1# 2# Memory devices 3# 4 5menuconfig MEMORY 6 bool "Memory Controller drivers" 7 8if MEMORY 9 10config ARM_PL172_MPMC 11 tristate "ARM PL172 MPMC driver" 12 depends on ARM_AMBA && OF 13 help 14 This selects the ARM PrimeCell PL172 MultiPort Memory Controller. 15 If you have an embedded system with an AMBA bus and a PL172 16 controller, say Y or M here. 17 18config ATMEL_SDRAMC 19 bool "Atmel (Multi-port DDR-)SDRAM Controller" 20 default y 21 depends on ARCH_AT91 && OF 22 help 23 This driver is for Atmel SDRAM Controller or Atmel Multi-port 24 DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs. 25 Starting with the at91sam9g45, this controller supports SDR, DDR and 26 LP-DDR memories. 27 28config ATMEL_EBI 29 bool "Atmel EBI driver" 30 default y 31 depends on ARCH_AT91 && OF 32 select MFD_SYSCON 33 select MFD_ATMEL_SMC 34 help 35 Driver for Atmel EBI controller. 36 Used to configure the EBI (external bus interface) when the device- 37 tree is used. This bus supports NANDs, external ethernet controller, 38 SRAMs, ATA devices, etc. 39 40config TI_AEMIF 41 tristate "Texas Instruments AEMIF driver" 42 depends on (ARCH_DAVINCI || ARCH_KEYSTONE) && OF 43 help 44 This driver is for the AEMIF module available in Texas Instruments 45 SoCs. AEMIF stands for Asynchronous External Memory Interface and 46 is intended to provide a glue-less interface to a variety of 47 asynchronuous memory devices like ASRAM, NOR and NAND memory. A total 48 of 256M bytes of any of these memories can be accessed at a given 49 time via four chip selects with 64M byte access per chip select. 50 51config TI_EMIF 52 tristate "Texas Instruments EMIF driver" 53 depends on ARCH_OMAP2PLUS 54 select DDR 55 help 56 This driver is for the EMIF module available in Texas Instruments 57 SoCs. EMIF is an SDRAM controller that, based on its revision, 58 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols. 59 This driver takes care of only LPDDR2 memories presently. The 60 functions of the driver includes re-configuring AC timing 61 parameters and other settings during frequency, voltage and 62 temperature changes 63 64config OMAP_GPMC 65 bool 66 select GPIOLIB 67 help 68 This driver is for the General Purpose Memory Controller (GPMC) 69 present on Texas Instruments SoCs (e.g. OMAP2+). GPMC allows 70 interfacing to a variety of asynchronous as well as synchronous 71 memory drives like NOR, NAND, OneNAND, SRAM. 72 73config OMAP_GPMC_DEBUG 74 bool "Enable GPMC debug output and skip reset of GPMC during init" 75 depends on OMAP_GPMC 76 help 77 Enables verbose debugging mostly to decode the bootloader provided 78 timings. To preserve the bootloader provided timings, the reset 79 of GPMC is skipped during init. Enable this during development to 80 configure devices connected to the GPMC bus. 81 82 NOTE: In addition to matching the register setup with the bootloader 83 you also need to match the GPMC FCLK frequency used by the 84 bootloader or else the GPMC timings won't be identical with the 85 bootloader timings. 86 87config MVEBU_DEVBUS 88 bool "Marvell EBU Device Bus Controller" 89 default y 90 depends on PLAT_ORION && OF 91 help 92 This driver is for the Device Bus controller available in some 93 Marvell EBU SoCs such as Discovery (mv78xx0), Orion (88f5xxx) and 94 Armada 370 and Armada XP. This controller allows to handle flash 95 devices such as NOR, NAND, SRAM, and FPGA. 96 97config TEGRA20_MC 98 bool "Tegra20 Memory Controller(MC) driver" 99 default y 100 depends on ARCH_TEGRA_2x_SOC 101 help 102 This driver is for the Memory Controller(MC) module available 103 in Tegra20 SoCs, mainly for a address translation fault 104 analysis, especially for IOMMU/GART(Graphics Address 105 Relocation Table) module. 106 107config FSL_CORENET_CF 108 tristate "Freescale CoreNet Error Reporting" 109 depends on FSL_SOC_BOOKE 110 help 111 Say Y for reporting of errors from the Freescale CoreNet 112 Coherency Fabric. Errors reported include accesses to 113 physical addresses that mapped by no local access window 114 (LAW) or an invalid LAW, as well as bad cache state that 115 represents a coherency violation. 116 117config FSL_IFC 118 bool 119 depends on FSL_SOC || ARCH_LAYERSCAPE 120 121config JZ4780_NEMC 122 bool "Ingenic JZ4780 SoC NEMC driver" 123 default y 124 depends on MACH_JZ4780 125 help 126 This driver is for the NAND/External Memory Controller (NEMC) in 127 the Ingenic JZ4780. This controller is used to handle external 128 memory devices such as NAND and SRAM. 129 130config MTK_SMI 131 bool 132 depends on ARCH_MEDIATEK || COMPILE_TEST 133 help 134 This driver is for the Memory Controller module in MediaTek SoCs, 135 mainly help enable/disable iommu and control the power domain and 136 clocks for each local arbiter. 137 138config DA8XX_DDRCTL 139 bool "Texas Instruments da8xx DDR2/mDDR driver" 140 depends on ARCH_DAVINCI_DA8XX 141 help 142 This driver is for the DDR2/mDDR Memory Controller present on 143 Texas Instruments da8xx SoCs. It's used to tweak various memory 144 controller configuration options. 145 146source "drivers/memory/samsung/Kconfig" 147source "drivers/memory/tegra/Kconfig" 148 149endif 150