| /linux/drivers/net/ethernet/wiznet/ |
| H A D | Kconfig | 28 the MAC and PHY functions only, onchip TCP/IP is unused.
41 the MAC and PHY functions only, onchip TCP/IP is unused.
|
| /linux/Documentation/devicetree/bindings/sound/ |
| H A D | renesas,idt821034.yaml | 13 The IDT821034 codec is a four channel PCM codec with onchip filters and
|
| /linux/Documentation/devicetree/bindings/interrupt-controller/ |
| H A D | brcm,bcm6345-l1-intc.yaml | 20 - Most onchip peripherals are wired directly to an L1 input
|
| H A D | brcm,bcm7038-l1-intc.yaml | 18 - Most onchip peripherals are wired directly to an L1 input
|
| /linux/drivers/net/ethernet/broadcom/ |
| H A D | b44.h | 60 #define MAC_CTRL_PHY_PDOWN 0x00000004 /* Onchip EPHY Powerdown */
61 #define MAC_CTRL_PHY_EDET 0x00000008 /* Onchip EPHY Energy Detected */
62 #define MAC_CTRL_PHY_LEDCTRL 0x000000e0 /* Onchip EPHY LED Control */
|
| /linux/drivers/char/hw_random/ |
| H A D | pasemi-rng.c | 7 * Driver for the PWRficient onchip rng
|
| /linux/drivers/net/ethernet/pasemi/ |
| H A D | pasemi_mac_ethtool.c | 5 * Ethtool hooks for the PA Semi PWRficient onchip 1G/10G Ethernet MACs
|
| H A D | pasemi_mac.h | 5 * Driver for the PA6T-1682M onchip 1G/10G Ethernet MACs, soft state and
|
| H A D | pasemi_mac.c | 5 * Driver for the PA Semi PWRficient onchip 1G/10G Ethernet MACs
|
| /linux/arch/mips/sgi-ip22/ |
| H A D | ip22-time.c | 78 * we are using the onchip r4k counter/compare register to serve this in plat_time_init()
|
| /linux/arch/mips/sni/ |
| H A D | time.c | 122 * we are using the onchip r4k counter/compare register to serve this in plat_time_init()
|
| /linux/drivers/mtd/nand/raw/ |
| H A D | pasemi_nand.c | 8 * Driver for the PWRficient onchip NAND flash interface
|
| /linux/arch/x86/include/asm/ |
| H A D | iosf_mbi.h | 3 * Intel OnChip System Fabric MailBox access support
|
| /linux/drivers/edac/ |
| H A D | pasemi_edac.c | 8 * Driver for the PWRficient onchip memory controllers
|
| /linux/drivers/net/can/ |
| H A D | Kconfig | 90 tristate "Atmel AT91 onchip CAN controller"
|
| /linux/arch/x86/pci/ |
| H A D | irq.c | 761 * the routing registers, particularly for the onchip devices
766 * bits [6:4] reserved (sometimes used for onchip devices)
788 * Onchip routing for router rev-id 0x01/0xb0 and probably 0x00/0xb1:
809 * Onchip routing for router rev-id 0x04 (try-and-error observation)
|
| /linux/arch/powerpc/include/asm/ |
| H A D | mpc52xx_psc.h | 4 * Definitions of consts/structs to drive the Freescale MPC52xx OnChip
|
| /linux/drivers/gpu/drm/mcde/ |
| H A D | mcde_drv.c | 310 * The vendor code uses ESRAM (onchip RAM) and need to activate in mcde_probe()
|
| /linux/drivers/usb/cdns3/ |
| H A D | cdns3-gadget.c | 2014 * cdns3_ep_onchip_buffer_reserve - Try to reserve onchip buf for EP
2042 * ALL OUT EPs are shared the same chunk onchip memory, so in cdns3_ep_onchip_buffer_reserve()
2173 /* onchip buffer is only allocated before configuration */ in cdns3_ep_config()
2178 dev_err(priv_dev->dev, "onchip mem is full, ep is invalid\n"); in cdns3_ep_config()
|
| /linux/drivers/scsi/esas2r/ |
| H A D | esas2r_init.c | 1475 * dump is located in the upper 512KB of the onchip SRAM. Make sure in esas2r_reset_chip()
|
| /linux/drivers/gpu/drm/msm/registers/adreno/ |
| H A D | adreno_pm4.xml | 1928 <!-- With REG_COMPARE instead of register read from ONCHIP memory -->
1961 <!-- Instead of register read from ONCHIP memory -->
|
| /linux/drivers/soc/ti/ |
| H A D | knav_qmss_queue.c | 1157 * queue_base specified => using internal or onchip in knav_get_link_ram()
|
| /linux/drivers/net/ethernet/broadcom/bnx2x/ |
| H A D | bnx2x_reg.h | 3764 /* [WB 53] Onchip address table */
3766 /* [WB 53] Onchip address table - B0 */
|
| /linux/drivers/infiniband/hw/qib/ |
| H A D | qib_iba7322.c | 603 #define TXDDS_TABLE_SZ 16 /* number of entries per speed in onchip table */
|