Home
last modified time | relevance | path

Searched +full:rx +full:- +full:crci (Results 1 – 6 of 6) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/mtd/
H A Dqcom,nandc.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
15 - qcom,ipq806x-nand
16 - qcom,ipq4019-nand
17 - qcom,ipq6018-nand
18 - qcom,ipq8074-nand
19 - qcom,sdx55-nand
26 - description: Core Clock
[all …]
H A Dqcom_nandc.txt4 - compatible: must be one of the following:
5 * "qcom,ipq806x-nand" - for EBI2 NAND controller being used in IPQ806x
7 * "qcom,ipq4019-nand" - for QPIC NAND controller v1.4.0 being used in
9 * "qcom,ipq6018-nand" - for QPIC NAND controller v1.5.0 being used in
11 * "qcom,ipq8074-nand" - for QPIC NAND controller v1.5.0 being used in
13 * "qcom,sdx55-nand" - for QPIC NAND controller v2.0.0 being used in
16 - reg: MMIO address range
17 - clocks: must contain core clock and always on clock
18 - clock-names: must contain "core" for the core clock and "aon" for the
22 - dmas: DMA specifier, consisting of a phandle to the ADM DMA
[all …]
/freebsd/sys/contrib/device-tree/Bindings/dma/
H A Dqcom_adm.txt4 - compatible: must contain "qcom,adm" for IPQ/APQ8064 and MSM8960
5 - reg: Address range for DMA registers
6 - interrupts: Should contain one interrupt shared by all channels
7 - #dma-cells: must be <2>. First cell denotes the channel number. Second cell
8 denotes CRCI (client rate control interface) flow control assignment.
9 - clocks: Should contain the core clock and interface clock.
10 - clock-names: Must contain "core" for the core clock and "iface" for the
12 - resets: Must contain an entry for each entry in reset names.
13 - reset-names: Must include the following entries:
14 - clk
[all …]
/freebsd/sys/contrib/device-tree/Bindings/serial/
H A Dqcom,msm-uartdm.yaml1 # SPDX-License-Identifier: GPL-2.0 OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/serial/qcom,msm-uartdm.yaml#
5 $schema: http://devicetree.org/meta-schema
[all...]
H A Dqcom,msm-uartdm.txt3 The MSM serial UARTDM hardware is designed for high-speed use cases where the
4 transmit and/or receive channels can be offloaded to a dma-engine. From a
9 - compatible: Should contain at least "qcom,msm-uartdm".
12 "qcom,msm-uartdm-v1.1"
13 "qcom,msm-uartdm-v1.2"
14 "qcom,msm-uartdm-v1.3"
15 "qcom,msm-uartdm-v1.4"
16 - reg: Should contain UART register locations and lengths. The first
19 "qcom,msm-uartdm-v1.3" is the only compatible value that might
21 - interrupts: Should contain UART interrupt.
[all …]
/freebsd/sys/contrib/device-tree/src/arm/qcom/
H A Dqcom-ipq8064.dtsi1 // SPDX-License-Identifier: GPL-2.0
2 /dts-v1/;
4 #include <dt-bindings/interrupt-controller/arm-gic.h>
5 #include <dt-bindings/mfd/qcom-rpm.h>
6 #include <dt-binding
[all...]