Home
last modified time | relevance | path

Searched full:bd71837 (Results 1 – 12 of 12) sorted by relevance

/linux/Documentation/devicetree/bindings/regulator/
H A Drohm,bd71837-regulator.yaml4 $id: http://devicetree.org/schemas/regulator/rohm,bd71837-regulator.yaml#
7 title: ROHM BD71837 Power Management Integrated Circuit regulators
13 List of regulators provided by this controller. BD71837 regulators node
14 should be sub node of the BD71837 MFD node. See BD71837 MFD bindings at
15 Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml
20 Note that if BD71837 starts at RUN state you probably want to use
26 # The valid names for BD71837 regulator nodes are:
83 # BD71837:
96 # BD71837 power outputs can either be controlled by the PMIC internal
111 # amongst users of BD71837. (This allows for example scaling down the
H A Drohm,bd71847-regulator.yaml106 # amongst users of BD71837. (This allows for example scaling down the
/linux/include/linux/mfd/
H A Drohm-bd718x7.h39 /* BD71837 specific voltage configurations */
51 /* Registers specific to BD71837 */
60 /* Registers common for BD71837 and BD71847 */
121 /* BD71837 BUCK ramp rate CTRL reg bits */
178 /* BD71837 specific voltage monitoring masks */
/linux/drivers/mfd/
H A Drohm-bd718x7.c39 { .name = "bd71837-clk", },
40 { .name = "bd71837-pmic", },
191 .compatible = "rohm,bd71837",
229 MODULE_DESCRIPTION("ROHM BD71837/BD71847 Power Management IC driver");
/linux/drivers/clk/
H A Dclk-bd718x7.c20 /* BD71837 and BD71847 */
24 * BD71837, BD71847, and BD71828 all use bit [0] to clk output control
145 { "bd71837-clk", ROHM_CHIP_TYPE_BD71837 },
H A DKconfig478 This driver supports ROHM BD71837, BD71847, BD71850, BD71815
/linux/drivers/regulator/
H A Dbd718x7-regulator.c3 // bd71837-regulator.c ROHM BD71837MWV/BD71847MWV regulator driver
100 * them we just return a constant. BD71837 BUCK3 and BUCK4 are exceptions as
263 * BD71837 BUCK1/2/3/4
273 * BD71837 BUCK5
333 * BD71837 BUCK7
392 * LDO5 for BD71837
400 * LDO5 for BD71837
443 * BD71837/47/50 ... (ICs supported by this driver) do not provide in bd718x7_xvp_sanity_check()
610 * OPS for BD71837
645 * BD71837 bucks 3 and 4 support defining their enable/disable state also
[all …]
/linux/arch/arm64/boot/dts/freescale/
H A Dimx8mq-pico-pi.dts67 compatible = "rohm,bd71837";
H A Dimx8mq-phanbell.dts121 compatible = "rohm,bd71837";
H A Dimx8mm-ucm-som.dtsi134 compatible = "rohm,bd71837";
H A Dimx8mq-librem5-devkit.dts289 compatible = "rohm,bd71837";
H A Dimx8mq-librem5.dtsi828 compatible = "rohm,bd71837";