Home
last modified time | relevance | path

Searched +full:5 +full:vout (Results 1 – 25 of 25) sorted by relevance

/freebsd/sys/contrib/device-tree/src/arm/aspeed/
H A Daspeed-bmc-ibm-sbp1.dts587 gpios = <&smb_svc_pex_rssd01_16 5 GPIO_ACTIVE_LOW>;
683 gpios = <&smb_svc_pex_rssd17_32 5 GPIO_ACTIVE_LOW>;
842 io-channels = <&adc1 5>;
963 io-channels = <&adc0 5>;
1004 vout-supply = <&p12v_a>;
1009 vout-supply = <&p12v_b>;
1014 vout-supply = <&p12v_c>;
1019 vout-supply = <&p12v_d>;
1024 vout-supply = <&pvccinfaon_cpu0>;
1029 vout-supply = <&pvccfa_ehv_cpu0>;
[all …]
H A Daspeed-bmc-delta-ahe50dc.dts10 vout-supply = <&efuse##n>; \
21 efuse##num: vout { \
75 <&adc 5>, <&adc 6>, <&adc 7>, <&adc 8>, <&adc 9>;
258 /* lm25066 efuses @ 10-17, 40-47, 50-57, 59, 5a */
284 EFUSE(5a, 50);
/freebsd/sys/contrib/device-tree/Bindings/leds/
H A Dleds-lp55xx.yaml60 - 1 # D1~6 with VDD, D7~9 with VOUT
61 - 2 # D1~6 with VOUT, D7~9 with VDD
62 - 3 # D1~9 are connected to VOUT
146 - 5 # LED output D6
186 pwr-sel = /bits/ 8 <3>; /* D1~9 connected to VOUT */
224 led@5 {
225 reg = <5>;
/freebsd/sys/contrib/device-tree/Bindings/iio/addac/
H A Dadi,ad74115.yaml65 5 - Current input, loop-powered
196 either source or sink for VOUT and 4mA sink for IOUT.
197 When present, the limit is 16mA in either source or sink for VOUT,
270 5 - Monitor HART EOM status
272 maximum: 5
284 5 - Monitor HART SOM status
286 maximum: 5
298 5 - Monitor HART TX complete status
300 maximum: 5
312 5
[all...]
/freebsd/sys/contrib/device-tree/Bindings/iio/afe/
H A Dtemperature-sense-rtd.yaml29 5V0
33 | R 5k |
38 +---- Vout
97 excitation-current-microamp = <1000>; /* i = U/R = 5 / 5000 */
/freebsd/sys/contrib/device-tree/src/arm/st/
H A Dstm32mp15xc-lxa-tac.dtsi103 reg_5v: regulator-5v {
105 regulator-name = "5V";
121 reg_pb_5v: regulator-pb-5v {
123 regulator-name = "5V_POWERBOARD";
141 vout-supply = <&reg_iobus_12v>;
146 vout-supply = <&v3v3_hdmi>;
194 "", "USB_RESET", "", "", "", /* 5 */
201 "TP39", "", "", "TP41", "TP42", /* 5 */
208 "", "", "", "", "", /* 5 */
215 "", "", "", "", "", /* 5 */
[all …]
/freebsd/sys/contrib/device-tree/Bindings/gpio/
H A Dgpio-max3191x.txt40 through 5VOUT instead of VCC24V, in which case they
H A Dmaxim,max31910.yaml68 the chips are powered through 5VOUT instead of VCC24V, in which case they
/freebsd/sys/contrib/device-tree/Bindings/hwmon/
H A Dlltc,ltc2978.yaml70 "^vout[0-7]$":
89 regulator@5e {
/freebsd/sys/contrib/device-tree/src/arm64/ti/
H A Dk3-am65-iot2050-common.dtsi128 led-5 {
342 AM65X_IOPAD(0x0074, PIN_INPUT, 5) /* (T27) I2C2_SCL */
343 AM65X_IOPAD(0x0070, PIN_INPUT, 5) /* (R25) I2C2_SDA */
426 regulator-name = "tps62363-vout";
432 ti,enable-vout-discharge;
H A Dk3-am654-base-board.dts90 switch-5 {
262 AM65X_IOPAD(0x0074, PIN_INPUT, 5) /* (T27) GPMC0_CSn3.I2C2_SCL */
263 AM65X_IOPAD(0x0070, PIN_INPUT, 5) /* (R25) GPMC0_CSn2.I2C2_SDA */
380 ti,enable-vout-discharge;
505 ti,adc-channels = <0 1 2 3 4 5 6 7>;
512 ti,adc-channels = <0 1 2 3 4 5 6 7>;
H A Dk3-am62-verdin.dtsi123 /* Enabled by +V2.5_ETH */
132 /* Enabled by +V2.5_ETH */
261 pinctrl_qspi1_io2_gpio: main-gpio0-5-default-pins {
675 AM62X_IOPAD(0x01f0, PIN_OUTPUT_PULLUP, 5) /* (A18) EXT_REFCLK1.CLKOUT0 */
707 AM62X_IOPAD(0x0008, PIN_INPUT_PULLUP, 5) /* (J24) OSPI0_DQS.UART5_CTSn */ /* WiFi_UART_CTS */
708 AM62X_IOPAD(0x0004, PIN_OUTPUT, 5) /* (G25) OSPI0_LBCLKO.UART5_RTSn */ /* WiFi_UART_RTS */
709 AM62X_IOPAD(0x0034, PIN_INPUT_PULLUP, 5) /* (H21) OSPI0_CSn2.UART5_RXD */ /* WiFi_UART_RXD */
710 AM62X_IOPAD(0x0038, PIN_OUTPUT, 5) /* (E24) OSPI0_CSn3.UART5_TXD */ /* WiFi_UART_TXD */
722 pinctrl_parallel_rgb: main-vout-default-pins {
1212 regulator-name = "+V2.5_ETH (PMIC LDO4)";
[all …]
/freebsd/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx8mp-tx8p-ml81-moduline-display-106.dts36 vout-supply = <&reg_5v0_sensor>;
60 reg_5v0: regulator-5v0 {
66 regulator-name = "5v0";
69 reg_5v0_sensor: regulator-5v0-sensor {
75 regulator-name = "5v0-supply-external-sensor";
148 interrupts = <5 IRQ_TYPE_EDGE_FALLING>;
364 pinctrl_reg_5v0_sensor: reg-5v0-sensorgrp {
/freebsd/sys/contrib/device-tree/src/arm/ti/keystone/
H A Dkeystone-k2g-evm.dts243 vout_pins: vout-pins {
403 cdns,read-delay = <5>;
429 partition@5 {
/freebsd/sys/contrib/device-tree/src/arm/nvidia/
H A Dtegra30-asus-transformer-common.dtsi1182 interrupts = <TEGRA_GPIO(O, 5) IRQ_TYPE_EDGE_RISING>;
1340 regulator-name = "tps62361-vout";
1348 ti,enable-vout-discharge;
1399 cd-gpios = <&gpio TEGRA_GPIO(I, 5) GPIO_ACTIVE_LOW>;
1474 gpios = <&gpio TEGRA_GPIO(H, 5) GPIO_ACTIVE_HIGH>;
1596 vdd_5v0_sys: regulator-5v {
H A Dtegra30-cardhu.dtsi363 regulator-name = "tps62361-vout";
410 cd-gpios = <&gpio TEGRA_GPIO(I, 5) GPIO_ACTIVE_LOW>;
529 cp_5v_reg: regulator-5v0cp {
H A Dtegra30-colibri.dtsi895 /* 5 ms touch detect interrupt delay */
896 st,touch-det-delay = <5>;
914 regulator-name = "tps62362-vout";
1011 reg_5v0_charge_pump: regulator-5v0-charge-pump {
H A Dtegra30-asus-p1801-t.dts1139 interrupts = <TEGRA_GPIO(O, 5) IRQ_TYPE_EDGE_RISING>;
1309 regulator-name = "tps62361-vout";
1317 ti,enable-vout-discharge;
1346 vdd_5v0_sys: regulator-5v {
1743 cd-gpios = <&gpio TEGRA_GPIO(I, 5) GPIO_ACTIVE_LOW>;
H A Dtegra30-apalis-v1.1.dtsi1031 /* 5 ms touch detect interrupt delay */
1032 st,touch-det-delay = <5>;
1050 regulator-name = "tps62362-vout";
1159 reg_5v0_charge_pump: regulator-5v0-charge-pump {
H A Dtegra30-apalis.dtsi1014 /* 5 ms touch detect interrupt delay */
1015 st,touch-det-delay = <5>;
1033 regulator-name = "tps62362-vout";
1142 reg_5v0_charge_pump: regulator-5v0-charge-pump {
H A Dtegra30-pegatron-chagall.dts1071 nvidia,pull-down-strength = <5>;
1072 nvidia,pull-up-strength = <5>;
1415 interrupts = <TEGRA_GPIO(U, 5) IRQ_TYPE_EDGE_FALLING>;
1425 regulator-name = "tps62361-vout";
1433 ti,enable-vout-discharge;
1441 vdd_5v0_sys: regulator-5v {
1475 gpio = <&gpio TEGRA_GPIO(K, 5) GPIO_ACTIVE_HIGH>;
2520 cd-gpios = <&gpio TEGRA_GPIO(I, 5) GPIO_ACTIVE_LOW>;
2662 vsync-len = <5>;
H A Dtegra30-asus-tf600t.dts1057 interrupts = <TEGRA_GPIO(D, 5) IRQ_TYPE_EDGE_RISING>;
1238 regulator-name = "tps62361-vout";
1246 ti,enable-vout-discharge;
2067 cd-gpios = <&gpio TEGRA_GPIO(I, 5) GPIO_ACTIVE_LOW>;
2303 vdd_5v0_sys: regulator-5v {
2356 gpio = <&gpio TEGRA_GPIO(L, 5) GPIO_ACTIVE_HIGH>;
H A Dtegra30-beaver.dts1885 regulator-name = "tps62361-vout";
1933 cd-gpios = <&gpio TEGRA_GPIO(I, 5) GPIO_ACTIVE_LOW>;
2014 vdd_5v_in_reg: regulator-5v0 {
H A Dtegra30-ouya.dts2189 ti,enable-vout-discharge;
4727 vdd_5v0_reg: regulator-vdd-5v0 {
4743 gpio = <&gpio TEGRA_GPIO(DD, 5) GPIO_ACTIVE_HIGH>;
/freebsd/sys/contrib/device-tree/src/arm64/rockchip/
H A Drk3399-pinebook-pro.dts213 /* 5 V USB power supply */
337 vbus_5vout: vbus_typec: regulator-vbus-5vout {
877 pwr_5v_pin: pwr-5v-pin {