| /linux/arch/arm64/boot/dts/amlogic/ |
| H A D | meson-gxl-s905x-khadas-vim.dts | 197 "WIFI SDIO D0", "WIFI SDIO D1", "WIFI SDIO D2",
198 "WIFI SDIO D3", "WIFI SDIO CLK", "WIFI SDIO CMD",
199 "WIFI Power Enable", "WIFI WAKE HOST",
204 "WIFI 32K", "Bluetooth Enable",
|
| H A D | meson-gxbb-nanopi-k2.dts | 284 "WIFI SDIO D0", "WIFI SDIO D1", "WIFI SDIO D2",
285 "WIFI SDIO D3", "WIFI SDIO CLK", "WIFI SDIO CMD",
286 "WIFI Power Enable", "WIFI WAKE HOST",
291 "", "", "", "WIFI 32K", "Bluetooth Enable",
|
| H A D | meson-g12a-u200.dts | 277 /* Connected to the WIFI/BT chip */
|
| /linux/arch/arm64/boot/dts/qcom/ |
| H A D | sc7280-herobrine-wifi-sku.dtsi | 3 * Google Herobrine dts fragment for WIFI SKUs
8 /* WIFI SKUs save 256M by not having modem/mba/rmtfs memory regions defined. */
|
| H A D | sc7180-trogdor-pazquel360-wifi.dts | 15 model = "Google Pazquel (Parade,WIFI-only)";
|
| /linux/drivers/input/misc/ |
| H A D | wistron_btns.c | 30 #define WIFI 0x35 macro
1049 bios_set_state(WIFI, (value != LED_OFF) ? 1 : 0); in wistron_wifi_led_set()
1065 u16 wifi = bios_get_default_setting(WIFI); in wistron_led_init()
1071 bios_set_state(WIFI, wistron_wifi_led.brightness); in wistron_led_init()
1124 bios_set_state(WIFI, wifi_enabled); in handle_key()
1257 u16 wifi = bios_get_default_setting(WIFI); in wistron_probe()
1264 bios_set_state(WIFI, wifi_enabled); in wistron_probe()
1299 bios_set_state(WIFI, 0); in wistron_suspend()
1312 bios_set_state(WIFI, wifi_enabled); in wistron_resume()
|
| /linux/arch/arm/boot/dts/allwinner/ |
| H A D | sun4i-a10-pcduino2.dts | 48 * the USB host ports has been replaced with a USB WIFI chip.
64 usb1_vbus-supply = <®_vcc3v3>; /* USB WIFI is always on */
|
| H A D | sun8i-s3-pinecube.dts | 49 gpio = <&pio 1 2 GPIO_ACTIVE_LOW>; /* PB2 WIFI-EN */
56 reset-gpios = <&pio 1 3 GPIO_ACTIVE_LOW>; /* PB3 WIFI-RST */
|
| /linux/arch/arm64/boot/dts/freescale/ |
| H A D | imx8mm-ddr4-evk.dts | 11 model = "FSL i.MX8MM DDR4 EVK with CYW43455 WIFI/BT board";
|
| H A D | imx8mm-var-som.dtsi | 296 /* WIFI */
|
| H A D | imx8mn-var-som.dtsi | 290 /* WIFI */
|
| /linux/arch/arm/boot/dts/ti/omap/ |
| H A D | omap3-pandora-600mhz.dts | 57 OMAP3430_CORE2_IOPAD(0x25ea, PIN_INPUT | MUX_MODE4) /* etk_d7.gpio_21 = WIFI IRQ */
|
| H A D | omap3-pandora-1ghz.dts | 57 OMAP3630_CORE2_IOPAD(0x25ea, PIN_INPUT | MUX_MODE4) /* etk_d7.gpio_21 = WIFI IRQ */
|
| /linux/arch/arm64/boot/dts/ti/ |
| H A D | k3-am6548-iot2050-advanced-sm.dts | 134 "UART0-enable", "UART0-terminate", "", "WIFI-disable",
|
| H A D | k3-am65-iot2050-arduino-connector.dtsi | 694 "UART0-enable", "UART0-terminate", "", "WIFI-disable",
|
| /linux/arch/arm64/boot/dts/hisilicon/ |
| H A D | hi3670-hikey970.dts | 394 &dwmmc2 { /* WIFI */
|
| H A D | hi3660-hikey960.dts | 648 &dwmmc2 { /* WIFI */
|
| /linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6qdl-ts4900.dtsi | 386 MX6QDL_PAD_ENET_RXD1__GPIO1_IO26 0x17059 /* WIFI IRQ */
|
| /linux/drivers/pinctrl/ |
| H A D | pinctrl-xway.c | 896 MFP_XWAY(GPIO9, GPIO, WIFI, NONE, EXIN),
898 MFP_XWAY(GPIO11, GPIO, USIF, WIFI, SPI),
|
| /linux/arch/arm64/boot/dts/nvidia/ |
| H A D | tegra132-norrin.dts | 994 /* WIFI/BT module */
|
| /linux/ |
| H A D | MAINTAINERS | 12020 INTEL WIRELESS WIFI LINK (iwlwifi)
15663 MICROCHIP WILC1000 WIFI DRIVER
|