| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-devices-system-cpu | 279 Description: Autonomous selection enable 281 Read/write interface to control autonomous selection enable 282 Read returns autonomous selection status: 283 0: autonomous selection is disabled 284 1: autonomous selection is enabled 286 Write 'y' or '1' or 'on' to enable autonomous selection. 287 Write 'n' or '0' or 'off' to disable autonomous selection. 294 Description: Autonomous activity window 297 the platform's autonomous selection policy. 299 Read/write an integer represents autonomous activity window (in [all …]
|
| H A D | sysfs-bus-iio-dac | 7 autonomous toggling, the way it should be done is: 38 autonomous toggling, the way it should be done is:
|
| /linux/Documentation/power/ |
| H A D | pm_qos_interface.rst | 194 autonomous mode if available. If that value is PM_QOS_LATENCY_ANY, in turn, and 199 be done in the autonomous latency tolerance control mode. 206 allows the hardware to be switched to the autonomous mode if there are no other
|
| /linux/include/linux/mfd/ |
| H A D | db8500-prcmu.h | 403 /* Defs related to autonomous power management */ 455 * Definitions for autonomous power management configuration. 473 * struct prcmu_auto_pm_config - Autonomous power management configuration. 474 * @sia_auto_pm_enable: SIA autonomous pm enable. (PRCMU_AUTO_PM_{OFF,ON}) 477 * @sva_auto_pm_enable: SVA autonomous pm enable. (PRCMU_AUTO_PM_{OFF,ON})
|
| /linux/net/dccp/ |
| H A D | ccid.h | |
| /linux/Documentation/devicetree/bindings/sound/ |
| H A D | ti,ts3a227e.yaml | 8 Autonomous Audio Accessory Detection and Configuration Switch
|
| /linux/drivers/usb/phy/ |
| H A D | phy-generic.c | 4 * into USB IP or which are mostly autonomous. 11 * autonomous such as isp1504, isp1707, etc.
|
| H A D | Kconfig | 46 built-in with usb ip or which are autonomous and doesn't require any
|
| /linux/drivers/acpi/ |
| H A D | cppc_acpi.c | 1619 * cppc_get_auto_act_window() - Read autonomous activity window register. 1623 * According to ACPI 6.5, s8.4.6.1.6, the value read from the autonomous 1649 * cppc_set_auto_act_window() - Write autonomous activity window register. 1651 * @auto_act_window: usec value to write to the autonomous activity window register. 1653 * According to ACPI 6.5, s8.4.6.1.6, the value to write to the autonomous 1688 * cppc_get_auto_sel() - Read autonomous selection register. 1711 * cppc_set_auto_sel - Write autonomous selection register. 1713 * @enable : the desired value of autonomous selection resiter to be updated.
|
| /linux/Documentation/devicetree/bindings/power/supply/ |
| H A D | qcom,pm8916-lbc.yaml | 14 such as pm8916. Implements a simple, autonomous CC/CV charger.
|
| /linux/Documentation/hwmon/ |
| H A D | ltc4282.rst | 36 flexibility in the autonomous generation of alerts and response to faults.
|
| H A D | asc7621.rst | 118 - Programmable autonomous fan control based on temperature readings
|
| /linux/drivers/platform/x86/ |
| H A D | meegopad_anx7428.c | 16 * IOW the ANX7428 operates fully autonomous and to the x5-Z8350 SoC
|
| /linux/arch/sparc/kernel/ |
| H A D | pci_impl.h | 24 * Furthermore, each PCI bus module controls its own autonomous
|
| /linux/drivers/net/wireless/ath/ath12k/ |
| H A D | hw.c | 242 /* CE6: Reserved for target autonomous hif_memcpy */ 262 /* CE8: Reserved for target autonomous hif_memcpy */ 369 /* CE6: Reserved for target autonomous hif_memcpy */ 652 /* Reserved for target autonomous HIF_memcpy */
|
| /linux/tools/power/x86/x86_energy_perf_policy/ |
| H A D | x86_energy_perf_policy.8 | 149 corresponds to 'full autonomous' HWP control.
|
| /linux/Documentation/admin-guide/pm/ |
| H A D | amd-pstate.rst | 333 ``amd_pstate`` CPPC has 3 operation modes: autonomous (active) mode, 334 non-autonomous (passive) mode and guided autonomous (guided) mode. 337 - In autonomous mode, platform ignores the desired performance level request 340 - In non-autonomous mode, platform gets desired performance level 342 - In guided-autonomous mode, platform sets operating performance level
|
| /linux/Documentation/devicetree/bindings/pci/ |
| H A D | snps,dw-pcie.yaml | 194 Link Autonomous Bandwidth Status flag has been set in the Link
|
| /linux/drivers/pci/controller/dwc/ |
| H A D | pcie-uniphier.c | 241 dev_dbg(pci->dev, "Link Autonomous Bandwidth Event\n"); in uniphier_pcie_irq_handler()
|
| /linux/include/uapi/linux/ |
| H A D | pci_regs.h | 568 #define PCI_EXP_LNKCTL_HAWD 0x0200 /* Hardware Autonomous Width Disable */ 570 #define PCI_EXP_LNKCTL_LABIE 0x0800 /* Link Autonomous Bandwidth Interrupt Enable */ 589 #define PCI_EXP_LNKSTA_LABS 0x8000 /* Link Autonomous Bandwidth Status */ 706 #define PCI_EXP_LNKCTL2_HASD 0x0020 /* HW Autonomous Speed Disable */
|
| /linux/drivers/net/wireless/ath/ath10k/ |
| H A D | pci.c | 176 /* CE6: target autonomous hif_memcpy */ 201 /* CE9 target autonomous qcache memcpy */ 209 /* CE10: target autonomous hif memcpy */ 217 /* CE11: target autonomous hif memcpy */ 290 /* CE6: Reserved for target autonomous hif_memcpy */ 320 /* CE9 target autonomous qcache memcpy */
|
| /linux/arch/x86/platform/intel/ |
| H A D | iosf_mbi.c | 308 * autonomous P-Unit tasks from accessing the PMIC I2C bus while we hold it.
|
| /linux/drivers/net/wireless/ath/ath11k/ |
| H A D | hw.c | 1351 /* CE6: Reserved for target autonomous hif_memcpy */ 1684 /* CE6: Reserved for target autonomous hif_memcpy */ 1863 /* CE6: Reserved for target autonomous hif_memcpy */ 2135 /* CE6: Reserved for target autonomous hif_memcpy */
|
| /linux/drivers/mfd/ |
| H A D | db8500-prcmu.c | 390 * @auto_pm_lock: The autonomous power management configuration lock. 391 * @auto_pm_enabled: A flag indicating whether autonomous PM is enabled. 1132 * prcmu_configure_auto_pm - Configure autonomous power management. 1162 * The autonomous power management configuration is done through in prcmu_configure_auto_pm()
|
| /linux/net/dsa/ |
| H A D | tag_8021q.c | 274 * autonomous forwarding path, and accomplishes tag_8021q's primary goal of
|