Lines Matching +full:on +full:- +full:soc
1 # SPDX-License-Identifier: GPL-2.0-only
12 via GPIOs or SoC-internal reset controller modules.
20 depends on MFD_ALTERA_A10SR || COMPILE_TEST
23 peripheral PHYs on the Altera Arria10 System Resource Chip.
27 depends on ARCH_ASPEED || COMPILE_TEST
37 AR71xx SoC reset controller.
47 depends on BMIPS_GENERIC || COMPILE_TEST
54 depends on ARCH_BERLIN || COMPILE_TEST
61 depends on ARCH_BRCMSTB || ARCH_BCM2835 || COMPILE_TEST
69 depends on HAS_IOMEM
70 depends on ARCH_BRCMSTB || ARCH_BCM2835 || COMPILE_TEST
73 This enables the RESCAL reset controller for SATA, PCIe0, or PCIe1 on
78 depends on MACH_EYEQ5 || MACH_EYEQ6H || COMPILE_TEST
91 depends on GPIOLIB
94 GPIOs. Typically for OF platforms this driver expects "reset-gpios"
97 If compiled as module, it will be called reset-gpio.
101 depends on HAS_IOMEM
102 depends on ARC_SOC_HSDK || COMPILE_TEST
108 depends on IMX_SCU && HAVE_ARM_SMCCC
109 depends on (ARM64 && ARCH_MXC) || COMPILE_TEST
115 depends on HAS_IOMEM
116 depends on SOC_IMX7D || (ARM64 && ARCH_MXC) || COMPILE_TEST
124 depends on ARCH_MXC || COMPILE_TEST
132 depends on X86 || COMPILE_TEST
133 depends on OF && HAS_IOMEM
141 bool "Reset controller driver for Canaan Kendryte K210 SoC"
142 depends on (SOC_CANAAN_K210 || COMPILE_TEST) && OF
146 Support for the Canaan Kendryte K210 RISC-V SoC reset controller.
151 tristate "Reset controller driver for Canaan Kendryte K230 SoC"
152 depends on ARCH_CANAAN || COMPILE_TEST
153 depends on OF
155 Support for the Canaan Kendryte K230 RISC-V SoC reset controller.
173 depends on ARCH_SPARX5 || SOC_LAN966 || MCHP_LAN966X_PCI || COMPILE_TEST
177 This driver supports switch core reset for the Microchip Sparx5 SoC.
189 depends on ARCH_MA35 || COMPILE_TEST
192 This enables the reset controller driver for Nuvoton MA35D1 SoC.
196 depends on MIPS || COMPILE_TEST
201 bool "Microchip PolarFire SoC (MPFS) Reset Driver"
202 depends on MCHP_CLK_MPFS
206 This driver supports peripheral reset for the Microchip PolarFire SoC
210 depends on ARCH_QCOM || COMPILE_TEST
212 This enables the AOSS (always on subsystem) reset driver
219 depends on ARCH_QCOM || COMPILE_TEST
228 depends on RASPBERRYPI_FIRMWARE || (RASPBERRYPI_FIRMWARE=n && COMPILE_TEST)
231 Raspberry Pi 4's co-processor controls some of the board's HW
234 interfacing with RPi4's co-processor and model these firmware
239 depends on ARCH_RZG2L || COMPILE_TEST
241 Support for USBPHY Control found on RZ/G2L family. It mainly
246 depends on ARCH_RENESAS || COMPILE_TEST
248 Support for USB2PHY Port reset Control found on the RZ/V2H(P) SoC
253 depends on ARM_SCMI_PROTOCOL || COMPILE_TEST
265 depends on HAS_IOMEM
272 - Altera SoCFPGAs
273 - ASPEED BMC SoCs
274 - Bitmain BM1880 SoC
275 - Realtek SoCs
276 - RCC reset controller in STM32 MCUs
277 - Allwinner SoCs
278 - SiFive FU740 SoCs
279 - Sophgo SoCs
291 depends on ARCH_SPACEMIT || COMPILE_TEST
315 tristate "T-HEAD TH1520 reset controller"
316 depends on ARCH_THEAD || COMPILE_TEST
319 This driver provides support for the T-HEAD TH1520 SoC reset controller,
320 which manages hardware reset lines for SoC components such as the GPU.
321 Enable this option if you need to control hardware resets on TH1520-based
325 tristate "TI System Control Interface (TI-SCI) reset driver"
326 depends on TI_SCI_PROTOCOL || (COMPILE_TEST && TI_SCI_PROTOCOL=n)
329 available on some new TI's SoCs. If you wish to use reset resources
334 depends on HAS_IOMEM
338 memory-mapped reset registers as part of a syscon device node. If
339 you wish to use the reset framework for such memory-mapped devices,
352 depends on MFD_TN48M_CPLD || COMPILE_TEST
356 It provides reset signals for Armada 7040 and 385 SoC-s, Alleycat 3X
357 switch MAC-s, Alaska OOB ethernet PHY, Quad Alaska ethernet PHY-s and
361 called reset-tn48m.
365 depends on ARCH_UNIPHIER || COMPILE_TEST
366 depends on OF && MFD_SYSCON
369 Support for reset controllers on UniPhier SoCs.
375 depends on (ARCH_UNIPHIER || COMPILE_TEST) && OF
380 on UniPhier SoCs. Say Y if you want to control reset signals