Home
last modified time | relevance | path

Searched +full:da9063 +full:- +full:onkey (Results 1 – 16 of 16) sorted by relevance

/linux/drivers/input/misc/
H A Dda9063_onkey.c1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * OnKey device driver for DA9063, DA9062 and DA9061 PMICs
7 #include <linux/devm-helpers.h>
18 #include <linux/mfd/da9063/core.h>
19 #include <linux/mfd/da9063/registers.h>
75 .name = "da9062-onkey",
80 struct da9063_onkey *onkey = container_of(work, in da9063_poll_on() local
83 const struct da906x_chip_config *config = onkey->config; in da9063_poll_on()
90 error = regmap_read(onkey->regmap, in da9063_poll_on()
91 config->onkey_status, in da9063_poll_on()
[all …]
H A DKconfig1 # SPDX-License-Identifier: GPL-2.0-only
17 tristate "88PM860x ONKEY support"
20 Support the ONKEY of Marvell 88PM860x PMICs as an input device
27 tristate "88PM80x ONKEY support"
30 Support the ONKEY of Marvell 88PM80x PMICs as an input device
37 tristate "Marvell 88PM886 onkey support"
40 Support the onkey of Marvell 88PM886 PMIC as an input device
47 Say Y here to use the PowerOn Key for ST-Ericsson's AB8500
48 Mix-Sig PMIC.
51 will be called ab8500-ponkey.
[all …]
/linux/Documentation/devicetree/bindings/mfd/
H A Ddlg,da9063.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mfd/dlg,da9063.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Steve Twiss <stwiss.opensource@diasemi.com>
13 For device-tree bindings of other sub-modules refer to the binding documents
14 under the respective sub-system directories.
15 Using regulator-{uv,ov}-{warn,error,protection}-microvolt requires special
17 moment where all voltage monitors are disabled. Next, as da9063 only supports
21 - https://www.dialog-semiconductor.com/products/da9063l
[all …]
/linux/Documentation/devicetree/bindings/input/
H A Ddlg,da9062-onkey.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/input/dlg,da9062-onkey.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Dialog DA9061/62/63 OnKey Module
10 - Biju Das <biju.das.jz@bp.renesas.com>
13 This module is part of the DA9061/DA9062/DA9063. For more details about entire
14 DA906{1,2,3} chips see Documentation/devicetree/bindings/mfd/dlg,da9063.yaml
21 - enum:
22 - dlg,da9062-onkey
[all …]
/linux/drivers/mfd/
H A Dda9063-core.c1 // SPDX-License-Identifier: GPL-2.0+
3 * Device access for Dialog DA9063 modules
24 #include <linux/mfd/da9063/core.h>
25 #include <linux/mfd/da9063/registers.h>
58 .name = "ONKEY",
85 .of_compatible = "dlg,da9063-watchdog",
96 .of_compatible = "dlg,da9063-onkey",
103 /* Only present on DA9063 , not on DA9063L */
109 .of_compatible = "dlg,da9063-rtc",
113 static int da9063_clear_fault_log(struct da9063 *da9063) in da9063_clear_fault_log() argument
[all …]
H A DKconfig1 # SPDX-License-Identifier: GPL-2.0-only
57 tristate "Active-semi ACT8945A"
62 Support for the ACT8945A PMIC from Active-semi. This device
63 features three step-down DC/DC converters and four low-dropout
79 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
82 called sun4i-gpadc.
113 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
144 over at91-usart-serial driver and usart-spi-driver. Only one function
160 tristate "Atmel HLCDC (High-end LCD Controller)"
197 tristate "X-Powers AC100"
[all …]
/linux/include/linux/mfd/da9063/
H A Dcore.h1 /* SPDX-License-Identifier: GPL-2.0+ */
3 * Definitions for DA9063 MFD driver
15 #include <linux/mfd/da9063/registers.h>
17 /* DA9063 modules */
18 #define DA9063_DRVNAME_CORE "da9063-core"
19 #define DA9063_DRVNAME_REGULATORS "da9063-regulators"
20 #define DA9063_DRVNAME_LEDS "da9063-leds"
21 #define DA9063_DRVNAME_WATCHDOG "da9063-watchdog"
22 #define DA9063_DRVNAME_HWMON "da9063-hwmon"
23 #define DA9063_DRVNAME_ONKEY "da9063-onkey"
[all …]
/linux/arch/riscv/boot/dts/sifive/
H A Dhifive-unmatched-a00.dts1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
4 #include "fu740-c000.dtsi"
5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/interrupt-controller/irq.h>
7 #include <dt-bindings/leds/common.h>
8 #include <dt-bindings/pwm/pwm.h>
15 compatible = "sifive,hifive-unmatched-a00", "sifive,fu740-c000",
19 stdout-path = "serial0";
23 timebase-frequency = <RTCCLK_FREQ>;
32 #clock-cells = <0>;
[all …]
/linux/arch/arm/boot/dts/renesas/
H A Dr8a7790-stout.dts1 // SPDX-License-Identifier: GPL-2.0
8 /dts-v1/;
10 #include <dt-bindings/gpio/gpio.h>
11 #include <dt-bindings/input/input.h>
23 stdout-path = "serial0:115200n8";
32 compatible = "gpio-leds";
47 fixedregulator1v8: regulator-1v8 {
48 compatible = "regulator-fixed";
49 regulator-name = "fixed-1.8V";
50 regulator-min-microvolt = <1800000>;
[all …]
H A Dr8a7794-silk.dts1 // SPDX-License-Identifier: GPL-2.0
6 * Copyright (C) 2014-2015 Renesas Solutions Corp.
7 * Copyright (C) 2014-2015 Cogent Embedded, Inc.
11 * SSI-AK4643
13 * SW1: 2-1: AK4643
14 * 2-3: ADV7511
21 /dts-v1/;
23 #include <dt-bindings/gpio/gpio.h>
24 #include <dt-bindings/input/input.h>
40 stdout-path = "serial0:115200n8";
[all …]
/linux/arch/arm/boot/dts/nxp/imx/
H A Dimx6qdl-phytec-pfla02.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later
6 #include <dt-bindings/gpio/gpio.h>
9 model = "Phytec phyFLEX-i.MX6 Quad";
10 compatible = "phytec,imx6q-pfla02", "fsl,imx6q";
17 reg_usb_otg_vbus: regulator-usb-otg-vbus {
18 compatible = "regulator-fixed";
19 regulator-name = "usb_otg_vbus";
20 regulator-min-microvolt = <5000000>;
21 regulator-max-microvolt = <5000000>;
23 enable-active-high;
[all …]
H A Dimx6qdl-emcon.dtsi1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
6 #include <dt-bindings/gpio/gpio.h>
7 #include <dt-bindings/pwm/pwm.h>
8 #include <dt-bindings/input/input.h>
12 model = "emtrion SoM emCON-MX6";
13 compatible = "emtrion,emcon-mx6";
23 stdout-path = &uart1;
31 gpio-keys {
32 compatible = "gpio-keys";
33 pinctrl-names = "default";
[all …]
H A Dimx6ull-dhcor-som.dtsi1 // SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
6 #include <dt-bindings/clock/imx6ul-clock.h>
7 #include <dt-bindings/gpio/gpio.h>
8 #include <dt-bindings/input/input.h>
9 #include <dt-bindings/leds/common.h>
10 #include <dt-bindings/pwm/pwm.h>
11 #include <dt-bindings/regulator/dlg,da9063-regulator.h>
16 /delete-property/ mmc0;
17 /delete-property/ mmc1;
21 /* Appropriate memory size will be filled by U-Boot */
[all …]
H A Dimx6qdl-phytec-phycore-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
7 #include <dt-bindings/gpio/gpio.h>
8 #include <dt-bindings/regulator/dlg,da9063-regulator.h>
26 compatible = "gpio-leds";
27 pinctrl-names = "default";
28 pinctrl-0 = <&pinctrl_gpioleds_som>;
30 som-led-green {
33 linux,default-trigger = "heartbeat";
39 pinctrl-names = "default";
40 pinctrl-0 = <&pinctrl_ecspi1>;
[all …]
H A Dimx6q-ba16.dtsi2 * Support for imx6 based Advantech DMS-BA16 Qseven module
7 * This file is dual-licensed: you can use it either under the terms
46 #include <dt-bindings/gpio/gpio.h>
55 compatible = "pwm-backlight";
56 pinctrl-names = "default";
57 pinctrl-0 = <&pinctrl_display>;
59 brightness-levels = < 0 1 2 3 4 5 6 7 8 9
85 default-brightness-level = <255>;
86 enable-gpios = <&gpio1 0 GPIO_ACTIVE_HIGH>;
89 reg_1p8v: regulator-1p8v {
[all …]
/linux/
H A DMAINTAINERS5 ---------------------------------------------------
21 W: *Web-page* with status/info
23 B: URI for where to file *bugs*. A web-page with detailed bug
28 patches to the given subsystem. This is either an in-tree file,
29 or a URI. See Documentation/maintainer/maintainer-entry-profile.rst
46 N: [^a-z]tegra all files whose path contains tegra
64 ----------------
83 3WARE SAS/SATA-RAID SCSI DRIVERS (3W-XXXX, 3W-9XXX, 3W-SAS)
85 L: linux-scsi@vger.kernel.org
88 F: drivers/scsi/3w-*
[all …]