| /linux/Documentation/spi/ |
| H A D | spi-lm70llp.rst | 46 D7 9 --> SI/O 5 52 is connected to both pin D7 (as Master Out) and Select (as Master In) 65 transistor Q1 (and also a pullup, and a zener diode to D7); while the 69 and not grounded by the host via D7), the transistor conducts and switches
|
| H A D | butterfly.rst | 37 MOSI J403.PB2/MOSI pin 9/D7
|
| /linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3566-radxa-zero-3.dtsi | 116 /* GPIO0_D0 - D7 */ 131 /* GPIO1_D0 - D7 */ 143 /* GPIO2_D0 - D7 */ 161 /* GPIO3_D0 - D7 */ 176 /* GPIO4_D0 - D7 */
|
| H A D | rk3308-rock-pi-s.dts | 180 /* GPIO0_D0 - D7 */ 193 /* GPIO1_D0 - D7 */ 212 /* GPIO2_D0 - D7 */ 226 /* GPIO3_D0 - D7 */
|
| H A D | rk3328-rock-pi-e.dts | 190 /* GPIO0_D0 - D7 */ 202 /* GPIO1_D0 - D7 */ 218 /* GPIO2_D0 - D7 */ 231 /* GPIO3_D0 - D7 */
|
| /linux/arch/arm/boot/dts/aspeed/ |
| H A D | aspeed-bmc-qcom-dc-scm-v1.dts | 98 /*D0-D7*/ "","","","","","","","", 135 /*D0-D7*/ "","BMC_SPI1_RST_N","BIOS_FLASH_MUX_SEL","",
|
| H A D | aspeed-bmc-vegman-n110.dts | 18 /*D0-D7*/ "","","","","","","","", 55 /*D0-D7*/ "","","","","","","","","","","","","","","","",
|
| H A D | aspeed-bmc-vegman-sx20.dts | 18 /*D0-D7*/ "","","","","","","","", 55 /*D0-D7*/ "","","","","","","","","","","","","","","","",
|
| H A D | aspeed-bmc-facebook-greatlakes.dts | 252 /*D0-D7*/ "","","","","","","","", 290 /*18D0-18D7*/ "","","","","","","","",
|
| H A D | aspeed-bmc-amd-daytonax.dts | 128 /*D0-D7*/ "","","ASSERT_BMC_READY","","","","","",
|
| H A D | aspeed-bmc-amd-ethanolx.dts | 121 /*D0-D7*/ "HDT_DBREQ","LOCAL_SPI_ROM_SEL","FPGA_SPI_ROM_SEL","JTAG_MUX_S",
|
| H A D | aspeed-bmc-ufispace-ncplite.dts | 341 /*D0-D7*/ "","","","","","","","",
|
| H A D | aspeed-bmc-inventec-starscream.dts | 322 /*D0-D7*/ "","","","","","","","",
|
| /linux/arch/arm/boot/dts/rockchip/ |
| H A D | rk3128-xpi-3128.dts | 291 /* GPIO0 D0-D7 */ 306 /* GPIO1 D0-D7 */ 321 /* GPIO2 D0-D7 */ 336 /* GPIO3 D0-D7 */
|
| /linux/arch/arm/boot/dts/intel/socfpga/ |
| H A D | socfpga_cyclone5_socrates.dts | 63 label = "led:green:D7";
|
| /linux/arch/arm64/boot/dts/ti/ |
| H A D | k3-am62p-verdin-ivy.dtsi | 113 /* D7 Blue - SODIMM 30 - LEDs.GPIO1 */ 122 /* D7 Green - SODIMM 32 - LEDs.GPIO2 */ 131 /* D7 Red - SODIMM 34 - LEDs.GPIO3 */
|
| H A D | k3-am62-verdin-ivy.dtsi | 109 /* D7 Blue - SODIMM 30 - LEDs.GPIO1 */ 118 /* D7 Green - SODIMM 32 - LEDs.GPIO2 */ 127 /* D7 Red - SODIMM 34 - LEDs.GPIO3 */
|
| /linux/Documentation/networking/ |
| H A D | plip.rst | 147 D5,D6,D7 are 7*, 8*, 9* 180 D7->D7 9 - 9
|
| /linux/Documentation/i2c/busses/ |
| H A D | i2c-parport.rst | 89 - Pins 4-9 (D2-D7) could be used as VDD is the driver drives them high. 90 The ADM1032 evaluation board uses D4-D7. Beware that the amount of
|
| /linux/drivers/pinctrl/aspeed/ |
| H A D | pinctrl-aspeed-g7-soc1.c | 231 D7, enumerator 506 PIN(D7), 761 [D7] = 106, [N13] = 107, [C8] = 108, [C9] = 109, [C10] = 110, [M16] = 111, [A15] = 112, 975 PIN_GROUP(DSGPM0, D19, B10, C7, D7); 1082 PIN_GROUP(RGMII1, D19, B11, D15, B12, B10, P13, C18, C6, C7, D7, N13, C8); 1085 PIN_GROUP(RMII1, D19, D15, B12, B10, P13, C6, C7, D7);
|
| H A D | pinctrl-aspeed-g5.c | 1173 #define D7 157 macro 1174 SIG_EXPR_LIST_DECL_SINGLE(D7, GPIOT5, GPIOT5, SIG_DESC_SET(SCUA0, 5)); 1175 SIG_EXPR_LIST_DECL_SINGLE(D7, RMII1DASH1, RMII1, RMII1_DESC); 1176 SIG_EXPR_LIST_DECL_SINGLE(D7, RGMII1TXD3, RGMII1); 1177 PIN_DECL_(D7, SIG_EXPR_LIST_PTR(D7, GPIOT5), SIG_EXPR_LIST_PTR(D7, RMII1DASH1), 1178 SIG_EXPR_LIST_PTR(D7, RGMII1TXD3)); 1265 FUNC_GROUP_DECL(RGMII1, B4, A4, A3, D6, C5, C4, B5, E9, F9, A5, E7, D7); 1989 ASPEED_PINCTRL_PIN(D7), 2545 ASPEED_SB_PINCONF(PIN_CONFIG_BIAS_PULL_DOWN, B5, D7, SCU90, 12), 2546 ASPEED_SB_PINCONF(PIN_CONFIG_BIAS_DISABLE, B5, D7, SCU90, 12),
|
| /linux/Documentation/arch/xtensa/ |
| H A D | mmu.rst | 42 80..9F -> 80 -> 80 -> 80 D0..D7 -> 00 -> 00
|
| /linux/arch/m68k/fpsp040/ |
| H A D | binstr.S | 21 | A1. Init d7 to 1. D7 is the byte digit counter, and if 1, the
|
| /linux/arch/arm/boot/dts/ti/omap/ |
| H A D | omap3-beagle-xm.dts | 48 gpios = <&gpio5 21 GPIO_ACTIVE_HIGH>; /* 149 -> D7 LED */
|
| H A D | omap3-beagle.dts | 44 gpios = <&gpio5 21 GPIO_ACTIVE_HIGH>; /* 149 -> D7 LED */
|