Home
last modified time | relevance | path

Searched +full:1200 +full:khz (Results 1 – 20 of 20) sorted by relevance

/freebsd/sys/dev/videomode/
H A Dmodelines18 # 640x350 @ 85Hz (VESA) hsync: 37.9kHz
21 # 640x400 @ 85Hz (VESA) hsync: 37.9kHz
24 # 720x400 @ 70Hz (EDID established timing) hsync: 31.47kHz
27 # 720x400 @ 85Hz (VESA) hsync: 37.9kHz
30 # 720x400 @ 88Hz (EDID established timing) hsync: 39.44kHz
33 # 640x480 @ 60Hz (Industry standard) hsync: 31.5kHz
36 # 640x480 @ 72Hz (VESA) hsync: 37.9kHz
39 # 640x480 @ 75Hz (VESA) hsync: 37.5kHz
42 # 640x480 @ 85Hz (VESA) hsync: 43.3kHz
45 # 800x600 @ 56Hz (VESA) hsync: 35.2kHz
[all …]
/freebsd/sys/contrib/device-tree/Bindings/regulator/
H A Drichtek,rt6245-regulator.yaml63 Buck switch frequency selection. Each respective value means 400KHz,
64 800KHz, 1200KHz. If this property is missing then keep in chip default.
/freebsd/sys/contrib/device-tree/src/arm64/rockchip/
H A Drk3399-nanopc-t4.dts59 * With 20KHz PWM and an EVERCOOL EC4007H12SA fan, these levels
60 * work out to 0, ~1200, ~3000, and 5000RPM respectively.
/freebsd/sys/contrib/device-tree/Bindings/leds/backlight/
H A Dqcom-wled.yaml84 kHz; switching frequency.
86 enum: [ 600, 640, 685, 738, 800, 872, 960, 1066, 1200, 1371, 1600, 1920,
/freebsd/sys/arm/freescale/imx/
H A Dimx6_anatop.c131 {1200, 1275},
139 static uint32_t imx6_ocotp_mhz_tab[] = {792, 852, 996, 1200};
199 * going from 400->1200, but works for smaller changes). in vdd_set()
607 * Set the sensor to sample automatically at 16Hz (32.768KHz/0x800), set in initialize_tempmon()
/freebsd/contrib/ntp/html/drivers/
H A Ddriver36.html20 Autotune Port: <tt>/dev/icom</tt>; 1200/9600 baud, 8-bits, no parity<br>
24 <p>The driver requires an audio codec or sound card with sampling rate 8 kHz and &mu;-law compandin…
30 …kHz &mu;-law companded codec samples using maximum-likelihood techniques which exploit the conside…
34 <p>The 1000/1200-Hz pulses and 100-Hz subcarrier are first separated using a 600-Hz bandpass filter…
H A Ddriver7.html21 Autotune Port: <tt>/dev/icom</tt>; 1200/9600 baud, 8-bits, no parity<br>
31 …he data. If compiled for the audio codec, it requires a sampling rate of 8 kHz and &mu;-law compan…
37 <p>The driver processes 8-kHz &mu;-law companded codec samples using maximum-likelihood techniques …
54 …>/dev/icom</tt> and, if successful will tune the radio to 3.331 MHz. The 1-kHz offset is useful wi…
/freebsd/contrib/ntp/ntpd/
H A Drefclock_chu.c36 * Ottawa, Ontario. Transmissions are made continuously on 3330 kHz,
37 * 7850 kHz and 14670 kHz in upper sideband, compatible AM mode. An
44 * kHz and mu-law companding. This is the same standard as used by the
169 * ident identifier (CHU0 3330 kHz, CHU1 7850 kHz, CHU2 14670 kHz)
197 * 9600 bps if the high order 0x80 bit of the mode is zero and 1200 bps
437 * Note the tuned frequencies are 1 kHz higher than the carrier. CHU
1540 * The radio can be tuned to three channels: 0 (3330 kHz), 1 in chu_newchan()
1541 * (7850 kHz) and 2 (14670 kHz). There are five one-minute in chu_newchan()
H A Drefclock_wwv.c43 * kHz and mu-law companding. This is the same standard as used by the
207 #define IN1200 ((1200 * 80) / WWV_SEC) /* 1200 Hz increment */
477 * used for the second and minute sync pulses, 1000 Hz for WWV and 1200
715 * to select the line speed 0 (9600 bps) or 1 (1200 bps). Note in wwv_start()
914 * signal and 1200 Hz for the WWVH sync signal. These drive synchronous
917 * at 1200 Hz). Two additional matched filters are switched in
919 * WWVH second sync signal (6 cycles at 1200 Hz).
933 static double bpf[9]; /* 1000/1200-Hz bpf delay line */ in wwv_rf()
935 static double mf[41]; /* 1000/1200 in wwv_rf()
[all...]
H A Drefclock_irig.c37 * kHz and mu-law companding. This is the same standard as used by the
523 * IRIG-B filter. Matlab 4th-order IIR elliptic, 800-1200 Hz in irig_rf()
/freebsd/contrib/ntp/html/
H A Daudio.html54 … For instance, on the east coast the best compromise CHU frequency is 7335 kHz and the best WWV fr…
56 …s not set, the rate is 9600 bps for the newer radios; if set, the rate is 1200 bps for the older r…
/freebsd/sys/contrib/device-tree/src/arm/ti/omap/
H A Domap5.dtsi53 /* kHz uV */
72 /* kHz uV */
768 prm_iva: prm@1200 {
/freebsd/sys/contrib/device-tree/Bindings/thermal/
H A Dthermal.txt213 /* kHz uV */
536 coefficients = <1200 -345 890>;
/freebsd/share/misc/
H A Dusb_vendors248 0317 LaserJet 1200
256 0417 LaserJet 1200 series
476 2f11 PSC 1200
783 1000 Mustek BearPaw 1200 Scanner
962 f9d9 Wetterempfanger 147.3kHz
2201 201d ColorPage-Vivid 1200 X
2202 201e ColorPage-Slim 1200
2203 201f ColorPage-Vivid 1200 XE
2204 2020 ColorPage-Slim 1200 USB2
2626 0361 Colorado 1200u Scanner
[all …]
H A Dpci_vendors720 1000 100d Nytro NWD-BFH6-1200
4108 7919 RS690 HDMI Audio [Radeon Xpress 1200 Series]
4114 791f RS690M [Radeon Xpress 1200/1250/1270]
4123 793f RS690M [Radeon Xpress 1200/1250/1270] (Secondary)
4750 1200 GD 7542 [Nordic]
5018 1200 Family 10h Processor HyperTransport Configuration
5990 102b 1200 MGA-1084SG Mystique
5996 102b 1200 MGA-2164W Millennium II
8907 1093 7aef PXIe-4190 (500 kHz)
9090 bd11 1200 PCTV pro (TV + FM stereo receiver)
[all …]
/freebsd/sys/contrib/device-tree/src/arm/nvidia/
H A Dtegra30-lg-x3.dtsi1461 /* PMIC has a built-in 32KHz oscillator which is used by PMC */
1549 /delete-node/ opp-625000000-1200;
1551 /delete-node/ opp-667000000-1200;
H A Dtegra30-pegatron-chagall.dts2599 /* PMIC has a built-in 32KHz oscillator which is used by PMC */
2722 /delete-node/ opp-625000000-1200;
2724 /delete-node/ opp-667000000-1200;
/freebsd/crypto/heimdal/lib/wind/
H A Dnormalize_table.c2157 {0x3391, 3, 3601}, /* SQUARE KHZ */
18701 1200,
H A DUnicodeData.txt3323 1200;ETHIOPIC SYLLABLE HA;Lo;0;L;;;;;N;;;;;
9216 3391;SQUARE KHZ;So;0;L;<square> 006B 0048 007A;;;;N;SQUARED KHZ;;;;
/freebsd/sys/dev/qlnx/qlnxe/
H A Dreg_addr.h1060 …of the non-deemphasized voltage level at the transmitter pins: 0x0 = 800-1200 mV for full swing 4…
38003 … [31:30] Vco_range Set VCO frequency range 00 = 800 - 2000 MHz 01 = 500 - 1200 MHz 10 = 1600 - 400…
38006 … [31:30] Vco_range Set VCO frequency range 00 = 800 - 2000 MHz 01 = 500 - 1200 MHz 10 = 1600 - 400…
38036 … [31:30] Vco_range Set VCO frequency range 00 = 800 - 2000 MHz 01 = 500 - 1200 MHz 10 = 1600 - 400…
38038 … [31:30] Vco_range Set VCO frequency range 00 = 800 - 2000 MHz 01 = 500 - 1200 MHz 10 = 1600 - 400…
38454 …is lowers the overall power consumption. 1: Select 1Mhz Clock 0: Select 500Khz Clock Global Regist…
72325 … When this bit is set the SMBUS block operates in 400KHz mode. When cleared SMBUS operates in 100K…
75439 …EG_CMSG_QUE_SIZE_E5 1200