| /linux/Documentation/devicetree/bindings/mtd/ |
| H A D | ingenic,nand.yaml | 72 <4 0 0x18000000 0x1000000>,
127 partition@c00000 {
132 partition@4c00000 {
|
| /linux/arch/arm/boot/dts/aspeed/ |
| H A D | openbmc-flash-layout.dtsi | 23 rofs@4c0000 {
28 rwfs@1c00000 {
|
| /linux/Documentation/devicetree/bindings/gpio/ |
| H A D | xylon,logicvc-gpio.yaml | 20 - GPIO[4:0] (display control) mapped to index 0-4
56 logicvc: logicvc@43c00000 {
|
| /linux/Documentation/devicetree/bindings/mfd/ |
| H A D | syscon-common.yaml | 45 enum: [1, 2, 4, 8]
67 syscon: syscon@1c00000 {
|
| /linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx1-apf9328.dts | 57 eth: ethernet@4,c00000 {
61 reg = <4 0x00c00000 0x2>,
62 <4 0x00c00002 0x2>;
|
| /linux/arch/arm/boot/dts/xilinx/ |
| H A D | zynq-cc108.dts | 63 spi-rx-bus-width = <4>;
68 reg = <0x0 0x400000>; /* 4MB */
72 reg = <0x400000 0x400000>; /* 4MB */
76 reg = <0x800000 0x400000>; /* 4MB */
78 partition@c00000 {
|
| H A D | zynq-zc770-xm012.dts | 79 partition@c00000 {
92 num-cs = <4>;
|
| H A D | zynq-zc770-xm013.dts | 69 spi-rx-bus-width = <4>;
91 partition@c00000 {
101 num-cs = <4>;
|
| H A D | zynq-zed.dts | 58 spi-rx-bus-width = <4>;
81 partition@c00000 {
|
| H A D | zynq-zc770-xm010.dts | 69 spi-rx-bus-width = <4>;
91 partition@c00000 {
105 num-cs = <4>;
|
| /linux/arch/arm64/boot/dts/nvidia/ |
| H A D | tegra186-p3310.dtsi | 38 phy-reset-gpios = <&gpio TEGRA186_MAIN_GPIO(M, 4)
59 memory-controller@2c00000 {
142 wp-gpios = <&gpio TEGRA186_MAIN_GPIO(P, 4) GPIO_ACTIVE_HIGH>;
163 hsp@3c00000 {
388 cpu@4 {
|
| /linux/arch/arm64/boot/dts/renesas/ |
| H A D | rzv2-evk-cn15-sd.dtso | 17 mmc0 = "/soc/mmc@15c00000";
65 bus-width = <4>;
|
| /linux/Documentation/devicetree/bindings/display/ |
| H A D | arm,komeda.yaml | 15 to a 4K resolution each. Each pipeline can be composed of up to four
94 display@c00000 {
104 <&smmu 4>, <&smmu 5>, <&smmu 6>, <&smmu 7>,
|
| /linux/Documentation/devicetree/bindings/bus/ |
| H A D | socionext,uniphier-system-bus.yaml | 82 system-bus@58c00000 {
93 interrupts = <0 48 4>;
100 interrupts = <0 49 4>;
|
| /linux/Documentation/devicetree/bindings/media/ |
| H A D | qcom,msm8996-venus.yaml | 29 maxItems: 4
112 video-codec@c00000 {
|
| /linux/arch/microblaze/boot/dts/ |
| H A D | system.dts | 203 Hard_Ethernet_MAC: xps-ll-temac@81c00000 {
208 ethernet@81c00000 {
264 gpios = <&LEDs_8Bit 4 1>;
344 xps_timer_1: timer@83c00000 {
|
| /linux/Documentation/devicetree/bindings/pci/ |
| H A D | qcom,pcie-sa8255p.yaml | 79 pci@1c00000 {
110 <0 0 0 4 &intc GIC_SPI 151 IRQ_TYPE_LEVEL_HIGH>;
|
| H A D | qcom,pcie-sm8350.yaml | 92 pcie@1c00000 {
146 <0 0 0 4 &intc 0 152 IRQ_TYPE_LEVEL_HIGH>; /* int_d */
|
| H A D | qcom,pcie-sc8180x.yaml | 87 pcie@1c00000 {
151 <0 0 0 4 &intc 0 152 IRQ_TYPE_LEVEL_HIGH>; /* int_d */
|
| H A D | qcom,pcie-sm8150.yaml | 93 pcie@1c00000 {
141 <0 0 0 4 &intc 0 152 IRQ_TYPE_LEVEL_HIGH>; /* int_d */
|
| H A D | qcom,pcie-sa8775p.yaml | 99 pcie@1c00000 {
158 <0 0 0 4 &intc GIC_SPI 439 IRQ_TYPE_LEVEL_HIGH>;
|
| /linux/arch/arm/boot/dts/marvell/ |
| H A D | kirkwood-linksys-viper.dts | 119 partition@4a0000 {
124 partition@1c00000 {
192 port@4 {
193 reg = <4>;
|
| H A D | armada-385-db-ap.dts | 60 phy1: ethernet-phy@4 {
61 reg = <4>;
212 nand-ecc-strength = <4>;
232 partition@c00000 {
|
| /linux/arch/mips/boot/dts/ingenic/ |
| H A D | ci20.dts | 125 wifi_power: fixedregulator-4 {
196 bus-width = <4>;
210 bus-width = <4>;
269 shutdown-gpios = <&gpf 4 GPIO_ACTIVE_HIGH>;
464 partition@c00000 {
469 partition@4c00000 {
605 groups = "mmc0-1bit-e", "mmc0-4bit-e";
611 groups = "mmc1-1bit-d", "mmc1-4bit-d";
|
| /linux/arch/arm/boot/dts/intel/pxa/ |
| H A D | pxa27x.dtsi | 30 reg = <0x40e00054 0x20 0x40e0000c 0xc 0x40e0010c 4
41 usb0: usb@4c000000 {
63 pwm2: pwm@40c00000 {
98 interrupts = <4>;
|