Searched +full:0 +full:x00000000 +full:- +full:0 +full:x03ffffff (Results 1 – 15 of 15) sorted by relevance
| /linux/arch/sh/include/mach-common/mach/ |
| H A D | sh7785lcr.h | 1 /* SPDX-License-Identifier: GPL-2.0 */ 7 * It can be changed with DIP switch(S2-5). 9 * phys address | S2-5 = OFF | S2-5 = ON 10 * -----------------------------+---------------+--------------- 11 * 0x00000000 - 0x03ffffff(CS0) | NOR Flash | NOR Flash 12 * 0x04000000 - 0x05ffffff(CS1) | PLD | PLD 13 * 0x06000000 - 0x07ffffff(CS1) | I2C | I2C 14 * 0x08000000 - 0x0bffffff(CS2) | USB | DDR SDRAM 15 * 0x0c000000 - 0x0fffffff(CS3) | SD | DDR SDRAM 16 * 0x10000000 - 0x13ffffff(CS4) | SM107 | SM107 [all …]
|
| /linux/arch/arm/boot/dts/gemini/ |
| H A D | gemini.dtsi | 1 // SPDX-License-Identifier: GPL-2.0 6 #include <dt-bindings/interrupt-controller/irq.h> 7 #include <dt-bindings/clock/cortina,gemini-clock.h> 8 #include <dt-bindings/reset/cortina,gemini-reset.h> 9 #include <dt-bindings/gpio/gpio.h> 13 #address-cells = <1>; 14 #size-cells = <1>; 16 compatible = "simple-bus"; 17 interrupt-parent = <&intcon>; 20 compatible = "cortina,gemini-flash", "cfi-flash"; [all …]
|
| /linux/arch/parisc/kernel/ |
| H A D | perf_images.h | 1 /* SPDX-License-Identifier: GPL-2.0-or-later */ 3 * Imagine for use with the Onyx (PCX-U) CPU interface 5 * Copyright (C) 2001 Randolph Chung <tausq at parisc-linux.org> 6 * Copyright (C) 2001 Hewlett-Packard (Grant Grundler) 27 0x4c00c000, 0x00000000, 0x00060000, 0x00000000, 28 0xe0e0e0e0, 0x004e0004, 0x07ffffff, 0xffc01380, 29 0x0101ffff, 0xfffff104, 0xe000c07f, 0xfffffffc, 30 0x01380010, 0x1fffffff, 0xff000000, 0x00000000, 31 0x00000fff, 0xff00000f, 0xffff0000, 0x0fffff00, 32 0x000fffff, 0x00000000, 0x00000000, 0x00ffffff, [all …]
|
| /linux/drivers/firewire/ |
| H A D | device-attribute-test.c | 1 // SPDX-License-Identifier: GPL-2.0-only 3 // device-attribute-test.c - An application of Kunit to test implementation for device attributes. 7 // This file can not be built independently since it is intentionally included in core-device.c. 17 0x0404eabf, 18 0x31333934, 19 0xe0646102, 20 0xffffffff, 21 0xffffffff, 22 0x00063287, // root directory. 23 0x03ffffff, [all …]
|
| /linux/arch/arm/boot/dts/ti/omap/ |
| H A D | am335x-nano.dts | 1 // SPDX-License-Identifier: GPL-2.0-only 3 * Copyright (C) 2013 Newflow Ltd - https://www.newflow.co.uk/ 5 /dts-v1/; 14 cpu@0 { 15 cpu0-supply = <&dcdc2_reg>; 21 reg = <0x80000000 0x10000000>; /* 256 MB */ 25 compatible = "gpio-leds"; 29 gpios = <&gpio1 5 0>; 30 default-state = "off"; 36 pinctrl-names = "default"; [all …]
|
| /linux/arch/sh/boards/mach-migor/ |
| H A D | setup.c | 1 // SPDX-License-Identifier: GPL-2.0 3 * Renesas System Solutions Asia Pte. Ltd - Migo-R 8 #include <linux/dma-map-ops.h> 30 #include <media/drv-intf/renesas-ceu.h> 41 * 0x00000000 64MB 16 NOR Flash (SP29PL256N) 42 * 0x0c000000 64MB 64 SDRAM (2xK4M563233G) 43 * 0x10000000 IRQ0 16 Ethernet (SMC91C111) 44 * 0x14000000 IRQ4 16 USB 2.0 Host Controller (M66596) 45 * 0x18000000 8GB 8 NAND Flash (K9K8G08U0A) 56 [0] = { [all …]
|
| /linux/lib/crypto/powerpc/ |
| H A D | poly1305-p10le_64.S | 1 /* SPDX-License-Identifier: GPL-2.0-or-later */ 5 # Copyright 2023- IBM Corp. All rights reserved 10 # Poly1305 - this version mainly using vector/VSX/Scalar 11 # - 26 bits limbs 12 # - Handle multiple 64 byte blcok. 16 # clamp r &= 0x0FFFFFFC0FFFFFFC 0x0FFFFFFC0FFFFFFF 17 # p = 2^130 - 5 25 # 07/22/21 - this revison based on the above sum of products. Setup r^4, r^3, r^2, r and s3, s2, … 56 #include <asm/asm-offsets.h> 57 #include <asm/asm-compat.h> [all …]
|
| /linux/drivers/rapidio/devices/ |
| H A D | tsi721.h | 1 /* SPDX-License-Identifier: GPL-2.0-or-later */ 3 * Tsi721 PCIExpress-to-SRIO bridge definitions 13 DBG_NONE = 0, 14 DBG_INIT = BIT(0), /* driver init */ 26 DBG_ALL = ~0, 36 } while (0) 53 #define DEFAULT_HOPCOUNT 0xff 54 #define DEFAULT_DESTID 0xff 57 #define PCI_DEVICE_ID_TSI721 0x80ab 59 #define BAR_0 0 [all …]
|
| /linux/arch/sh/boards/mach-kfr2r09/ |
| H A D | setup.c | 1 // SPDX-License-Identifier: GPL-2.0 35 #include <linux/dma-map-ops.h> 39 #include <media/drv-intf/renesas-ceu.h> 49 #define DRVCRB 0xA405018C 55 .offset = 0, 57 .mask_flags = MTD_WRITEABLE, /* Read-only */ 73 [0] = { 75 .start = 0x00000000, 76 .end = 0x03ffffff, 82 .name = "physmap-flash", [all …]
|
| /linux/drivers/net/ethernet/amd/ |
| H A D | lance.c | 3 Written/copyright 1993-1998 by Donald Becker. 11 with most other LANCE-based bus-master (NE2100/NE2500) ethercards. 19 - alignment problem with 1.3.* kernel and some minor changes. 21 - added support for Linux/Alpha, but removed most of it, because 23 - added hook for the 32bit lance driver 24 - added PCnetPCI II (79C970A) to chip table 26 - hopefully fix above so Linux/Alpha can use ISA cards too. 27 8/20/96 Fixed 7990 autoIRQ failure and reversed unneeded alignment -djb 28 v1.12 10/27/97 Module support -djb 29 v1.14 2/3/98 Module support modified, made PCI support optional -djb [all …]
|
| /linux/drivers/gpu/drm/radeon/ |
| H A D | evergreen.c | 50 #define DC_HPDx_CONTROL(x) (DC_HPD1_CONTROL + (x * 0xc)) 51 #define DC_HPDx_INT_CONTROL(x) (DC_HPD1_INT_CONTROL + (x * 0xc)) 52 #define DC_HPDx_INT_STATUS_REG(x) (DC_HPD1_INT_STATUS + (x * 0xc)) 62 spin_lock_irqsave(&rdev->cg_idx_lock, flags); in eg_cg_rreg() 63 WREG32(EVERGREEN_CG_IND_ADDR, ((reg) & 0xffff)); in eg_cg_rreg() 65 spin_unlock_irqrestore(&rdev->cg_idx_lock, flags); in eg_cg_rreg() 73 spin_lock_irqsave(&rdev->cg_idx_lock, flags); in eg_cg_wreg() 74 WREG32(EVERGREEN_CG_IND_ADDR, ((reg) & 0xffff)); in eg_cg_wreg() 76 spin_unlock_irqrestore(&rdev->cg_idx_lock, flags); in eg_cg_wreg() 84 spin_lock_irqsave(&rdev->pif_idx_lock, flags); in eg_pif_phy0_rreg() [all …]
|
| H A D | r600d.h | 30 #define CP_PACKET2 0x80000000 31 #define PACKET2_PAD_SHIFT 0 32 #define PACKET2_PAD_MASK (0x3fffffff << 0) 41 #define R6XX_MAX_BACKENDS_MASK 0xff 43 #define R6XX_MAX_SIMDS_MASK 0xff 45 #define R6XX_MAX_PIPES_MASK 0xff 48 #define ARRAY_LINEAR_GENERAL 0x00000000 49 #define ARRAY_LINEAR_ALIGNED 0x00000001 50 #define ARRAY_1D_TILED_THIN1 0x00000002 51 #define ARRAY_2D_TILED_THIN1 0x00000004 [all …]
|
| /linux/fs/unicode/ |
| H A D | mkutf8data.c | 16 * Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA 30 /* Default names of the in- and output files. */ 50 int verbose = 0; 63 #define ARRAY_SIZE(x) (sizeof(x) / sizeof((x)[0])) 65 /* ------------------------------------------------------------------ */ 80 #define UNICODE_MAJ_MAX ((unsigned short)-1) 81 #define UNICODE_MIN_MAX ((unsigned char)-1) 82 #define UNICODE_REV_MAX ((unsigned char)-1) 98 return 0; in age_valid() 100 return 0; in age_valid() [all …]
|
| /linux/arch/sh/boards/mach-ecovec24/ |
| H A D | setup.c | 1 // SPDX-License-Identifier: GPL-2.0 39 #include <linux/dma-map-ops.h> 41 #include <media/drv-intf/renesas-ceu.h> 52 *----------------------------------------- 53 * 0x0000_0000 uboot 16bit 54 * 0x0004_0000 Linux romImage 16bit 55 * 0x0014_0000 MTD for Linux 16bit 56 * 0x0400_0000 Internal I/O 16/32bit 57 * 0x0800_0000 DRAM 32bit 58 * 0x1800_0000 MFI 16bit [all …]
|
| /linux/arch/arm/boot/dts/microchip/ |
| H A D | sam9x60.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 3 * sam9x60.dtsi - Device Tree Include file for Microchip SAM9X60 SoC 10 #include <dt-bindings/dma/at91.h> 11 #include <dt-bindings/pinctrl/at91.h> 12 #include <dt-bindings/interrupt-controller/irq.h> 13 #include <dt-bindings/gpio/gpio.h> 14 #include <dt-bindings/clock/at91.h> 15 #include <dt-bindings/mfd/at91-usart.h> 16 #include <dt-bindings/mfd/atmel-flexcom.h> 19 #address-cells = <1>; [all …]
|