Home
last modified time | relevance | path

Searched refs:RXD (Results 1 – 22 of 22) sorted by relevance

/linux/arch/arm/boot/dts/st/
H A Dste-href-family-pinctrl.dtsi23 pins = "GPIO218_AH11"; /* RXD */
41 pins = "GPIO218_AH11"; /* RXD */
58 "GPIO218_AH11"; /* RXD */
H A Dste-hrefprev60.dtsi80 pins = "GPIO145_C13"; /* RXD */
H A Dste-hrefv60plus.dtsi368 /* Normally UART1 RXD, now dangling */
H A Dste-snowball.dts569 pins = "GPIO145_C13"; /* RXD */
/linux/arch/arm64/boot/dts/renesas/
H A Drzg3s-smarc.dtsi190 pinmux = <RZG2L_PORT_PINMUX(6, 3, 1)>, /* RXD */
195 pinmux = <RZG2L_PORT_PINMUX(17, 2, 7)>, /* RXD */
235 <RZG2L_PORT_PINMUX(18, 5, 8)>; /* RXD */
H A Dr9a08g045s33-smarc-pmod1-type-3a.dtso35 <RZG2L_PORT_PINMUX(14, 1, 1)>, /* RXD */
H A Drzg2ul-smarc-pinfunction.dtsi119 <RZG2L_PORT_PINMUX(3, 3, 2)>; /* RXD */
H A Drzg2lc-smarc-pinfunction.dtsi129 <RZG2L_PORT_PINMUX(45, 3, 1)>; /* RXD */
H A Drzg2l-smarc-pinfunction.dtsi148 <RZG2L_PORT_PINMUX(45, 3, 1)>; /* RXD */
/linux/Documentation/devicetree/bindings/net/bluetooth/
H A Dmediatek,bluetooth.txt22 - pinctrl-0: Should contain UART RXD low when the device is powered up to
30 - boot-gpios: GPIO same to the pin as UART RXD and used to keep LOW when
/linux/arch/arm64/boot/dts/amlogic/
H A Dmeson-gxm-ugoos-am3.dts7 * Vcc RXD TXD GND
/linux/arch/arm/boot/dts/microchip/
H A Dsama5d4.dtsi1362 <AT91_PIOE 29 AT91_PERIPH_B AT91_PINCTRL_PULL_UP /* RXD */
1371 <AT91_PIOC 25 AT91_PERIPH_C AT91_PINCTRL_PULL_UP /* RXD */
1380 <AT91_PIOD 12 AT91_PERIPH_A AT91_PINCTRL_PULL_UP /* RXD */
1395 <AT91_PIOD 16 AT91_PERIPH_A AT91_PINCTRL_PULL_UP /* RXD */
1410 <AT91_PIOB 4 AT91_PERIPH_B AT91_PINCTRL_PULL_UP /* RXD - conflicts with G0_CRS, ISI_HSYNC */
1425 <AT91_PIOE 16 AT91_PERIPH_B AT91_PINCTRL_PULL_UP /* RXD */
1434 <AT91_PIOE 26 AT91_PERIPH_B AT91_PINCTRL_PULL_UP /* RXD */
H A Dlan966x-kontron-kswitch-d10-mmt.dtsi98 /* RXD, TXD */
H A Dlan966x-pcb8309.dts136 /* RXD, TXD */
H A Dat91-tse850-3.dts325 /* 28 */ "RXD", "TXD", "BRX", "BTX";
/linux/drivers/mtd/nand/raw/
H A Dmxic_nand.c64 #define RXD 0x24 macro
374 data = readl(nfc->regs + RXD); in mxic_nfc_data_xfer()
/linux/drivers/mailbox/
H A Dbcm-pdc-mailbox.c71 #define RXD(x, max_mask) XXD((x), (max_mask)) macro
74 #define NEXTRXD(i, max_mask) RXD((i) + 1, (max_mask))
75 #define PREVRXD(i, max_mask) RXD((i) - 1, (max_mask))
77 #define NRXDACTIVE(h, t, max_mask) RXD((t) - (h), (max_mask))
/linux/drivers/net/ethernet/intel/idpf/
H A Didpf_txrx.h86 #define IDPF_RX_BUFQ_DESC_COUNT(RXD, NUM_BUFQ) ((RXD) / (NUM_BUFQ)) argument
/linux/arch/arm64/boot/dts/rockchip/
H A Drk3326-odroid-go.dtsi541 /* EXT Header(P2): 2(RXD:GPIO1.C0),3(TXD:.C1),4(CTS:.C2),5(RTS:.C3) */
/linux/Documentation/networking/dsa/
H A Dsja1105.rst341 In the RMII spec, the PHY can transmit extra out-of-band signals via RXD[1:0].
/linux/arch/arm64/boot/dts/ti/
H A Dk3-am69-aquila.dtsi657 /* Aquila UART_4 (RXD) */
/linux/Documentation/driver-api/
H A Dpin-control.rst437 (these are four pins: CLK, RXD, TXD, FRM). In that case, pin B5 can be used as