Searched full:breathing (Results 1 – 15 of 15) sorted by relevance
12 The only supported pattern is hardware breathing mode::29 breathing frequencies of 1/4, 1/2, 1 and 2 Hz.33 while breathing by writing the brightness attribute.37 while blinking. Breathing on this hw really is just a variant
13 high time, fall time and low time for the breathing mode.15 For the breathing mode, the SC27XX LED only expects one brightness
15 Breathing mode for Screen frame light tube::
13 2 breathing18 Breathing: LEDs brightness varies at human breathing rate
7 title: Spreadtrum SC2731 PMIC breathing light controller15 The SC2731 breathing light controller supports up to 3 outputs:
13 encoded with symbol 'S' (hex code 0x53). Supports blinking breathing pattern.
15 for auto breathing or group dimming control. Supported devices:
19 /* Breathing light controller register definition */184 * time and low time to enable the breathing mode. in sc27xx_led_pattern_set()228 /* Enable the LED breathing mode */ in sc27xx_led_pattern_set()352 MODULE_DESCRIPTION("Spreadtrum SC27xx breathing light controller driver");
40 * | '2' 0x32 | Cascade | Breathing |150 dev_dbg(led->priv->dev, "Breathing mode for 0x%02x(%c)", in el15203000_pattern_set_S()
164 /* reset detention time (no "breathing" effect). */ in an30259a_blink_set()
21 * GT683R_LED_BREATHING: LEDs brightness varies at human breathing rate
488 - Breathing: LEDs brightness varies at human breathing rate
81 * "breathing"/pulsing effect until the power is fully
491 default value is to add a 50% breathing room
1363 * Give ourselves some breathing room. in mpt_register_lan_device()