| /freebsd/sys/contrib/device-tree/Bindings/crypto/ |
| H A D | fsl-sec6.txt | 1 SEC 6 is as Freescale's Cryptographic Accelerator and Assurance Module (CAAM).
2 Currently Freescale powerpc chip C29X is embedded with SEC 6.
3 SEC 6 device tree binding include:
4 -SEC 6 Node
9 SEC 6 Node
13 Node defines the base address of the SEC 6 block.
15 configuration registers for the SEC 6 block.
16 For example, In C293, we could see three SEC 6 node.
48 address and length of the SEC 6 configuration registers.
62 crypto@a0000 {
[all …]
|
| /freebsd/contrib/wpa/src/wps/ |
| H A D | wps_module_tests.c | 44 { "104a0000", -1, 0 },
190 { "106a0000", -1, 0 },
250 { "1049001600372a0001ff0100020101030101040101ff00fe0101", 0, 6 },
252 { "1049000500372a0000", -1, 0 },
312 case 6: in wps_attr_parse_tests()
|
| /freebsd/sys/contrib/device-tree/src/arm/marvell/ |
| H A D | kirkwood-linksys-viper.dts | 109 partition@a0000 {
119 partition@4a0000 {
226 /* eth1 is connected to the switch at port 6. However DSA only supports a
|
| H A D | armada-370-netgear-rn102.dts | 44 sata@a0000 {
144 gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
261 reg = <0x0200000 0x600000>; /* 6MB */
|
| /freebsd/sys/contrib/device-tree/Bindings/pci/ |
| H A D | nvidia,tegra194-pcie-ep.yaml | 92 - const: p2u-6
139 6 : C6
219 pcie-ep@141a0000 {
260 "p2u-5", "p2u-6", "p2u-7";
276 pcie-ep@141a0000 {
317 "p2u-5", "p2u-6", "p2u-7";
|
| /freebsd/sys/contrib/device-tree/Bindings/dma/ |
| H A D | marvell,xor-v2.yaml | 54 xor0@6a0000 {
|
| /freebsd/sys/contrib/device-tree/src/arm/ti/omap/ |
| H A D | omap3-cm-t3x.dtsi | 287 gpmc,we-on-ns = <6>;
290 gpmc,oe-on-ns = <6>;
293 gpmc,page-burst-access-ns = <6>;
317 partition@2a0000 {
321 partition@6a0000 {
|
| /freebsd/sys/contrib/device-tree/src/c6x/ |
| H A D | tms320c6457.dtsi | 50 ti,dscr-mac-fuse-regs = <0x114 3 4 5 6
61 clock-controller@29a0000 {
|
| H A D | tms320c6678.dtsi | 41 cpu@6 {
43 reg = <6>;
91 timer10: timer@22A0000 {
143 0x114 5 6 0 0>;
|
| H A D | tms320c6474.dtsi | 78 ti,dscr-mac-fuse-regs = <0x34 3 4 5 6
82 clock-controller@29a0000 {
|
| H A D | tms320c6472.dtsi | 105 clock-controller@29a0000 {
121 0x704 5 6 0 0>;
|
| /freebsd/sys/contrib/device-tree/src/arm/samsung/ |
| H A D | exynos4.dtsi | 309 keypad: keypad@100a0000 {
544 i2c_4: i2c@138a0000 {
616 dmas = <&pdma0 7>, <&pdma0 6>;
632 dmas = <&pdma1 7>, <&pdma1 6>;
781 ppmu_dmc0: ppmu@106a0000 {
805 ppmu_rightbus: ppmu@112a0000 {
813 ppmu_leftbus: ppmu@116a0000 {
898 interrupts = <5 6>;
964 interrupts = <4 6>;
|
| H A D | exynos3250.dtsi | 764 i2c_4: i2c@138a0000 {
820 dmas = <&pdma0 7>, <&pdma0 6>;
837 dmas = <&pdma1 7>, <&pdma1 6>;
875 ppmu_dmc0: ppmu@106a0000 {
893 ppmu_rightbus: ppmu@112a0000 {
901 ppmu_leftbus: ppmu@116a0000 {
|
| /freebsd/sys/contrib/device-tree/src/arm64/nvidia/ |
| H A D | tegra234-p3737-0000+p3701-0000.dts | 95 pwm@32a0000 {
357 pcie@141a0000 {
368 "p2u-5", "p2u-6", "p2u-7";
371 pcie-ep@141a0000 {
386 "p2u-5", "p2u-6", "p2u-7";
|
| /freebsd/sys/contrib/device-tree/Bindings/pinctrl/ |
| H A D | sprd,sc9860-pinctrl.txt | 14 - drive-strength: Drive strength in mA. Supported values: 2, 4, 6, 8, 10,
40 pin_controller: pinctrl@402a0000 {
|
| /freebsd/sys/contrib/device-tree/src/powerpc/ |
| H A D | sbc8548.dts | 42 partition@7a0000 {
84 alt-flash@6,0 {
|
| H A D | sbc8548-altflash.dts | 87 alt-flash@6,0 {
99 partition@7a0000 {
|
| /freebsd/sys/contrib/device-tree/src/arm64/arm/ |
| H A D | vexpress-v2m-rs1.dtsi | 85 led-6 {
93 gpios = <&v2m_led_gpios 6 0>;
117 <0 6 &gic GIC_SPI 6 IRQ_TYPE_LEVEL_HIGH>,
307 v2m_serial1: serial@a0000 {
310 interrupts = <6>;
393 compact-flash@1a0000 {
|
| H A D | foundation-v8.dtsi | 145 <0 0 6 &gic 0 GIC_SPI 6 IRQ_TYPE_LEVEL_HIGH>,
208 v2m_serial1: serial@a0000 {
211 interrupts = <6>;
|
| /freebsd/sys/contrib/device-tree/src/arm/arm/ |
| H A D | vexpress-v2m-rs1.dtsi | 85 led-6 {
93 gpios = <&v2m_led_gpios 6 0>;
117 <0 6 &gic GIC_SPI 6 IRQ_TYPE_LEVEL_HIGH>,
307 v2m_serial1: serial@a0000 {
310 interrupts = <6>;
393 compact-flash@1a0000 {
|
| /freebsd/sys/contrib/device-tree/src/arm/microchip/ |
| H A D | at91-wb50n.dtsi | 16 bootargs = "ubi.mtd=6 root=ubi0:rootfs rootfstype=ubifs rw";
146 ubootenv@a0000 {
176 user@6ae0000 {
|
| H A D | at91-wb45n.dtsi | 16 bootargs = "ubi.mtd=6 root=ubi0:rootfs rootfstype=ubifs rw";
79 ubootenv@a0000 {
|
| /freebsd/sys/contrib/device-tree/src/powerpc/fsl/ |
| H A D | ppa8548.dts | 71 partition@7A0000 {
87 rtc@6f {
|
| /freebsd/sys/contrib/device-tree/src/arm64/marvell/ |
| H A D | ac5-98dx25xx.dtsi | 268 usb1: usb@a0000 {
301 spi0: spi@805a0000 {
339 interrupts = <GIC_PPI 6 IRQ_TYPE_LEVEL_HIGH>;
|
| /freebsd/sys/contrib/device-tree/src/arm64/freescale/ |
| H A D | imx93.dtsi | 160 interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(6) | IRQ_TYPE_LEVEL_LOW)>,
161 <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(6) | IRQ_TYPE_LEVEL_LOW)>,
162 <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(6) | IRQ_TYPE_LEVEL_LOW)>,
163 <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(6) | IRQ_TYPE_LEVEL_LOW)>;
268 <GIC_SPI 101 IRQ_TYPE_LEVEL_HIGH>, // 6: I3C1 From Bus
445 flexcan1: can@443a0000 {
690 wdog4: watchdog@424a0000 {
842 lpuart6: serial@425a0000 {
942 lpuart8: serial@426a0000 {
1137 eqos: ethernet@428a0000 {
[all …]
|