Home
last modified time | relevance | path

Searched +full:tcb +full:- +full:capture (Results 1 – 8 of 8) sorted by relevance

/linux/drivers/counter/
H A Dmicrochip-tcb-capture.c1 // SPDX-License-Identifier: GPL-2.0-only
74 if (priv->qdec_mode) in mchp_tc_count_function_read()
89 regmap_read(priv->regmap, ATMEL_TC_BMR, &bmr); in mchp_tc_count_function_write()
90 regmap_read(priv->regmap, ATMEL_TC_REG(priv->channel[0], CMR), &cmr); in mchp_tc_count_function_write()
92 /* Set capture mode */ in mchp_tc_count_function_write()
97 priv->qdec_mode = 0; in mchp_tc_count_function_write()
100 if (!priv->tc_cfg->has_gclk) in mchp_tc_count_function_write()
104 /* Setup the period capture mode */ in mchp_tc_count_function_write()
109 if (!priv->tc_cfg->has_qdec) in mchp_tc_count_function_write()
110 return -EINVAL; in mchp_tc_count_function_write()
[all …]
H A DMakefile1 # SPDX-License-Identifier: GPL-2.0-only
6 obj-$(CONFIG_COUNTER) += counter.o
7 counter-y := counter-core.o counter-sysfs.o counter-chrdev.o
9 obj-$(CONFIG_I8254) += i8254.o
10 obj-$(CONFIG_104_QUAD_8) += 104-quad-8.o
11 obj-$(CONFIG_INTERRUPT_CNT) += interrupt-cnt.o
12 obj-$(CONFIG_RZ_MTU3_CNT) += rz-mtu3-cnt.o
13 obj-$(CONFIG_STM32_TIMER_CNT) += stm32-timer-cnt.o
14 obj-$(CONFIG_STM32_LPTIMER_CNT) += stm32-lptimer-cnt.o
15 obj-$(CONFIG_TI_EQEP) += ti-eqep.o
[all …]
H A DKconfig1 # SPDX-License-Identifier: GPL-2.0-only
31 tristate "ACCES 104-QUAD-8 driver"
37 Say yes here to build support for the ACCES 104-QUAD-8 quadrature
38 encoder counter/interface device family (104-QUAD-8, 104-QUAD-4).
41 operation on the respective count value attribute. The 104-QUAD-8
58 module will be called ftm-quaddec.
69 will be called intel-qep.
79 module will be called interrupt-cnt.
82 tristate "Microchip Timer Counter Capture driver"
88 capture driver.
[all …]
/linux/sound/pci/emu10k1/
H A Demufx.c1 // SPDX-License-Identifier: GPL-2.0-or-later
4 * James Courtier-Dutton <James@superbug.co.uk>
25 #if 0 /* for testing purposes - digital out -> capture */
28 #if 0 /* for testing purposes - set S/PDIF to AC3 output */
31 #if 0 /* for testing purposes - feed the front signal to Center/LFE outputs */
37 MODULE_PARM_DESC(high_res_gpr_volume, "GPR mixer controls use 31-bit range.");
132 /* 0x0a */ "PCM Capture Left",
133 /* 0x0b */ "PCM Capture Right",
134 /* 0x0c */ "MIC Capture",
177 /* 0x12 */ "ADC Capture Left",
[all …]
H A Demu10k1_main.c1 // SPDX-License-Identifier: GPL-2.0-or-later
4 * James Courtier-Dutton <James@superbug.co.uk>
85 if (emu->audigy) { in snd_emu10k1_voice_init()
128 { 0x0e, 0xcf }, /* Attenuation Left 0x01 = -103dB, 0xff = 24dB */
146 HCFG_MUTEBUTTONENABLE, emu->port + HCFG); in snd_emu10k1_init()
148 outl(0, emu->port + INTE); in snd_emu10k1_init()
169 if (emu->audigy) { in snd_emu10k1_init()
182 SPCS0, emu->spdif_bits[0], in snd_emu10k1_init()
183 SPCS1, emu->spdif_bits[1], in snd_emu10k1_init()
184 SPCS2, emu->spdif_bits[2], in snd_emu10k1_init()
[all …]
/linux/include/sound/
H A Demu10k1.h1 /* SPDX-License-Identifier: GPL-2.0-or-later */
16 #include <sound/pcm-indirect.h>
25 /* ------------------- DEFINES -------------------- */
33 /* FIXME? - according to the OSS driver the EMU10K1 needs a 29 bit DMA mask */
41 // This is used to define hardware bit-fields (sub-registers) by combining
44 // The non-concatenating (_NC) variant should be used directly only for
45 // sub-registers that do not follow the <register>_<field> naming pattern.
55 // Macros for manipulating values of bit-fields declared using the above macros.
59 // single sub-register at a time.
62 #define REG_MASK0(r) ((1U << REG_SIZE(r)) - 1U)
[all …]
/linux/Documentation/admin-guide/
H A Dkernel-parameters.txt16 force -- enable ACPI if default was off
17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
18 off -- disable ACPI if default was on
19 noirq -- do not use ACPI for IRQ routing
20 strict -- Be less tolerant of platforms that are not
22 rsdt -- prefer RSDT over (default) XSDT
23 copy_dsdt -- copy DSDT to memory
24 nocmcff -- Disable firmware first mode for corrected
28 nospcr -- disable console in ACPI SPCR table as
45 If set to vendor, prefer vendor-specific driver
[all …]
/linux/
H A DMAINTAINERS5 ---------------------------------------------------
21 W: *Web-page* with status/info
23 B: URI for where to file *bugs*. A web-page with detailed bug
28 patches to the given subsystem. This is either an in-tree file,
29 or a URI. See Documentation/maintainer/maintainer-entry-profile.rst
46 N: [^a-z]tegra all files whose path contains tegra
64 ----------------
83 3WARE SAS/SATA-RAID SCSI DRIVERS (3W-XXXX, 3W-9XXX, 3W-SAS)
85 L: linux-scsi@vger.kernel.org
88 F: drivers/scsi/3w-*
[all …]