| /linux/drivers/gpu/drm/amd/display/modules/inc/ |
| H A D | mod_info_packet.h | 68 struct frame_duration_op decrease; member
|
| /linux/arch/arm/boot/dts/intel/socfpga/ |
| H A D | socfpga_arria5_socdk.dts | 92 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| H A D | socfpga_arria10_socdk.dtsi | 131 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| /linux/drivers/ras/ |
| H A D | Kconfig | 22 a failed system increases, then availability will decrease.
|
| /linux/Documentation/leds/ |
| H A D | leds-mt6370-rgb.rst | 16 can increase or decrease the brightness of the RGB LED via an I2C interface.
|
| /linux/Documentation/hwmon/ |
| H A D | sht15.rst | 51 measurement and decrease power consumption, while losing on precision.
|
| H A D | w83793.rst | 91 if tempX_input < thermal_cruiseX - toleranceX, the chip will decrease
|
| H A D | w83792d.rst | 159 (3) If the temperature goes below the low limit, PWM duty cycle will decrease
|
| /linux/Documentation/sound/soc/ |
| H A D | pops-clicks.rst | 52 is heard when the gain increase or decrease changes the mean audio signal
|
| /linux/Documentation/scheduler/ |
| H A D | schedutil.rst | 39 will decrease to reflect the fraction of time each task spends on the CPU
102 highest. UTIL_EST filters to instantly increase and only decay on decrease.
|
| /linux/fs/ocfs2/ |
| H A D | Kconfig | 78 this option for debugging only as it is likely to decrease
|
| /linux/drivers/net/ethernet/wiznet/ |
| H A D | Kconfig | 70 Performance may decrease compared to explicitly selected bus mode.
|
| /linux/arch/mips/cavium-octeon/ |
| H A D | Kconfig | 10 workarounds will cause a slight decrease in performance on
|
| /linux/arch/arm/boot/dts/st/ |
| H A D | stm32mp135f-dhcor-dhsbc.dts | 397 st,decrease-hs-slew-rate;
415 st,decrease-hs-slew-rate;
|
| H A D | stm32mp135f-dk.dts | 597 st,decrease-hs-slew-rate;
611 st,decrease-hs-slew-rate;
|
| /linux/Documentation/driver-api/media/ |
| H A D | v4l2-device.rst | 128 decrease the refcount manually as well by calling:
|
| /linux/Documentation/PCI/ |
| H A D | sysfs-pci.rst | 79 echoed into it, it will then return '5'. Echoing a '0' into it will decrease
|
| /linux/Documentation/RCU/ |
| H A D | UP.rst | 27 element B. This situation can greatly decrease the life expectancy of
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-fs-f2fs | 183 needs to decrease this value to reduce the space overhead.
538 decrease. If you write "0" here, you can initialize
546 decrease. If you write "0" here, you can initialize
554 doesn't decrease. If you write "0" here, you can initialize
|
| /linux/Documentation/driver-api/thermal/ |
| H A D | cpu-idle-cooling.rst | 37 decrease. Acting on the idle state duration or the idle cycle
|
| /linux/Documentation/timers/ |
| H A D | hrtimers.rst | 75 hrtimers. E.g. we could decrease the frequency of the timeout subsystem
|
| /linux/Documentation/networking/devlink/ |
| H A D | devlink-dpipe.rst | 237 tables this table does multiple operations like TTL decrease and MTU check.
|
| /linux/Documentation/cpu-freq/ |
| H A D | cpu-drivers.rst | 150 policy->max first, and only if this is no solution, decrease policy->min.
|
| /linux/Documentation/process/ |
| H A D | stable-api-nonsense.rst | 184 original developer) will decrease.
|
| /linux/Documentation/driver-api/ |
| H A D | libata.rst | 970 - if SATA, decrease SATA PHY speed. if speed cannot be decreased,
972 - decrease UDMA xfer speed. if at UDMA0, switch to PIO4,
974 - decrease PIO xfer speed. if at PIO3, complain, but continue
|