Home
last modified time | relevance | path

Searched +full:coexist +full:- +full:gpio +full:- +full:pin (Results 1 – 6 of 6) sorted by relevance

/linux/Documentation/devicetree/bindings/net/wireless/
H A Dqcom,ath10k.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Kalle Valo <kvalo@kernel.org>
11 - Jeff Johnson <jjohnson@kernel.org>
19 - qcom,ath10k # SDIO-based devices
20 - qcom,ipq4019-wifi
21 - qcom,wcn3990-wifi # SNoC-based devices
26 reg-names:
28 - const: membase
[all …]
/linux/include/linux/ssb/
H A Dssb_regs.h1 /* SPDX-License-Identifier: GPL-2.0 */
33 #define SSB_MAX_NR_CORES ((SSB_ENUM_LIMIT - SSB_ENUM_BASE) / SSB_CORE_SIZE)
51 #define SSB_GPIO_IN 0xB0 /* GPIO Input (pcirev >= 3 only) */
52 #define SSB_GPIO_OUT 0xB4 /* GPIO Output (pcirev >= 3 only) */
53 #define SSB_GPIO_OUT_ENABLE 0xB8 /* GPIO Output Enable/Disable (pcirev >= 3 only) */
55 #define SSB_GPIO_HWRAD 0x20 /* PCI config space GPIO 13 for hw radio disable */
56 #define SSB_GPIO_XTAL 0x40 /* PCI config space GPIO 14 for Xtal powerup */
57 #define SSB_GPIO_PLL 0x80 /* PCI config space GPIO 15 for PLL powerdown */
108 #define SSB_TMSHIGH_SERR 0x00000001 /* S-error */
168 * in two-byte quantities.
[all …]
/linux/include/sound/
H A Dhda_verbs.h1 /* SPDX-License-Identifier: GPL-2.0 */
3 * HD-audio codec verbs
30 AC_WID_PIN, /* Pin Complex */
59 /* f10-f1a: GPIO */
162 #define AC_WCAP_IN_AMP (1<<1) /* AMP-in present */
163 #define AC_WCAP_OUT_AMP (1<<2) /* AMP-out present */
164 #define AC_WCAP_AMP_OVRD (1<<3) /* AMP-parameter override */
251 /* Pin widget capabilies */
264 * in HD-audio specification
266 #define AC_PINCAP_HDMI (1<<7) /* HDMI pin */
[all …]
/linux/drivers/tty/serial/
H A Datmel_serial.c1 // SPDX-License-Identifier: GPL-2.0+
18 #include <linux/clk-provider.h>
24 #include <linux/dma-mapping.h>
62 /* Use device name ttyAT, major 204 and minor 154-169. This is necessary if we
63 * should coexist with the 8250 driver, such as if we have an external 16C550
71 /* Use device name ttyS, major 4, minor 64-68. This is the usual serial port
167 bool hd_start_rx; /* can start RX during half-duplex operation */
197 { .compatible = "atmel,at91rm9200-usart-serial" },
210 return __raw_readl(port->membase + reg); in atmel_uart_readl()
215 __raw_writel(value, port->membase + reg); in atmel_uart_writel()
[all …]
/linux/drivers/net/wireless/ath/ath10k/
H A Dcore.c1 // SPDX-License-Identifier: ISC
3 * Copyright (c) 2005-2011 Atheros Communications Inc.
4 * Copyright (c) 2011-2017 Qualcomm Atheros, Inc.
5 * Copyright (c) 2018-2019, The Linux Foundation. All rights reserved.
6 * Copyright (c) 2021-2024 Qualcomm Innovation Center, Inc. All rights reserved.
16 #include <linux/nvmem-consumer.h>
28 #include "wmi-ops.h"
58 MODULE_PARM_DESC(cryptmode, "Crypto mode: 0-hardware, 1-software");
474 * or 2x2 160Mhz, long-guard-interval.
525 * 1x1 160Mhz, long-guard-interval.
[all …]
/linux/drivers/spi/
H A Dspi.c1 // SPDX-License-Identifier: GPL-2.0-or-later
9 #include <linux/clk/clk-conf.h>
13 #include <linux/dma-mapping.h>
15 #include <linux/gpio/consumer.h>
35 #include <linux/spi/spi-mem.h>
51 spi_controller_put(spi->controller); in spidev_release()
52 kfree(spi->driver_override); in spidev_release()
53 free_percpu(spi->pcpu_statistics); in spidev_release()
63 len = acpi_device_modalias(dev, buf, PAGE_SIZE - 1); in modalias_show()
64 if (len != -ENODEV) in modalias_show()
[all …]