Home
last modified time | relevance | path

Searched +full:50 +full:ohm (Results 1 – 25 of 46) sorted by relevance

12

/freebsd/sys/contrib/device-tree/Bindings/phy/
H A Drockchip,rk3399-emmc-phy.yaml25 drive-impedance-ohm:
28 Specifies the drive impedance in Ohm.
29 enum: [33, 40, 50, 66, 100]
30 default: 50
62 drive-impedance-ohm = <50>;
H A Drockchip-emmc-phy.txt16 - drive-impedance-ohm: Specifies the drive impedance in Ohm.
17 Possible values are 33, 40, 50, 66 and 100.
18 If not set, the default value of 50 will be applied.
40 drive-impedance-ohm = <50>;
/freebsd/sys/contrib/device-tree/Bindings/iio/potentiostat/
H A Dlmp91000.txt14 - ti,external-tia-resistor: if the property ti,tia-gain-ohm is not defined this
19 - ti,tia-gain-ohm: ohm value of the internal resistor for the transimpedance
22 - ti,rload-ohm: ohm value of the internal resistor load applied to the gas
23 sensor. Must be 10, 33, 50, or 100 (default) ohms.
30 ti,tia-gain-ohm = <7500>;
H A Dti,lmp91000.yaml32 If the property ti,tia-gain-ohm is not defined this needs to be set to
35 ti,tia-gain-ohm:
41 ti,rload-ohm:
43 enum: [10, 33, 50, 100]
63 ti,tia-gain-ohm = <7000>;
64 ti,rload-ohm = <100>;
/freebsd/sys/contrib/device-tree/Bindings/display/bridge/
H A Danalogix,anx7625.yaml69 adjust 50ohm impedance of DP tx termination. 00:55 ohm,
70 01:50 ohm(default), 10:45 ohm, 11:40 ohm.
/freebsd/sys/contrib/device-tree/src/arm64/rockchip/
H A Drk3399-gru-kevin.dts71 pullup-ohm = <25500>;
72 pulldown-ohm = <0>;
80 pullup-ohm = <25500>;
81 pulldown-ohm = <0>;
186 i2c-scl-falling-time-ns = <50>;
202 i2c-scl-falling-time-ns = <50>;
/freebsd/sys/contrib/device-tree/src/arm/st/
H A Dste-hrefv60plus.dtsi24 /* At 50 degrees take down the CPU frequency */
56 pullup-ohm = <220000>;
57 pulldown-ohm = <0>;
65 pullup-ohm = <220000>;
66 pulldown-ohm = <0>;
H A Dste-snowball.dts46 pullup-ohm = <230000>;
47 pulldown-ohm = <0>;
68 debounce-interval = <50>;
75 debounce-interval = <50>;
82 debounce-interval = <50>;
89 debounce-interval = <50>;
96 debounce-interval = <50>;
/freebsd/sys/contrib/device-tree/src/arm64/ti/
H A Dk3-am6548-iot2050-advanced-common.dtsi52 ti,driver-strength-ohm = <50>;
H A Dk3-j7200-common-proc-board.dts382 ti,driver-strength-ohm = <50>;
393 ti,driver-strength-ohm = <50>;
H A Dk3-am642-sr-som.dtsi299 som_eeprom: eeprom@50 {
536 cdns,tshsl-ns = <50>;
537 cdns,tsd2d-ns = <50>;
550 ti,driver-strength-ohm = <50>;
573 ti,driver-strength-ohm = <50>;
H A Dk3-am642-tqma64xxl.dtsi111 eeprom0: eeprom@50 {
227 ti,driver-strength-ohm = <50>;
H A Dk3-am654-base-board.dts354 eeprom@50 {
458 ti,driver-strength-ohm = <50>;
472 ti,driver-strength-ohm = <50>;
H A Dk3-am64-phycore-som.dtsi249 eeprom@50 {
359 ti,driver-strength-ohm = <50>;
H A Dk3-j722s-evm.dts604 ti,driver-strength-ohm = <50>;
614 ti,driver-strength-ohm = <50>;
H A Dk3-j721e-beagleboneai64.dts568 ti,driver-strength-ohm = <50>;
579 ti,driver-strength-ohm = <50>;
642 eeprom@50 {
H A Dk3-j721e-common-proc-board.dts490 ti,driver-strength-ohm = <50>;
501 ti,driver-strength-ohm = <50>;
/freebsd/sys/contrib/device-tree/src/arm/nxp/imx/
H A Dimx6dl-lanmcu.dts211 threshold = <50>;
363 /* DSE 0x30 => 25 Ohm, 0x20 => 37 Ohm, 0x10 => 75 Ohm */
/freebsd/sys/contrib/device-tree/Bindings/mmc/
H A Dsdhci-am654.txt38 - ti,driver-strength-ohm: driver strength in ohms.
39 Valid values are 33, 40, 50, 66 and 100 ohms.
H A Dsdhci-am654.yaml179 ti,driver-strength-ohm:
185 - 50
/freebsd/sys/contrib/device-tree/Bindings/pinctrl/
H A Dfsl,imx-pinctrl.txt91 0x17059 means enable hysteresis, 47KOhm Pull Up, 50Mhz speed,
92 80Ohm driver strength and Fast Slew Rate.
/freebsd/sys/arm64/rockchip/
H A Drk3568_combphy.c178 /* tx_rterm 50 ohm & rx_rterm 44 ohm */ in rk3568_combphy_enable()
/freebsd/sys/contrib/device-tree/Bindings/soc/rockchip/
H A Dgrf.yaml325 drive-impedance-ohm = <50>;
/freebsd/contrib/ntp/html/drivers/
H A Ddriver6.html24 …al is driven &plusmn;10 V behind 50 Ohms. In such cases the cable should be terminated at the line…
/freebsd/contrib/ntp/html/
H A Daudio.html112 <td>50</td>
168 drive a cable terminated with a 50-ohm resistor, which results in a level

12