Lines Matching +full:zynq +full:- +full:gpio

1 # SPDX-License-Identifier: GPL-2.0-only
12 	  via GPIOs or SoC-internal reset controller modules.
90 	tristate "GPIO reset controller"
94 	  GPIOs.  Typically for OF platforms this driver expects "reset-gpios"
97 	  If compiled as module, it will be called reset-gpio.
146 	  Support for the Canaan Kendryte K210 RISC-V SoC reset controller.
155 	  Support for the Canaan Kendryte K230 RISC-V SoC reset controller.
231 	  Raspberry Pi 4's co-processor controls some of the board's HW
234 	  interfacing with RPi4's co-processor and model these firmware
272 	   - Altera SoCFPGAs
273 	   - ASPEED BMC SoCs
274 	   - Bitmain BM1880 SoC
275 	   - Realtek SoCs
276 	   - RCC reset controller in STM32 MCUs
277 	   - Allwinner SoCs
278 	   - SiFive FU740 SoCs
279 	   - Sophgo SoCs
315 	tristate "T-HEAD TH1520 reset controller"
319 	  This driver provides support for the T-HEAD TH1520 SoC reset controller,
321 	  Enable this option if you need to control hardware resets on TH1520-based
325 	tristate "TI System Control Interface (TI-SCI) reset driver"
338 	  memory-mapped reset registers as part of a syscon device node. If
339 	  you wish to use the reset framework for such memory-mapped devices,
356 	  It provides reset signals for Armada 7040 and 385 SoC-s, Alleycat 3X
357 	  switch MAC-s, Alaska OOB ethernet PHY, Quad Alaska ethernet PHY-s and
361 	  called reset-tn48m.
384 	bool "ZYNQ Reset Driver" if COMPILE_TEST
387 	  This enables the reset controller driver for Xilinx Zynq SoCs.