Searched full:deasserting (Results 1 – 25 of 33) sorted by relevance
12
94 /* Deasserting USB3 system reset */ in bcm_ns_usb3_phy_init_ns_bx()144 /* Deasserting USB3 system reset */ in bcm_ns_usb3_phy_init_ns_ax()
35 deasserting the device chip select (qspi_n_ss_out).
110 self-deasserting reset control.115 The reset controller API allows requesting self-deasserting reset controls as
45 * Doing this before deasserting the CPUs is needed to wake up CPUs in mvebu_cortex_a9_boot_secondary()
72 * deasserting the reset. Otherwise, the component may not be ready in bcm6345_reset_reset()
59 * The LPC18xx RGU has mostly self-deasserting resets except for the
120 * argument set to false for deasserting the reset.
12 * @reset: for self-deasserting resets, does all necessary
57 /* if the associated clock is gated, deasserting might otherwise hang forever */ in jh71x0_reset_update()
124 * deasserting the reset. Otherwise, the component may not be ready in bcm63268_timer_reset_reset()
133 * the clocks and deasserting reset, to avoid glitches. in hi6220_ao_deassert()
364 * T2.min before deasserting the reset pin. If it takes T1.min for the in ps8622_pre_enable()365 * power to rise, we need to wait at most T2.max before deasserting the in ps8622_pre_enable()
173 * Deasserting the core reset while the register reset is asserted in denali_dt_probe()
72 * 7AP. We do not assume writes to the LVT deasserting IRQs
67 * specifies to wait 150 ms after deasserting EL3_ON before in atana33xc20_suspend()
745 /* Give power supplies time to stabilize before deasserting reset. */ in st7703_prepare()
40 * or switching between two parents by asserting or deasserting the gpio.
219 * This is a self-deasserting reset controller.
400 * deasserting WUCLKIN and clearing the ST_IO_CHAIN WKST bit. No
302 * deasserting WUCLKIN and waiting for WUCLKOUT to be deasserted.
384 udelay(2000); /* Wait 2 ms after deasserting PCI reset */ in octeon_pci_initialize()
173 * This function asserts or rearms (for self-deasserting resets) all
700 * the PLL_1_C register and then deasserting in sja1105_cgu_rmii_pll_config()
594 * Add delay of 12 ms before deasserting the init in pm8916_wcd_analog_enable_adc()
1205 start and deasserting on end.