Lines Matching +full:hardware +full:- +full:controlled

1 # SPDX-License-Identifier: GPL-2.0-only
12 	  via GPIOs or SoC-internal reset controller modules.
82 	  specific to ESWIN SoCs and should only be enabled if using such hardware.
93 	  such hardware.
116 	  GPIOs.  Typically for OF platforms this driver expects "reset-gpios"
119 	  If compiled as module, it will be called reset-gpio.
168 	  Support for the Canaan Kendryte K210 RISC-V SoC reset controller.
177 	  Support for the Canaan Kendryte K230 RISC-V SoC reset controller.
254 	  Raspberry Pi 4's co-processor controls some of the board's HW
257 	  interfacing with RPi4's co-processor and model these firmware
278 	tristate "Reset driver controlled via ARM SCMI interface"
283 	  controlled by firmware that implements the SCMI interface.
298 	   - Altera SoCFPGAs
299 	   - ASPEED BMC SoCs
300 	   - Bitmain BM1880 SoC
301 	   - Realtek SoCs
302 	   - RCC reset controller in STM32 MCUs
303 	   - Allwinner SoCs
304 	   - SiFive FU740 SoCs
305 	   - Sophgo SoCs
320 	  Support for block-level software reset lines in the Cix Sky1
322 	  outputs for audio peripherals are controlled through the CRU
359 	  Enable this option to be able to use hardware
363 	tristate "T-HEAD TH1520 reset controller"
367 	  This driver provides support for the T-HEAD TH1520 SoC reset controller,
368 	  which manages hardware reset lines for SoC components such as the GPU.
369 	  Enable this option if you need to control hardware resets on TH1520-based
373 	tristate "TI System Control Interface (TI-SCI) reset driver"
386 	  memory-mapped reset registers as part of a syscon device node. If
387 	  you wish to use the reset framework for such memory-mapped devices,
404 	  It provides reset signals for Armada 7040 and 385 SoC-s, Alleycat 3X
405 	  switch MAC-s, Alaska OOB ethernet PHY, Quad Alaska ethernet PHY-s and
409 	  called reset-tn48m.