| /linux/include/linux/regulator/ |
| H A D | max8973-regulator.h | 18 * Client need to pass this information with ORed
41 * @control_flags: Control flags which are ORed value of above flags to
|
| /linux/Documentation/devicetree/bindings/powerpc/fsl/ |
| H A D | pmc.txt | 44 which will be ORed into PMCDR upon suspend, and cleared from PMCDR
50 first of which will be ORed into DEVDISR (and the second into
|
| /linux/drivers/media/i2c/ |
| H A D | tea6420.h | 19 /* gain on the output pins, ORed with the output pin */
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-driver-intel-rapid-start | 10 These values are ORed together. For example, a value of 3
|
| /linux/Documentation/devicetree/bindings/net/ |
| H A D | broadcom-bcm87xx.txt | 12 with the existing register value, and the fourth cell is ORed with
|
| /linux/arch/xtensa/include/asm/ |
| H A D | mxregs.h | 21 * 01pp 0...0d..d 16 bits (d) 'ored' as single IPI to processor p
|
| /linux/sound/soc/fsl/ |
| H A D | mpc5200_dma.h | 46 * @sicr: Base value used in serial interface control register; mode is ORed
|
| /linux/security/landlock/ |
| H A D | access.h | 22 * by a ruleset/layer. This must be ORed with all ruleset->access_masks[]
|
| /linux/Documentation/devicetree/bindings/soc/fsl/cpm_qe/ |
| H A D | cpm.txt | 24 - fsl,cpm-command : This value is ORed with the opcode and command flag
|
| /linux/sound/soc/codecs/ |
| H A D | idt821034.c | 115 /* Power values that can be used in 'power' (can be ORed) */
158 /* Codec configuration values that can be used in 'codec_conf' (can be ORed) */
204 /* Channel direction values that can be used in 'ch_dir' (can be ORed) */
241 /* SLIC direction values that can be used in 'slic_dir' (can be ORed) */
328 /* Gain type values that can be used in 'gain_type' (cannot be ORed) */
|
| /linux/arch/powerpc/include/asm/ |
| H A D | pmac_low_i2c.h | 59 * direction can be directly ored in
|
| /linux/include/soc/fsl/qe/ |
| H A D | qmc.h | 93 /* Flags available (ORed) for read complete() flags parameter in HDLC mode.
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | vidioc-dqevent.rst | 148 second-oldest event is ORed with the ``changes`` field of the
178 ORed value of all the events generated.
|
| H A D | vidioc-queryctrl.rst | 111 :ref:`control-id` for predefined IDs. When the ID is ORed with
189 :ref:`control-id` for predefined IDs. When the ID is ORed with
192 ID is ORed with ``V4L2_CTRL_FLAG_NEXT_COMPOUND`` the driver clears
|
| /linux/drivers/media/pci/cx18/ |
| H A D | cx18-av-core.h | 30 /* S-Video inputs consist of one luma input (In1-In8) ORed with one
52 /* Component Video inputs consist of one luma input (In1-In8) ORed
|
| /linux/include/media/ |
| H A D | cec-pin.h | 69 * @caps: capabilities of the CEC adapter. This will be ORed with
|
| /linux/drivers/clk/qcom/ |
| H A D | clk-branch.h | 16 * @hwcg_bit: ORed with @hwcg_reg to enable dynamic hardware clock gating
|
| /linux/Documentation/devicetree/bindings/interrupt-controller/ |
| H A D | apple,aic2.yaml | 21 - Software triggering (ORed with hw line)
|
| H A D | apple,aic.yaml | 23 - Software triggering (ORed with hw line)
|
| /linux/drivers/net/phy/ |
| H A D | bcm87xx.c | 31 * value: ORed with the masked value and written to the regiser.
|
| /linux/Documentation/devicetree/bindings/mailbox/ |
| H A D | arm,mhu.yaml | 22 interrupt signal using a 32-bit register, with all 32-bits logically ORed
|
| /linux/tools/include/uapi/linux/ |
| H A D | sched.h | |
| /linux/net/rds/ |
| H A D | page.c | 55 * @gfp is always ored with __GFP_HIGHMEM. Callers must be prepared to
|
| /linux/include/uapi/linux/ |
| H A D | sched.h | 123 /* Can be ORed in to make sure the process is reverted back to SCHED_NORMAL on fork */
|
| /linux/tools/perf/trace/beauty/include/uapi/linux/ |
| H A D | sched.h | 123 /* Can be ORed in to make sure the process is reverted back to SCHED_NORMAL on fork */
|