/linux/Documentation/userspace-api/media/cec/ |
H A D | cec-ioc-adap-g-phys-addr.rst | 66 has address 0.0.0.0. Every device that is hooked up to an input of the 67 TV has address a.0.0.0 (where 'a' is ≥ 1), devices hooked up to those in
|
/linux/Documentation/devicetree/bindings/power/ |
H A D | rockchip-io-domain.yaml | 18 If the regulator hooked up to a pin like SDMMC0_VDD is 3.3V then 19 bit 7 of GRF_IO_VSEL needs to be 0. If the regulator hooked up to 24 hooked up to the pins.
|
/linux/drivers/input/misc/ |
H A D | stpmic1_onkey.c | 17 * @irq_falling: irq that we are hooked on to 18 * @irq_rising: irq that we are hooked on to
|
/linux/sound/hda/ |
H A D | Makefile | 6 # otherwise the codec drivers won't be hooked before the PCI probe
|
/linux/Documentation/devicetree/bindings/display/ |
H A D | dp-aux-bus.yaml | 14 are hooked up to them. This is the DP AUX bus. Over the DP AUX bus
|
/linux/Documentation/devicetree/bindings/display/panel/ |
H A D | panel-edp.yaml | 108 needed if HPD hooked up, either through a GPIO in the panel node or 109 hooked up directly to the eDP controller.
|
/linux/Documentation/devicetree/bindings/interrupt-controller/ |
H A D | fsl,ls-msi.yaml | 11 is hooked to a parent interrupt controller: e.g: ARM GIC for ARM-based
|
/linux/drivers/media/pci/zoran/ |
H A D | videocodec.c | 190 zrdev_dbg(zr, "videocodec: hooked in as first element\n"); in videocodec_register() 195 zrdev_dbg(zr, "videocodec: hooked in after '%s'\n", in videocodec_register()
|
/linux/arch/arm/boot/dts/rockchip/ |
H A D | rk3288-veyron-sdmmc.dtsi | 40 * Builtin CD line is hooked to ground to prevent JTAG at boot
|
/linux/include/drm/display/ |
H A D | drm_dp_aux_bus.h | 21 * be hooked up there.
|
/linux/net/ipv4/netfilter/ |
H A D | iptable_raw.c | 3 * 'raw' table, which is the very first hooked in at PRE_ROUTING and LOCAL_OUT .
|
/linux/arch/arc/mm/ |
H A D | highmem.c | 35 * - Both fixmap/pkmap use a dedicated page table each, hooked up to swapper PGD
|
/linux/Documentation/sound/soc/ |
H A D | jack.rst | 69 These are all hooked together by the machine driver depending on the
|
/linux/tools/tracing/rtla/src/ |
H A D | timerlat_aa.c | 260 * hooked to the osnoise:nmi_noise event. 297 * hooked to the osnoise:irq_noise event. 397 * hooked to the osnoise:softirq_noise event. 430 * hooked to the osnoise:thread_noise event.
|
/linux/arch/arm/boot/dts/allwinner/ |
H A D | sun6i-a31-colombus.dts | 64 /* The lcd panel i2c interface is hooked up via gpios */
|
H A D | sun5i-a13-utoo-p66.dts | 62 /* The lcd panel i2c interface is hooked up via gpios */
|
/linux/arch/arm64/boot/dts/qcom/ |
H A D | sc7280-herobrine-zombie.dtsi | 90 * - If a pin is not hooked up on Qcard, it gets no name.
|
H A D | sc7280-herobrine-villager.dtsi | 104 * - If a pin is not hooked up on Qcard, it gets no name.
|
H A D | sc7280-herobrine-evoker.dtsi | 114 * - If a pin is not hooked up on Qcard, it gets no name.
|
H A D | sc7280-herobrine-herobrine-r1.dts | 147 * - If a pin is not hooked up on Qcard, it gets no name.
|
/linux/arch/arc/include/asm/ |
H A D | smp.h | 39 * Takes @cpu and @hwirq to which the arch-common ISR is hooked up
|
/linux/drivers/usb/phy/ |
H A D | Kconfig | 72 are hooked to this driver through platform_data structure.
|
/linux/arch/arc/kernel/ |
H A D | intc-compact.c | 59 * To reduce platform code, we assume all IRQs directly hooked-up into intc.
|
/linux/drivers/gpu/drm/msm/hdmi/ |
H A D | hdmi.h | 67 /* the encoder we are hooked to (outside of hdmi block) */
|
/linux/Documentation/hid/ |
H A D | hid-transport.rst | 180 - RESET: Used by I2C-HID, not hooked up in HID core. 181 - SET_POWER: Used by I2C-HID, not hooked up in HID core.
|