1# SPDX-License-Identifier: GPL-2.0-only 2# 3# Solarflare device configuration 4# 5 6config NET_VENDOR_SOLARFLARE 7 bool "Solarflare devices" 8 default y 9 help 10 If you have a network (Ethernet) card belonging to this class, say Y. 11 12 Note that the answer to this question doesn't directly affect the 13 kernel: saying N will just cause the configurator to skip all 14 the questions about Solarflare devices. If you say Y, you will be asked 15 for your specific card in the following questions. 16 17if NET_VENDOR_SOLARFLARE 18 19config SFC 20 tristate "Solarflare SFC9100/EF100-family support" 21 depends on PCI 22 depends on PTP_1588_CLOCK_OPTIONAL 23 select MDIO 24 select CRC32 25 select NET_DEVLINK 26 help 27 This driver supports 10/40-gigabit Ethernet cards based on 28 the Solarflare SFC9100-family controllers. 29 30 It also supports 10/25/40/100-gigabit Ethernet cards based 31 on the Solarflare EF100 networking IP in Xilinx FPGAs. 32 33 To compile this driver as a module, choose M here. The module 34 will be called sfc. 35config SFC_MTD 36 bool "Solarflare SFC9100-family MTD support" 37 depends on SFC && MTD && !(SFC=y && MTD=m) 38 default y 39 help 40 This exposes the on-board flash and/or EEPROM as MTD devices 41 (e.g. /dev/mtd1). This is required to update the boot 42 configuration under Linux, or use some older userland tools to 43 update the firmware. 44config SFC_MCDI_MON 45 bool "Solarflare SFC9100-family hwmon support" 46 depends on SFC && HWMON && !(SFC=y && HWMON=m) 47 default y 48 help 49 This exposes the on-board firmware-managed sensors as a 50 hardware monitor device. 51config SFC_SRIOV 52 bool "Solarflare SFC9100-family SR-IOV support" 53 depends on SFC && PCI_IOV 54 depends on INET 55 default y 56 help 57 This enables support for the Single Root I/O Virtualization 58 features, allowing accelerated network performance in 59 virtualized environments. 60config SFC_MCDI_LOGGING 61 bool "Solarflare SFC9100-family MCDI logging support" 62 depends on SFC 63 default y 64 help 65 This enables support for tracing of MCDI (Management-Controller-to- 66 Driver-Interface) commands and responses, allowing debugging of 67 driver/firmware interaction. The tracing is actually enabled by 68 a sysfs file 'mcdi_logging' under the PCI device. 69config SFC_CXL 70 bool "Solarflare SFC9100-family CXL support" 71 depends on SFC && CXL_BUS >= SFC 72 default SFC 73 help 74 This enables SFC CXL support if the kernel is configuring CXL for 75 using CTPIO with CXL.mem. The SFC device with CXL support and 76 with a CXL-aware firmware can be used for minimizing latencies 77 when sending through CTPIO. 78 79source "drivers/net/ethernet/sfc/falcon/Kconfig" 80source "drivers/net/ethernet/sfc/siena/Kconfig" 81 82endif # NET_VENDOR_SOLARFLARE 83