| /linux/arch/arm/boot/dts/st/ |
| H A D | stm32mp135.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause) 11 dcmipp: dcmipp@5a000000 {
|
| H A D | stm32mp157.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause) 20 dsi: dsi@5a000000 {
|
| /linux/arch/mips/boot/dts/loongson/ |
| H A D | rs780e-pch.dtsi | 12 pci@1a000000 { 15 #address-cells = <3>;
|
| H A D | loongson64v_4core_virtio.dts | 26 liointc: interrupt-controller@3ff01400 { 34 interrupts = <2>, <3>; 68 pci@1a000000 { 71 #address-cells = <3>;
|
| H A D | loongson64-2k1000.dtsi | 90 interrupts = <3>; 115 pci@1a000000 { 118 #address-cells = <3>; 127 gmac@3,0 { 150 gmac@3,1 { 214 #address-cells = <3>; 233 #address-cells = <3>; 252 #address-cells = <3>; 271 #address-cells = <3>; 275 interrupts = <3 IRQ_TYPE_LEVEL_HIGH>; [all …]
|
| /linux/Documentation/devicetree/bindings/net/ |
| H A D | intel,dwmac-plat.yaml | 106 gmac0: ethernet@3a000000 {
|
| H A D | qca,ar71xx.yaml | 88 eth1: ethernet@1a000000 { 148 switch_port3: port@3 { 182 phy_port3: ethernet-phy@3 {
|
| /linux/arch/arm/boot/dts/arm/ |
| H A D | integrator.dtsi | 103 interrupts = <3>; 111 syscon@1a000000 { 144 led@4,3 {
|
| /linux/arch/powerpc/boot/dts/fsl/ |
| H A D | mpc8536ds.dtsi | 55 partition@3e00000 { 106 partition@1a000000 { 122 board-control@3,0 { 178 flash@3 { 180 reg = <3>;
|
| H A D | p2020ds.dtsi | 54 dink@3e00000 { 99 kernel@1a000000 { 113 board-control@3,0 { 142 interrupts = <3 1 0 0>; 146 interrupts = <3 1 0 0>; 150 interrupts = <3 1 0 0>; 231 // IDSEL 0x11 func 3 - PCI slot 1 266 #address-cells = <3>; 301 interrupts = <1 3 12 3>;
|
| H A D | p2041rdb.dts | 173 phy_sgmii_3: ethernet-phy@3 { 225 compatible = "ethernet-phy-ieee802.3-c45"; 277 partition@1a000000 {
|
| H A D | p3041ds.dts | 203 compatible = "ethernet-phy-ieee802.3-c45"; 208 compatible = "ethernet-phy-ieee802.3-c45"; 230 3 0 0xf 0xffdf0000 0x00008000>; 261 partition@1a000000 { 277 board-control@3,0 { 281 reg = <3 0 0x30>; 282 ranges = <0 3 0 0x30>;
|
| H A D | p5020ds.dts | 203 compatible = "ethernet-phy-ieee802.3-c45"; 208 compatible = "ethernet-phy-ieee802.3-c45"; 230 3 0 0xf 0xffdf0000 0x00008000>; 261 partition@1a000000 { 277 board-control@3,0 { 281 reg = <3 0 0x30>; 282 ranges = <0 3 0 0x30>;
|
| H A D | p5040ds.dts | 238 3 0 0xf 0xffdf0000 0x00008000>; 268 partition@1a000000 { 284 board-control@3,0 { 288 reg = <3 0 0x40>; 289 ranges = <0 3 0 0x40>; 421 compatible = "ethernet-phy-ieee802.3-c45"; 432 compatible = "ethernet-phy-ieee802.3-c45";
|
| H A D | mpc8572ds.dtsi | 55 partition@3e00000 { 112 partition@1a000000 { 167 phy3: ethernet-phy@3 { 184 sgmii_phy3: sgmii-phy@3 { 267 /* IDSEL 0x11 func 3 - PCI slot 1 */ 315 /* IDSEL 0x12 func 3 - PCI slot 2 */ 367 #address-cells = <3>; 402 interrupts = <1 3 12 3>;
|
| /linux/arch/arm64/boot/dts/freescale/ |
| H A D | imx8-ss-dma.dtsi | 18 dma_subsys: bus@5a000000 { 24 lpspi0: spi@5a000000 { 55 dmas = <&edma2 3 0 0>, <&edma2 2 0 FSL_EDMA_RX>; 161 #pwm-cells = <3>; 168 #dma-cells = <3>; 460 #dma-cells = <3>;
|
| /linux/Documentation/devicetree/bindings/net/wireless/ |
| H A D | qcom,ath10k.yaml | 49 maxItems: 3 53 maxItems: 3 338 wifi@a000000 {
|
| /linux/Documentation/devicetree/bindings/pci/ |
| H A D | mediatek-pcie.txt | 14 - #address-cells: Address representation for root ports (must be 3) 65 - #address-cells: Must be 3 76 hifsys: syscon@1a000000 { 93 #address-cells = <3>; 119 #address-cells = <3>; 129 #address-cells = <3>; 139 #address-cells = <3>; 156 #address-cells = <3>; 173 <0 0 0 3 &pcie_intc1 2>, 174 <0 0 0 4 &pcie_intc1 3>; [all …]
|
| /linux/arch/arm/boot/dts/socionext/ |
| H A D | uniphier-ld4.dtsi | 121 clocks = <&peri_clk 3>; 122 resets = <&peri_rst 3>; 242 dmac: dma-controller@5a000000 { 267 resets = <&mio_rst 0>, <&mio_rst 3>; 386 #interrupt-cells = <3>; 424 clocks = <&sys_clk 2>, <&sys_clk 3>, <&sys_clk 3>;
|
| H A D | uniphier-sld8.dtsi | 121 clocks = <&peri_clk 3>; 122 resets = <&peri_rst 3>; 246 dmac: dma-controller@5a000000 { 271 resets = <&mio_rst 0>, <&mio_rst 3>; 391 #interrupt-cells = <3>; 429 clocks = <&sys_clk 2>, <&sys_clk 3>, <&sys_clk 3>;
|
| /linux/arch/arm/boot/dts/ti/omap/ |
| H A D | omap4.dtsi | 73 #interrupt-cells = <3>; 90 interrupts = <GIC_PPI 13 (GIC_CPU_MASK_RAW(3) | IRQ_TYPE_EDGE_RISING)>; 97 #interrupt-cells = <3>; 131 l4_cfg: interconnect@4a000000 { 513 * "10.1.3 DSS Register Manual" for omap4460. 728 iva_hd_target: target-module@5a000000 {
|
| /linux/arch/arm/boot/dts/gemini/ |
| H A D | gemini-dlink-dir-685.dts | 226 ethernet-port@3 { 227 reg = <3>; 270 phy3: ethernet-phy@3 { 271 reg = <3>; 273 interrupts = <3>; 474 display-controller@6a000000 {
|
| H A D | gemini.dtsi | 160 interrupts = <3 IRQ_TYPE_LEVEL_HIGH>; 183 <16 IRQ_TYPE_EDGE_FALLING>; /* Timer 3 */ 288 #address-cells = <3>; 297 <0x4800 0 0 3 &pci_intc 2>, 298 <0x4800 0 0 4 &pci_intc 3>, 301 <0x5000 0 0 3 &pci_intc 3>, 304 <0x5800 0 0 2 &pci_intc 3>, 305 <0x5800 0 0 3 &pci_intc 0>, 307 <0x6000 0 0 1 &pci_intc 3>, /* Slot 12 */ 309 <0x6000 0 0 3 &pci_intc 1>, [all …]
|
| /linux/arch/arm64/boot/dts/marvell/mmp/ |
| H A D | pxa1908-samsung-coreprimevelte.dts | 58 cm3@a000000 { 79 i2c-gpio,delay-us = <3>;
|
| /linux/arch/loongarch/boot/dts/ |
| H A D | loongson-2k2000.dtsi | 145 interrupts = <3>; 174 #pwm-cells = <3>; 184 #pwm-cells = <3>; 194 #pwm-cells = <3>; 204 #pwm-cells = <3>; 214 #pwm-cells = <3>; 224 #pwm-cells = <3>; 280 pcie@1a000000 { 284 #address-cells = <3>; 292 gmac0: ethernet@3,0 { [all …]
|