Lines Matching +full:fsi +full:- +full:attached

1 # SPDX-License-Identifier: GPL-2.0-only
13 dynamic device discovery; some are even write-only or read-only.
17 chips, analog to digital (and d-to-a) converters, and more.
44 If your system has an master-capable SPI controller (which
56 by providing a high-level interface to send memory-like commands.
66 This enables support for SPI-NAND mode on the Airoha NAND
68 is implemented as a SPI-MEM controller.
107 to a single device like spi-nor (nvram), input device controller
138 in the Aspeed AST2600, AST2500 and AST2400 SoCs when attached
166 supports spi-mem interface.
245 this code to manage the per-word or per-transfer accesses to the
275 Flash over 1/2/4-bit wide bus. Enable this option if you have a
287 Flash over up to 8-bit wide bus. Enable this option if you have a
301 This enables dedicated general purpose SPI/Microwire1-compatible
302 master mode interface (SSI1) for CLPS711X-based CPUs.
320 tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller"
324 SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
342 tristate "Memory-mapped io interface driver for DW SPI core"
346 tristate "Baikal-T1 SPI driver for DW SPI core"
350 Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI
353 part of the Baikal-T1 System Boot Controller has got a very
355 chip-select and Tx/Rx FIFO with just 8 words depth available.
356 The later one is normally connected to an external SPI-nor flash
360 bool "Directly mapped Baikal-T1 Boot SPI flash support"
364 Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which
369 time-critical tasks (like the SPI memory operations implemented
375 tristate "Diolan DLN-2 USB SPI adapter"
382 will be called spi-dln2.
395 The external bus unit (EBU) found on the FALC-ON SoC has SPI
401 tristate "FSI SPI driver"
402 depends on FSI
404 This enables support for the driver for FSI bus attached SPI
422 supports the high-level SPI memory interface.
428 This enables support for the driver for GXP bus attached SPI
439 will be called hisi-kunpeng-spi.
458 supports the high-level SPI memory interface.
461 tristate "GPIO-based bitbanging SPI Master"
465 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
496 will be called spi-ingenic.
517 will be called spi-intel-pci.
529 exposes the low level SPI-NOR opcodes to the software. Using
536 will be called spi-intel-platform.
539 tristate "J-Core SPI Master"
542 This enables support for the SPI master controller in the J-Core
581 tristate "ICP DAS LP-8841 SPI Controller for RTC"
585 DS-1302 real time clock.
588 LP-8x4x industrial computer.
591 tristate "Freescale MPC52xx SPI (non-PSC) controller support"
656 will be called spi-ljca.
681 If built as a module, it will be called spi-microchip-core.
690 If built as a module, it will be called spi-microchip-core-qspi.
722 This enables support for SPI-NAND mode on the MediaTek NAND
724 is implemented as a SPI-MEM controller with pipelined ECC
736 supports the spi-mem interface.
746 supports spi-mem interface.
814 called as spi-pci1xxxx.
858 tristate "Realtek SPI-NAND Flash Controller"
862 This enables support for the SPI-NAND Flash controller on
866 only supports the spi-mem interface.
899 tristate "Renesas RPC-IF SPI driver"
902 SPI driver for Renesas R-Car Gen3 or RZ/G2 RPC-IF.
929 for serial peripheral interface (SPI) mini-core. SPI in master
942 yes to this option, support will be included for the built-in SPI
946 will be called spi-geni-qcom.
1009 for connecting an SPI Flash memory over up to 8-bit wide bus.
1044 supports spi-mem interface.
1047 tristate "STMicroelectronics SPI SSC-based driver"
1072 called as spi-sunplus-sp7021.
1083 that use the de-facto standard SPI protocol.
1085 It also supports the new dual-bit and quad-bit SPI protocol.
1167 tristate "Analog Devices AD-FMCOMMS1-EBZ SPI-I2C-bridge driver"
1170 Support for the SPI-I2C bridge found on the Analog Devices
1171 AD-FMCOMMS1-EBZ board.
1242 select one or more specific mux-controller drivers.
1286 If your system has a slave-capable SPI controller, you can enable