Home
last modified time | relevance | path

Searched +full:5 +full:a000000 (Results 1 – 25 of 27) sorted by relevance

12

/linux/arch/arm/boot/dts/st/
H A Dstm32mp135.dtsi11 dcmipp: dcmipp@5a000000 {
23 ltdc: display-controller@5a001000 {
H A Dstm32mp157.dtsi20 dsi: dsi@5a000000 {
/linux/Documentation/devicetree/bindings/dma/
H A Dsocionext,uniphier-mio-dmac.yaml55 dmac: dma-controller@5a000000 {
/linux/Documentation/devicetree/bindings/display/
H A Dst,stm32-dsi.yaml91 dsi: dsi@5a000000 {
/linux/Documentation/devicetree/bindings/mmc/
H A Dcdns,sdhci.yaml38 # sampling clock. The delay starts from 5ns (for delay parameter equal to 0)
148 emmc: mmc@5a000000 {
/linux/arch/arm/boot/dts/arm/
H A Dintegrator.dtsi42 interrupts = <5>;
111 syscon@1a000000 {
H A Darm-realview-pb1176.dts119 ethernet@3a000000 {
234 led@8,5 {
239 label = "versatile:5";
/linux/arch/arm64/boot/dts/freescale/
H A Dimx8-ss-dma.dtsi18 dma_subsys: bus@5a000000 {
24 lpspi0: spi@5a000000 {
42 lpspi1: spi@5a010000 {
60 lpspi2: spi@5a020000 {
73 dmas = <&edma2 5 0 0>, <&edma2 4 0 FSL_EDMA_RX>;
78 lpspi3: spi@5a030000 {
96 lpuart0: serial@5a060000 {
110 lpuart1: serial@5a070000 {
124 lpuart2: serial@5a080000 {
138 lpuart3: serial@5a090000 {
[all …]
/linux/Documentation/devicetree/bindings/net/
H A Dqca,ar71xx.yaml88 eth1: ethernet@1a000000 {
91 interrupts = <5>;
/linux/arch/powerpc/boot/dts/fsl/
H A Dp2020ds.dtsi99 kernel@1a000000 {
123 nand@5,0 {
155 interrupts = <5 1 0 0>;
159 interrupts = <5 1 0 0>;
186 fsl,tclk-period = <5>;
239 // IDSEL 0x11 func 5 - PCI slot 1
H A Dmpc8572ds.dtsi112 partition@1a000000 {
134 nand@5,0 {
196 fsl,tclk-period = <5>;
279 /* IDSEL 0x11 func 5 - PCI slot 1 */
327 /* IDSEL 0x12 func 5 - PCI slot 2 */
/linux/arch/mips/boot/dts/loongson/
H A Dloongson64-2k1000.dtsi115 pci@1a000000 {
313 interrupts = <5 IRQ_TYPE_LEVEL_HIGH>;
316 interrupt-map = <0 0 0 0 &liointc1 5 IRQ_TYPE_LEVEL_HIGH>;
/linux/arch/riscv/boot/dts/starfive/
H A Djh7100-common.dtsi55 linux,dma@107a000000 {
208 <GPIOMUX(5,
323 pmic@5e {
/linux/arch/arm/boot/dts/socionext/
H A Duniphier-ld4.dtsi162 clocks = <&peri_clk 5>;
163 resets = <&peri_rst 5>;
242 dmac: dma-controller@5a000000 {
257 sd: mmc@5a400000 {
277 emmc: mmc@5a500000 {
295 usb0: usb@5a800100 {
309 usb1: usb@5a810100 {
323 usb2: usb@5a820100 {
337 syscon@5f800000 {
347 syscon@5f900000 {
H A Duniphier-sld8.dtsi166 clocks = <&peri_clk 5>;
167 resets = <&peri_rst 5>;
246 dmac: dma-controller@5a000000 {
261 sd: mmc@5a400000 {
282 emmc: mmc@5a500000 {
300 usb0: usb@5a800100 {
314 usb1: usb@5a810100 {
328 usb2: usb@5a820100 {
342 syscon@5f800000 {
352 syscon@5f900000 {
H A Duniphier-pro4.dtsi144 socionext,interrupt-ranges = <0 48 16>, <16 154 5>;
170 clocks = <&peri_clk 5>;
171 resets = <&peri_rst 5>;
276 dmac: dma-controller@5a000000 {
292 sd: mmc@5a400000 {
313 emmc: mmc@5a500000 {
324 dmas = <&dmac 5>;
331 sd1: mmc@5a600000 {
340 resets = <&mio_rst 2>, <&mio_rst 5>;
347 usb2: usb@5a800100 {
[all …]
H A Duniphier-pxs2.dtsi259 socionext,interrupt-ranges = <0 48 16>, <16 154 5>,
307 comp_spdif_port0: port@5 {
341 clocks = <&peri_clk 5>;
342 resets = <&peri_rst 5>;
457 emmc: mmc@5a000000 {
473 sd: mmc@5a400000 {
492 soc_glue: syscon@5f800000 {
502 syscon@5f900000 {
521 xdmac: dma-controller@5fc10000 {
529 aidet: interrupt-controller@5fc20000 {
/linux/arch/arm/boot/dts/gemini/
H A Dgemini-dlink-dir-685.dts64 sck-gpios = <&gpio1 5 GPIO_ACTIVE_HIGH>;
175 sda-gpios = <&gpio0 5 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
236 rtl8366rb_cpu_port: ethernet-port@5 {
237 reg = <5>;
351 * gpio0bgrp cover line 5, 6 used by TK I2C
373 * gpio1bgrp cover line 5,8,7 used by panel SPI
474 display-controller@6a000000 {
H A Dgemini.dtsi401 interrupts = <5 IRQ_TYPE_EDGE_RISING>;
428 display-controller@6a000000 {
/linux/arch/arm64/boot/dts/marvell/mmp/
H A Dpxa1908-samsung-coreprimevelte.dts58 cm3@a000000 {
71 max-reason = <5>;
/linux/arch/arm64/boot/dts/socionext/
H A Duniphier-ld11.dtsi228 socionext,interrupt-ranges = <0 48 16>, <16 154 5>,
275 spdif_port0: port@5 {
352 clocks = <&peri_clk 5>;
353 resets = <&peri_rst 5>;
449 emmc: mmc@5a000000 {
468 usb0: usb@5a800100 {
484 usb1: usb@5a810100 {
500 usb2: usb@5a820100 {
516 syscon@5b3e0000 {
533 soc_glue: syscon@5f800000 {
[all …]
/linux/arch/arm/boot/dts/ti/omap/
H A Domap4.dtsi131 l4_cfg: interconnect@4a000000 {
728 iva_hd_target: target-module@5a000000 {
H A Dam4372.dtsi181 l4_fast: interconnect@4a000000 {
226 ti,tptcs = <&edma_tptc0 7>, <&edma_tptc1 5>,
384 <&edma 5 0>;
496 ti,irqs-reserved = /bits/ 8 <0x20>; /* BIT(5) */
583 ti,irqs-reserved = /bits/ 8 <0x20>; /* BIT(5) */
/linux/arch/loongarch/boot/dts/
H A Dloongson-2k1000.dtsi53 i2c-gpio,delay-us = <5>; /* ~100 kHz */
64 i2c-gpio,delay-us = <5>; /* ~100 kHz */
400 interrupts = <5 IRQ_TYPE_LEVEL_HIGH>;
427 pcie@1a000000 {
558 interrupt-map = <0x0 0x0 0x0 0x0 &liointc1 5 IRQ_TYPE_LEVEL_HIGH>;
/linux/tools/testing/selftests/tc-testing/tc-tests/actions/
H A Dpedit.json23 …r [0-9]+: pedit action pass keys 1.*index 1 ref.*key #0 at ipv4\\+8: val 0a000000 mask 00ffffff",
51 … [0-9]+: pedit action pass keys 1.*index 90 ref.*key #0 at ipv4\\+8: val 0a000000 mask 00ffffff",
170 "id": "5c7e",
773 "cmdUnderTest": "$TC actions add action pedit ex munge eth src set %e:11:m2:33:x4:-5",
801 "cmdUnderTest": "$TC actions add action pedit ex munge eth dst set %e:11:m2:33:x4:-5",

12