Home
last modified time | relevance | path

Searched full:latched (Results 1 – 25 of 125) sorted by relevance

12345

/linux/Documentation/devicetree/bindings/gpio/
H A Dgpio-latch.yaml42 The number of clk-gpios and latched-gpios is not fixed. The actual number
55 latched-gpios:
74 - latched-gpios
90 latched-gpios = <&gpio3 21 0>, <&gpio3 22 0>,
/linux/sound/soc/codecs/
H A Dtas2764.c79 u8 latched[6] = {0, 0, 0, 0, 0, 0}; in tas2764_irq() local
83 for (i = 0; i < ARRAY_SIZE(latched); i++) in tas2764_irq()
84 latched[i] = snd_soc_component_read(tas2764->component, in tas2764_irq()
88 if (latched[0] & BIT(i)) { in tas2764_irq()
95 if (latched[0]) { in tas2764_irq()
97 latched[1], latched[2], latched[3], latched[4], latched[ in tas2764_irq()
[all...]
H A Dtas2770.h107 /* Latched-Interrupt Reg0 */
111 /* Latched-Interrupt Reg1 */
H A Dtas2764.h112 /* Latched Fault Registers */
/linux/Documentation/ABI/testing/
H A Ddebugfs-vfio44 Description: Read the nointxmask policy latched for this device. This
53 Description: Read the disable_idle_d3 policy latched for this device. This
/linux/drivers/net/ethernet/broadcom/bnx2x/
H A Dbnx2x_init.h639 /* [28] MCP Latched rom_parity
640 * [29] MCP Latched ump_rx_parity
641 * [30] MCP Latched ump_tx_parity
642 * [31] MCP Latched scpad_parity
761 * [7] clears Latched rom_parity in bnx2x_clear_blocks_parity()
762 * [8] clears Latched ump_rx_parity in bnx2x_clear_blocks_parity()
763 * [9] clears Latched ump_tx_parity in bnx2x_clear_blocks_parity()
764 * [10] clears Latched scpad_parity (both ports) in bnx2x_clear_blocks_parity()
H A Dbnx2x_reg.h1125 interrupt; [21] RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN
1126 Latched attn; [24] RBCU Latched attn; [25] RBCP Latched attn; [26] GRC
1127 Latched timeout attention; [27] GRC Latched reserved access attention;
1128 [28] MCP Latched rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP
1129 Latched ump_tx_parity; [31] MCP Latched scpad_parity; */
1139 RBCR Latched attn; [22] RBCT Latched attn; [23] RBCN Latched attn; [24]
1140 RBCU Latched attn; [25] RBCP Latched attn; [26] GRC Latched timeout
1141 attention; [27] GRC Latched reserved access attention; [28] MCP Latched
1142 rom_parity; [29] MCP Latched ump_rx_parity; [30] MCP Latched
1143 ump_tx_parity; [31] MCP Latched scpad_parity; */
[all …]
/linux/drivers/net/ethernet/mellanox/mlxbf_gige/
H A Dmlxbf_gige_intr.c27 /* This error condition is latched into MLXBF_GIGE_INT_STATUS in mlxbf_gige_error_intr()
40 * sent. The "tx_small_frame" condition is latched into the in mlxbf_gige_error_intr()
/linux/Documentation/devicetree/bindings/iio/magnetometer/
H A Dti,tmag5273.yaml50 The low active interrupt can be configured to be fixed width or latched.
/linux/drivers/irqchip/
H A Dirq-sni-exiu.c52 * Level triggered interrupts are latched and must be cleared during in exiu_irq_eoi()
88 /* clear interrupts that were latched while disabled */ in exiu_irq_enable()
/linux/Documentation/virt/kvm/devices/
H A Darm-vgic-v3.rst154 GICR_ISPENDR0 registers get/set the value of the latched pending state for
161 to ISPENDR) this state is "latched", and only cleared when either the
165 ISPENDR writes are latched; if the device lowers the line level then the
/linux/drivers/iio/gyro/
H A Dmpu3050.h58 * @irq_latch: latched IRQ, this means that it is a level IRQ
/linux/drivers/staging/greybus/
H A Daudio_apbridgea.h17 * - RX data is received/latched on the rising edge of BCLK
/linux/kernel/module/
H A Dtree_lookup.c14 * Use a latched RB-tree for __module_address(); this allows us to use
/linux/drivers/scsi/aic7xxx/
H A Daic79xx_pci.c486 /* Silently clear any latched errors. */ in ahd_pci_test_register_access()
807 /* Clear latched errors. So our interrupt deasserts. */ in ahd_pci_intr()
863 /* Clear latched errors. So our interrupt deasserts. */ in ahd_pci_split_intr()
870 /* Clear latched errors. So our interrupt deasserts. */ in ahd_pci_split_intr()
/linux/tools/power/cpupower/debug/kernel/
H A Dcpufreq-test_tsc.c40 * source is not latched, so you must read it multiple in read_pmtmr()
/linux/drivers/net/ethernet/aquantia/atlantic/
H A Daq_hw_utils.c58 Counters are normally implemented by HW as latched pairs:
/linux/arch/arm/mach-versatile/
H A Dintegrator_cp.c65 * clear the latched interrupt.
/linux/drivers/pci/
H A Dvc.c47 * Status clears, hardware has latched the table into VC arbitration logic.
71 * Status clears, hardware has latched the table into port arbitration logic.
/linux/drivers/gpu/drm/msm/disp/mdp4/
H A Dmdp4_dsi_encoder.c94 * Wait for a vsync so we know the ENABLE=0 latched before in mdp4_dsi_encoder_disable()
H A Dmdp4_dtv_encoder.c97 * Wait for a vsync so we know the ENABLE=0 latched before in mdp4_dtv_encoder_disable()
/linux/arch/powerpc/sysdev/xics/
H A Dicp-opal.c50 /* Handle an interrupt latched by KVM first */ in icp_opal_get_xirr()
/linux/Documentation/devicetree/bindings/iio/resolver/
H A Dadi,ad2s1210.yaml23 selected by the A0 and A1 input pins. In normal mode, data is latched by
/linux/drivers/regulator/
H A Draa215300.c89 /* Clear the latched registers */ in raa215300_i2c_probe()
/linux/drivers/gpu/drm/i915/display/
H A Dintel_vrr.c153 * Without VRR registers get latched at:
156 * With VRR the earliest registers can get latched is:
160 * The latest point registers can get latched is the vmax decision boundary:
164 * latched) ASAP after a push is sent.

12345