Home
last modified time | relevance | path

Searched refs:eth2 (Results 1 – 25 of 39) sorted by relevance

12

/linux/Documentation/networking/
H A Dmulti-pf-netdev.rst142 - /sys/class/net/eth2/queues/tx-0/xps_cpus:000001
143 - /sys/class/net/eth2/queues/tx-1/xps_cpus:001000
144 - /sys/class/net/eth2/queues/tx-2/xps_cpus:000002
145 - /sys/class/net/eth2/queues/tx-3/xps_cpus:002000
146 - /sys/class/net/eth2/queues/tx-4/xps_cpus:000004
147 - /sys/class/net/eth2/queues/tx-5/xps_cpus:004000
148 - /sys/class/net/eth2/queues/tx-6/xps_cpus:000008
149 - /sys/class/net/eth2/queues/tx-7/xps_cpus:008000
150 - /sys/class/net/eth2/queues/tx-8/xps_cpus:000010
151 - /sys/class/net/eth2/queues/tx-9/xps_cpus:010000
[all …]
H A Dvrf.rst39 | eth1 | | eth2 | ... | bond1 |
239 …4: eth2: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master red state UP mode DEFA…
249 eth2 UP 02:00:00:00:02:03 <BROADCAST,MULTICAST,UP,LOWER_UP>
265 10.2.2.254 dev eth2 lladdr 5e:54:01:6a:ee:80 REACHABLE
290 …4: eth2: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast master red state UP group def…
292 inet 10.2.2.2/24 brd 10.2.2.255 scope global eth2
305 eth2 UP 10.2.2.2/24 2002:2::2/120 fe80::ff:fe00:203/64
325 broadcast 10.2.2.0 dev eth2 proto kernel scope link src 10.2.2.2
326 10.2.2.0/24 dev eth2 proto kernel scope link src 10.2.2.2
327 local 10.2.2.2 dev eth2 proto kernel scope host src 10.2.2.2
[all …]
H A Dnf_flowtable.rst138 (represented as eth1 and eth2 in the example figure below) and the gateway
150 -> eth1 eth2
/linux/tools/testing/selftests/net/
H A Dnat6to4.bpf.c89 struct ethhdr eth2; // used iff is_ethernet in sched_cls_ingress6_nat_6_prog() local
91 eth2 = *eth; // Copy over the ethernet header (src/dst mac) in sched_cls_ingress6_nat_6_prog()
92 eth2.h_proto = bpf_htons(ETH_P_IP); // But replace the ethertype in sched_cls_ingress6_nat_6_prog()
142 *new_eth = eth2; in sched_cls_ingress6_nat_6_prog()
224 struct ethhdr eth2; // used iff is_ethernet in sched_cls_egress4_snat4_prog() local
226 eth2 = *eth; // Copy over the ethernet header (src/dst mac) in sched_cls_egress4_snat4_prog()
227 eth2.h_proto = bpf_htons(ETH_P_IPV6); // But replace the ethertype in sched_cls_egress4_snat4_prog()
279 *new_eth = eth2; in sched_cls_egress4_snat4_prog()
H A Dtraceroute.sh183 connect_ns $r1 eth2 - 2000:102::1/64 $r2 eth2 - 2000:102::2/64
260 $router eth2 1.0.2.1/24 -
H A Dicmp_redirect.sh200 ip -netns $h2 li set r2h2 netns $r2 name eth2 up
251 ip -netns $r2 addr add dev eth2 ${R2_N2_IP}/24
252 ip -netns $r2 -6 addr add dev eth2 ${R2_N2_IP6}/64 nodad
276 run_cmd ip -netns $r2 li set eth2 mtu ${mtu}
/linux/tools/testing/selftests/drivers/net/bonding/
H A Dbond_options.sh79 ip -n ${s_ns} link set eth2 type bond_slave prio 11
97 check_active_slave eth2
106 ip -n ${s_ns} link set eth2 up
143 ip -n ${s_ns} link set eth2 type bond_slave prio -50
148 ip -n ${s_ns} -d link show eth2 | grep -q 'prio -50'
/linux/tools/testing/selftests/net/netfilter/
H A Dconntrack_icmp_related.sh76 ip link add "$DEV" netns "$nsrouter1" type veth peer name eth2 netns "$nsrouter2"
85 ip -net "$nsrouter2" link set eth2 up
102 ip -net "$nsrouter2" addr add 192.168.3.10/24 dev eth2
104 ip -net "$nsrouter2" addr add dead:3::10/64 dev eth2 nodad
/linux/arch/arm/boot/dts/marvell/
H A Darmada-385-turris-omnia.dts29 ethernet2 = &eth2;
110 * eth2 node below.
197 &eth2 {
199 * eth2 is connected via a multiplexor to both the SFP cage and to
H A Darmada-385-linksys.dtsi111 &eth2 {
197 ethernet = <&eth2>;
H A Darmada-388-clearfog.dtsi16 ethernet3 = &eth2;
101 &eth2 {
H A Darmada-385-clearfog-gtr.dtsi30 20 - 1512 phy reset (eth2, optional)
75 ethernet3 = &eth2;
368 &eth2 {
H A Darmada-385-db-88f6820-amc.dts69 &eth2 {
/linux/arch/arm64/boot/dts/hisilicon/
H A Dhip06-d03.dts40 &eth2 {
H A Dhip07-d05.dts76 &eth2 {
/linux/arch/arm64/boot/dts/freescale/
H A Dimx8mm-kontron-bl-osm-s.dts51 reg_rst_eth2: regulator-rst-eth2 {
56 regulator-name = "rst-usb-eth2";
H A Dimx8mm-kontron-bl.dts70 reg_rst_eth2: regulator-rst-eth2 {
72 regulator-name = "rst-usb-eth2";
/linux/arch/arm/boot/dts/nxp/imx/
H A Dimx6dl-yapp43-common.dtsi14 ethernet2 = &eth2;
143 eth2: port@1 { label
145 label = "eth2";
H A Dimx6dl-yapp4-common.dtsi14 ethernet2 = &eth2;
141 eth2: port@2 { label
143 label = "eth2";
/linux/arch/powerpc/boot/dts/fsl/
H A Dp1020rdb-pc_camp_core0.dts8 * eth1, eth2, sdhc, crypto, global-util, message, pci0, pci1, msi.
H A Dmpc8572ds_camp_core1.dts7 * This dts allows core1 to have l2, dma2, eth2, eth3, pci2, msi.
/linux/arch/arm64/boot/dts/st/
H A Dstm32mp25-pinctrl.dtsi9 eth2_rgmii_pins_a: eth2-rgmii-0 {
48 eth2_rgmii_sleep_pins_a: eth2-rgmii-sleep-0 {
/linux/Documentation/devicetree/bindings/infiniband/
H A Dhisilicon-hns-roce.txt33 eth-handle = <&eth2 &eth3 &eth4 &eth5 &eth6 &eth7>;
/linux/Documentation/admin-guide/aoe/
H A Daoe.rst51 "echo eth2 eth4 > /dev/etherd/interfaces" tells the aoe driver to
52 limit ATA over Ethernet traffic to eth2 and eth4. AoE traffic from
/linux/arch/arm/boot/dts/st/
H A Dstm32mp13-pinctrl.dtsi158 eth2_rgmii_pins_a: eth2-rgmii-0 {
185 eth2_rgmii_sleep_pins_a: eth2-rgmii-sleep-0 {
211 eth2_rmii_pins_a: eth2-rmii-0 {
233 eth2_rmii_sleep_pins_a: eth2-rmii-sleep-0 {

12