| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-sx9324 | 15 (PH0, PH1, PH2, PH3), where the inputs are configured
18 By default, during the first phase, [PH0], CS0 is measured,
|
| /linux/drivers/clk/meson/ |
| H A D | clk-phase.h | 18 struct parm ph0; member
|
| /linux/arch/arm64/boot/dts/qcom/ |
| H A D | sc7180-trogdor-quackingstick-r0-lte.dts | 21 semtech,ph0-pin = <3 1 3>;
|
| H A D | sc7180-trogdor-pazquel.dtsi | 12 semtech,ph0-pin = <1 3 3>;
|
| /linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | nvidia,tegra124-pinmux.yaml | 58 pk2, pi3, pi6, pg0, pg1, pg2, pg3, pg4, pg5, pg6, pg7, ph0,
|
| /linux/arch/arm/boot/dts/allwinner/ |
| H A D | sun7i-a20-bananapro.dts | 180 gpio = <&pio 7 0 GPIO_ACTIVE_HIGH>; /* PH0 */
|
| H A D | sun4i-a10-inet1.dts | 108 interrupts = <7 0 IRQ_TYPE_EDGE_RISING>; /* PH0 / EINT0 */
|
| H A D | sun7i-a20-olimex-som-evb.dts | 217 cd-gpios = <&pio 7 0 GPIO_ACTIVE_LOW>; /* PH0 */
|
| H A D | sun4i-a10-inet9f-rev03.dts | 239 interrupts = <7 0 IRQ_TYPE_EDGE_RISING>; /* PH0 / EINT0 */
|
| H A D | sun7i-a20.dtsi | 827 pins = "PH0", "PH1", "PH2", "PH3", "PH4",
1123 pins = "PH0", "PH1";
|
| H A D | sun8i-a23-a33.dtsi | 433 pins = "PH0";
|
| /linux/drivers/pwm/ |
| H A D | pwm-rcar.c | 148 /* Don't enable the PWM device if CYC0 or PH0 is 0 */ in rcar_pwm_enable()
|
| /linux/arch/arm64/boot/dts/allwinner/ |
| H A D | sun50i-a100.dtsi | 240 pins = "PH0", "PH1", "PH2", "PH3", "PH4",
248 pins = "PH0", "PH1", "PH2", "PH3", "PH4",
|
| H A D | sun55i-a523.dtsi | 184 pins = "PH0", "PH1", "PH2", "PH3", "PH4",
|
| H A D | sun50i-h616.dtsi | 373 pins = "PH0", "PH1";
|
| /linux/drivers/iio/proximity/ |
| H A D | sx9324.c | 169 /* 4 channels, as defined in STAT0: PH0, PH1, PH2 and PH3. */
916 "semtech,ph0-pin"); in sx9324_get_default_reg()
|
| /linux/arch/arm/boot/dts/nvidia/ |
| H A D | tegra124-venice2.dts | 422 ph0 {
423 nvidia,pins = "ph0";
|
| H A D | tegra124-nyan-blaze.dts | 227 ph0 {
228 nvidia,pins = "ph0";
|
| H A D | tegra124-nyan-big.dts | 225 ph0 {
226 nvidia,pins = "ph0";
|
| H A D | tegra124-jetson-tk1.dts | 277 ph0 {
278 nvidia,pins = "ph0";
|
| H A D | tegra124-apalis-v1.2.dtsi | 420 ph0 {
421 nvidia,pins = "ph0";
|
| H A D | tegra124-apalis.dtsi | 417 ph0 {
418 nvidia,pins = "ph0";
|
| /linux/drivers/pinctrl/renesas/ |
| H A D | pfc-shx3.c | 361 PINMUX_GPIO(PH0),
|
| H A D | pfc-sh7786.c | 474 PINMUX_GPIO(PH0),
|
| /linux/drivers/pinctrl/tegra/ |
| H A D | pinctrl-tegra124.c | 261 PINCTRL_PIN(TEGRA_PIN_PH0, "PH0"),
1875 …PINGROUP(ph0, PWM0, TRACE, GMI, DTV, 0x3210, N, N…
|