| /linux/Documentation/arch/mips/ |
| H A D | ingenic-tcu.rst | 29 operate.
35 - On the oldest SoCs (up to JZ4740), all of the eight channels operate in
37 - On JZ4725B, channel 5 operates as TCU2, the others operate as TCU1.
38 - On newest SoCs (JZ4750 and above), channels 1-2 operate as TCU2, the
39 others operate as TCU1.
|
| /linux/drivers/firmware/arm_scmi/transports/ |
| H A D | Kconfig | 57 If you want the SCMI SMC based transport to operate in atomic
61 transport to optionally ask for atomic SCMI transactions and operate
114 If you want the SCMI VirtIO based transport to operate in atomic
119 transport to optionally ask for atomic SCMI transactions and operate
|
| /linux/Documentation/scsi/ |
| H A D | bnx2fc.rst | 13 depend on the state of the network interfaces to operate. As such, the network
28 2. Configure the interfaces on which bnx2fc driver has to operate on.
|
| /linux/Documentation/arch/sh/ |
| H A D | booting.rst | 9 inter-operate with old bootloaders must either use a builtin DTB or
|
| /linux/drivers/usb/dwc2/ |
| H A D | Kconfig | 35 driver to operate in Host-only mode.
45 driver to operate in Peripheral-only mode. This option requires
|
| /linux/Documentation/ABI/obsolete/ |
| H A D | automount-tracefs-debugfs | 14 To allow older tooling to continue to operate, when mounting
|
| /linux/drivers/pci/endpoint/ |
| H A D | Kconfig | 14 controller that can operate in endpoint mode.
|
| /linux/fs/sysfs/ |
| H A D | Kconfig | 16 Some system agents rely on the information in sysfs to operate.
|
| /linux/Documentation/devicetree/bindings/cpufreq/ |
| H A D | cpufreq-st.txt | 7 the DT and operate in the usual way.
|
| /linux/Documentation/i2c/busses/ |
| H A D | i2c-taos-evm.rst | 47 to operate at 1200 bps. However, I don't think this is a big concern in
|
| /linux/Documentation/power/ |
| H A D | opp.rst | 70 As the system proceeds to operate, SoC framework may choose to make certain
77 operational functions operate only on available opps:
152 /* dont operate on the pointer.. just do a sanity check.. */
347 for the OPP library to operate on. Pointer to this structure is
|
| /linux/drivers/net/wireless/ath/wil6210/ |
| H A D | Kconfig | 24 ISR registers on wil6210 chip may operate in either
|
| /linux/Documentation/w1/masters/ |
| H A D | w1-uart.rst | 19 In short, the UART peripheral must support full-duplex and operate in
|
| /linux/Documentation/hwmon/ |
| H A D | ads7828.rst | 56 It can operate in single ended mode (8 +ve inputs) or in differential mode,
|
| H A D | lochnagar.rst | 15 hardware modifications or external circuitry to operate.
|
| /linux/arch/m68k/ |
| H A D | Kconfig.bus | 54 operate ISA cards on Atari. Only 8 bit cards are supported, and
|
| /linux/Documentation/networking/ |
| H A D | batman-adv.rst | 8 operate on the IP basis. Unlike the batman daemon, which exchanges information
30 batman-adv can operate. The batman-adv mesh-interface can be created using the
|
| H A D | x25.rst | 29 option appeared, XOT. This allows X.25 Packet Layer frames to operate over
|
| /linux/Documentation/driver-api/media/drivers/ |
| H A D | pvrusb2.rst | 153 operate corresponding chips within the pvrusb2 device. It is
155 operate specific pieces (and those modules are in turn driven by
190 applications can open and operate the driver in the usual V4L
|
| /linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | pinctrl-vt8500.txt | 3 These SoCs contain a combined Pinmux/GPIO module. Each pin may operate as
|
| /linux/Documentation/PCI/endpoint/ |
| H A D | pci-test-function.rst | 12 to configure a PCI controller that can operate in EP mode to work as
|
| /linux/Documentation/netlabel/ |
| H A D | lsm_interface.rst | 36 exist to operate both on sockets as well as the sk_buffs directly. These high
|
| /linux/Documentation/devicetree/bindings/powerpc/fsl/ |
| H A D | mpc5121-psc.txt | 48 - clocks : specifies the clock needed to operate the fifo controller
|
| /linux/Documentation/crypto/ |
| H A D | devel-algos.rst | 54 The CIPHER type is used for transformations which operate on exactly one
105 which operate on scatterlists of data supplied to the transformation
|
| /linux/Documentation/leds/ |
| H A D | leds-qcom-lpg.rst | 19 The each PWM channel can operate with a period between 27us and 384 seconds and
|