| /linux/drivers/gpu/drm/nouveau/nvkm/engine/disp/ |
| H A D | vga.c | 166 u32 tied = nvkm_rd32(device, 0x001084) & 0x10000000; in nvkm_rdvgaowner() local
167 if (tied == 0) { in nvkm_rdvgaowner()
|
| /linux/Documentation/spi/ |
| H A D | spi-lm70llp.rst | 66 collector is tied to VCC.
72 hand, the transistor is cut off and the voltage tied to its collector is
|
| /linux/Documentation/driver-api/nvdimm/ |
| H A D | security.rst | 93 An key with the current passphrase payload that is tied to the nvdimm should be
101 An key with the current passphrase payload that is tied to the nvdimm should be
115 An encrypted-key with the current user passphrase that is tied to the nvdimm
|
| /linux/security/landlock/ |
| H A D | Kconfig | 13 directory, etc.) tied to a file hierarchy. Such policy can be
|
| /linux/drivers/net/wireless/microchip/wilc1000/ |
| H A D | Kconfig | 37 immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | metafmt-intel-ipu3.rst | 51 Both 3A statistics and pipeline parameters described here are closely tied to
|
| /linux/arch/powerpc/boot/dts/ |
| H A D | xpedite5200.dts | 431 cle-line = <0x8>; /* CLE tied to A3 */
432 ale-line = <0x10>; /* ALE tied to A4 */
|
| H A D | xpedite5200_xmon.dts | 435 cle-line = <0x8>; /* CLE tied to A3 */
436 ale-line = <0x10>; /* ALE tied to A4 */
|
| H A D | ebony.dts | 316 /* Ebony has all 4 IRQ pins tied together per slot */
|
| H A D | bamboo.dts | 281 /* Bamboo has all 4 IRQ pins tied together per slot */
|
| /linux/Documentation/driver-api/cxl/platform/acpi/ |
| H A D | srat.rst | 69 performance numbers are tied to a CXL host bridge via the Device Handle.
|
| /linux/Documentation/driver-api/media/drivers/ |
| H A D | cx88-devel.rst | 66 GPIO 16(I believe) is tied to the IR port (if present).
|
| /linux/Documentation/devicetree/bindings/spi/ |
| H A D | spi-davinci.txt | 23 lines can be tied to the interrupt controller. Set this
|
| /linux/arch/arm64/boot/dts/marvell/ |
| H A D | cn9130-cf.dtsi | 106 * address pins tied low, which takes addresses 0x50 and 0x51.
|
| /linux/arch/arm/boot/dts/marvell/ |
| H A D | armada-388-clearfog.dtsi | 193 * address pins tied low, which takes addresses 0x50 and 0x51.
|
| /linux/Documentation/driver-api/cxl/linux/ |
| H A D | access-coordinates.rst | 26 memory region. The DSMAS subtable provides a DSMADHandle that is tied to a
28 performance coordinates that's tied to a DSMADhandle and this ties the two
|
| /linux/Documentation/fb/ |
| H A D | ep93xx-fb.rst | 123 the VIDSCRNPAGE (framebuffer physical offset) to be tied low. There is
|
| /linux/drivers/clk/samsung/ |
| H A D | Kconfig | 95 status of the certains clocks from SoC, but it could also be tied to
|
| /linux/arch/arm/boot/dts/allwinner/ |
| H A D | sun7i-a20-bananapi-m1-plus.dts | 262 /* VBUS on usb host ports are tied to DC5V and therefore always on */
|
| /linux/Documentation/driver-api/ |
| H A D | ioctl.rst | 238 is not tied to a physical device or constrained by the file system
248 that is not tied to a file descriptor.
|
| /linux/Documentation/networking/ |
| H A D | page_pool.rst | 143 pp_params.napi = napi; /* only if locking is tied to NAPI */
|
| /linux/Documentation/userspace-api/ |
| H A D | mseal.rst | 164 ksys_shmdt() in shm.c. The lifetimes of those mapping are not tied to
|
| /linux/Documentation/networking/devlink/ |
| H A D | devlink-dpipe.rst | 78 ASIC. Thus it is tied to the top of the ``devlink`` infrastructure.
|
| /linux/Documentation/dev-tools/kunit/ |
| H A D | style.rst | 155 Every test suite should be tied to a Kconfig entry.
|
| /linux/Documentation/gpu/amdgpu/display/ |
| H A D | mpo-overview.rst | 17 * Plane independent page flips - No need to be tied to global compositor
|