Searched +full:touchscreen +full:- +full:y +full:- +full:plate +full:- +full:ohms (Results 1 – 14 of 14) sorted by relevance
/linux/Documentation/devicetree/bindings/input/touchscreen/ |
H A D | ti,tsc2005.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/input/touchscreen/ti,tsc2005.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: Texas Instruments TSC2004 and TSC2005 touchscreen controller 10 - Marek Vasut <marex@denx.de> 11 - Michael Welling <mwelling@ieee.org> 15 pattern: "^touchscreen(@.*)?$" 19 - ti,tsc2004 20 - ti,tsc2005 [all …]
|
H A D | bu21029.txt | 4 - compatible : must be "rohm,bu21029" 5 - reg : i2c device address of the chip (0x40 or 0x41) 6 - interrupt-parent : the phandle for the gpio controller 7 - interrupts : (gpio) interrupt to which the chip is connected 8 - rohm,x-plate-ohms : x-plate resistance in Ohm 11 - reset-gpios : gpio pin to reset the chip (active low) 12 - touchscreen-size-x : horizontal resolution of touchscreen (in pixels) 13 - touchscreen-size-y : vertical resolution of touchscreen (in pixels) 14 - touchscreen-max-pressure: maximum pressure value 15 - vdd-supply : power supply for the controller [all …]
|
/linux/arch/arm/boot/dts/nxp/imx/ |
H A D | imx53-sk-imx53-atm0700d4.dtsi | 1 // SPDX-License-Identifier: GPL-2.0+ 5 /dts-v1/; 7 #include <dt-bindings/pwm/pwm.h> 8 #include "imx53-sk-imx53.dts" 11 panel: panel-rgb { 12 compatible = "powertip,ph800480t013-idf02"; 21 compatible = "spi-gpio"; 22 #address-cells = <0x1>; 23 #size-cells = <0x0>; 25 num-chipselects = <1>; [all …]
|
H A D | imx6qdl-skov-cpu-revc.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0 OR MIT) 6 touchscreen { 7 compatible = "resistive-adc-touch"; 8 io-channels = <&adc_ts 1>, <&adc_ts 3>, <&adc_ts 4>, <&adc_ts 5>; 9 io-channel-names = "y", "z1", "z2", "x"; 10 touchscreen-min-pressure = <65000>; 11 touchscreen-inverted-y; 12 touchscreen-swapped-x-y; 13 touchscreen-x-plate-ohms = <300>; 14 touchscreen-y-plate-ohms = <800>; [all …]
|
H A D | imx6dl-victgo.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT 7 /dts-v1/; 9 #include "imx6qdl-vicut1.dtsi" 15 gpio-keys { 16 compatible = "gpio-keys"; 17 pinctrl-names = "default"; 18 pinctrl-0 = <&pinctrl_gpiokeys>; 21 key-power { 25 wakeup-source; 28 key-enter { [all …]
|
H A D | imx6dl-plym2m.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT 7 /dts-v1/; 8 #include <dt-bindings/gpio/gpio.h> 9 #include <dt-bindings/leds/common.h> 17 stdout-path = &uart4; 21 compatible = "pwm-backlight"; 23 brightness-levels = <0 1000>; 24 num-interpolated-steps = <20>; 25 default-brightness-level = <19>; 26 power-supply = <®_12v0>; [all …]
|
/linux/drivers/input/touchscreen/ |
H A D | resistive-adc-touch.c | 1 // SPDX-License-Identifier: GPL-2.0 3 * ADC generic resistive touchscreen (GRTS) 13 #include <linux/input/touchscreen.h> 21 #define DRIVER_NAME "resistive-adc-touch" 37 * struct grts_state - generic resistive touch screen information struct 38 * @x_plate_ohms: resistance of the X plate 44 * @prop: touchscreen properties struct 45 * @ch_map: map of channels that are defined for the touchscreen 62 unsigned int x, y, press = 0; in grts_cb() local 64 x = touch_info[st->ch_map[GRTS_CH_X]]; in grts_cb() [all …]
|
H A D | bu21029_ts.c | 1 // SPDX-License-Identifier: GPL-2.0 3 * Rohm BU21029 touchscreen controller driver 5 * Copyright (C) 2015-2018 Bosch Sicherheitssysteme GmbH 16 #include <linux/input/touchscreen.h> 25 * +--------+--------+--------+--------+--------+--------+--------+--------+ 27 * +--------+--------+--------+--------+--------+--------+--------+--------+ 29 * +--------+--------+--------+--------+--------+--------+--------+--------+ 31 * +--------+--------+--------+--------+--------+--------+--------+--------+ 33 * +--------+--------+--------+--------+--------+--------+--------+--------+ 35 * +--------+--------+--------+--------+--------+--------+--------+--------+ [all …]
|
H A D | ads7846.c | 1 // SPDX-License-Identifier: GPL-2.0-only 3 * ADS7846 based touchscreen and sensor driver 10 * - corgi_ts.c 11 * Copyright (C) 2004-2005 Richard Purdie 12 * - omap_ts.[hc], ads7846.h, ts_osk.c 23 #include <linux/input/touchscreen.h> 39 * Support for ads7843 tested on Atmel at91sam926x-EK. 53 * note. The strength of filtering can be set in the board-* specific 76 * driver is used with DMA-based SPI controllers (like atmel_spi) on 77 * systems where main memory is not DMA-coherent (most non-x86 boards). [all …]
|
/linux/arch/arm64/boot/dts/freescale/ |
H A D | imx8mm-var-som.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 10 model = "Variscite VAR-SOM-MX8MM module"; 13 stdout-path = &uart4; 21 reg_eth_phy: regulator-eth-phy { 22 compatible = "regulator-fixed"; 23 pinctrl-names = "default"; 24 pinctrl-0 = <&pinctrl_reg_eth_phy>; 25 regulator-name = "eth_phy_pwr"; 26 regulator-min-microvolt = <3300000>; 27 regulator-max-microvolt = <3300000>; [all …]
|
H A D | imx8mn-var-som.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 4 * Copyright 2019-2020 Variscite Ltd. 11 model = "Variscite VAR-SOM-MX8MN module"; 12 compatible = "variscite,var-som-mx8mn", "fsl,imx8mn"; 15 stdout-path = &uart4; 23 reg_eth_phy: regulator-eth-phy { 24 compatible = "regulator-fixed"; 25 pinctrl-names = "default"; 26 pinctrl-0 = <&pinctrl_reg_eth_phy>; 27 regulator-name = "eth_phy_pwr"; [all …]
|
/linux/arch/arm/boot/dts/ti/omap/ |
H A D | logicpd-torpedo-baseboard.dtsi | 1 // SPDX-License-Identifier: GPL-2.0-only 5 compatible = "gpio-keys"; 6 pinctrl-names = "default"; 7 pinctrl-0 = <&gpio_key_pins &gpio_key_pins_wkup>; 13 wakeup-source; 20 wakeup-source; 27 wakeup-source; 34 wakeup-source; 39 compatible = "ti,omap-twl4030"; 45 compatible = "gpio-leds"; [all …]
|
H A D | omap3-n900.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later 4 * Copyright (C) 2013-2014 Aaro Koskinen <aaro.koskinen@iki.fi> 7 /dts-v1/; 10 #include <dt-bindings/input/input.h> 11 #include <dt-bindings/leds/common.h> 12 #include <dt-bindings/media/video-interfaces.h> 15 * Default secure signed bootloader (Nokia X-Loader) does not enable L3 firewall 17 * blocks then kernel receive "Unhandled fault: external abort on non-linefetch" 18 * and crash. Until somebody fix omap-aes.c and omap_hwmod_3xxx_data.c code (no 34 compatible = "nokia,omap3-n900", "ti,omap3430", "ti,omap3"; [all …]
|
/linux/arch/arm/mach-pxa/ |
H A D | spitz.c | 1 // SPDX-License-Identifier: GPL-2.0-only 3 * Support for Sharp SL-Cxx00 Series of PDAs 4 * Models: SL-C3000 (Spitz), SL-C1000 (Akita) and SL-C3100 (Borzoi) 20 #include <linux/platform_data/i2c-pxa.h> 28 #include <linux/input-event-codes.h> 37 #include <asm/mach-types.h> 43 #include "pxa27x-udc.h" 45 #include <linux/platform_data/mmc-pxamci.h> 46 #include <linux/platform_data/usb-ohci-pxa27x.h> 47 #include <linux/platform_data/video-pxafb.h> [all …]
|