Lines Matching +full:phy +full:- +full:is +full:- +full:integrated
1 # SPDX-License-Identifier: GPL-2.0-only
3 # PHY Layer Configuration
16 PHYlink models the link between the PHY and MAC, allowing fixed
21 tristate "PHY Device support and infrastructure"
24 Ethernet controllers are usually attached to PHY
26 managing PHY devices.
40 Adds support for a set of LED trigger events per-PHY. Link
43 supported by the PHY and also a one common "link" trigger as a
44 logical-or of all the link speed ones.
46 <mii bus id>:<phy>:<speed>
48 Where speed is in the form:
50 for any speed known to the PHY.
59 When LED class support is enabled, phylib can automatically
63 tristate "MDIO Bus/PHY emulation with fixed speed/link PHYs"
69 Currently tested with mpc866ads and mpc8349e-mitx.
76 Adds support needed for PHY drivers written in Rust. It provides
85 comment "MII PHY device drivers"
90 Currently supports the Aeonsemi AS21xxx PHY.
96 AS21210PB1 that all register with the PHY ID 0x7500 0x7500
97 before the firmware is loaded.
100 tristate "Airoha EN8811H 2.5 Gigabit PHY"
102 Currently supports the Airoha EN8811H PHY.
110 tristate "Amlogic Meson GXL Internal PHY"
114 Currently has a driver for the Amlogic Meson GXL Internal PHY
121 - ADIN1200 - Robust,Industrial, Low Power 10/100 Ethernet PHY
122 - ADIN1300 - Robust,Industrial, Low Latency 10/100/1000 Gigabit
123 Ethernet PHY
130 - ADIN1100 - Robust,Industrial, Low Power 10BASE-T1L Ethernet PHY
133 tristate "AMCC QT2025 PHY"
137 Adds support for the Applied Micro Circuits Corporation QT2025 PHY.
139 source "drivers/net/phy/aquantia/Kconfig"
144 Currently supports the Asix Electronics PHY found in the X-Surf 100
152 The features are equivalent. It supports the Asix Electronics PHY
153 found in the X-Surf 100 AX88796B package.
165 tristate "Broadcom BCM54140 PHY"
170 Support the Broadcom BCM54140 Quad SGMII/QSGMII PHY.
172 This driver also supports the hardware monitoring of this PHY and
176 tristate "Broadcom 63xx SOCs internal PHY"
190 tristate "Broadcom BCM84881 PHY"
192 Support the Broadcom BCM84881 PHY.
200 tristate "Broadcom Cygnus/Omega SoC internal PHY"
205 This PHY driver is for the 1G internal PHYs of the Broadcom
208 Currently supports internal PHY's used in the BCM11300,
224 tristate "Cortina EDC CDR 10G Ethernet PHY"
226 Currently supports the CS4340 phy.
248 PEF 7061, PEF 7071 and PEF 7072 or integrated into the Intel
252 tristate "LSI ET1011C PHY"
254 Supports the LSI ET1011C PHY.
267 tristate "Marvell 88Q2XXX PHY"
270 Support for the Marvell 88Q2XXX 100/1000BASE-T1 Automotive Ethernet
274 tristate "Marvell 88X2222 PHY"
276 Support for the Marvell 88X2222 Dual-port Multi-speed Ethernet
288 tristate "MaxLinear MXL86110 PHY support"
292 The MXL86110 is commonly used in networking equipment such as
296 If you are using a board with the MXL86110 PHY connected to your
299 source "drivers/net/phy/mediatek/Kconfig"
309 tristate "Microchip 10BASE-T1S Ethernet PHYs"
329 Currently supports LAN887X T1 PHY
349 Currently supports the DP83865 PHY.
352 tristate "NXP 100BASE-TX PHYs"
354 Support the 100BASE-TX PHY integrated on the SJA1110 automotive
372 tristate "Onsemi 10BASE-T1S Ethernet PHY"
374 Adds support for the onsemi 10BASE-T1S Ethernet PHY.
375 Currently supports the NCN26000 10BASE-T1S Industrial PHY
378 source "drivers/net/phy/qcom/Kconfig"
385 source "drivers/net/phy/realtek/Kconfig"
395 Currently supports the integrated Ethernet PHY.
406 This is the driver for the STe100p and STe101p PHYs.
420 tristate "Texas Instruments DP83TC811 PHY"
422 Supports the DP83TC811 PHY.
425 tristate "Texas Instruments DP83848 PHY"
427 Supports the DP83848 PHY.
430 tristate "Texas Instruments DP83867 Gigabit PHY"
432 Currently supports the DP83867 PHY.
435 tristate "Texas Instruments DP83869 Gigabit PHY"
437 Currently supports the DP83869 PHY. This PHY supports copper and
441 tristate "Texas Instruments DP83TD510 Ethernet 10Base-T1L PHY"
443 Support for the DP83TD510 Ethernet 10Base-T1L PHY. This PHY supports
447 tristate "Texas Instruments DP83TG720 Ethernet 1000Base-T1 PHY"
450 The DP83TG720S-Q1 is an automotive Ethernet physical layer
454 shielded single twisted-pair cables. This device offers
457 requiring high-speed data transmission in automotive