Lines Matching +full:external +full:- +full:fpga +full:- +full:config
1 # SPDX-License-Identifier: GPL-2.0-only
17 config DDR
25 config ARM_PL172_MPMC
33 config ATMEL_EBI
42 Used to configure the EBI (external bus interface) when the device-
43 tree is used. This bus supports NANDs, external ethernet controller,
46 config BRCMSTB_DPFE
58 config BRCMSTB_MEMC
67 config BT1_L2_CTL
68 bool "Baikal-T1 CM2 L2-RAM Cache Control Block"
72 Baikal-T1 CPU is based on the MIPS P5600 Warrior IP-core. The CPU
73 resides Coherency Manager v2 with embedded 1MB L2-cache. It's
75 tags and way-select latencies of RAM access. This driver provides a
76 dt properties-based and sysfs interface for it.
78 config TI_AEMIF
84 SoCs. AEMIF stands for Asynchronous External Memory Interface and
85 is intended to provide a glue-less interface to a variety of
90 config TI_EMIF
99 functions of the driver includes re-configuring AC timing
103 config OMAP_GPMC
114 config OMAP_GPMC_DEBUG
128 config TI_EMIF_SRAM
135 the EMIF PM code must run from on-chip SRAM late in the suspend
139 config FPGA_DFL_EMIF
140 tristate "FPGA DFL EMIF Driver"
144 FPGA Device Feature List (DFL) framework. It is used to expose
148 config MVEBU_DEVBUS
157 devices such as NOR, NAND, SRAM, and FPGA.
159 config FSL_CORENET_CF
169 config FSL_IFC
174 config JZ4780_NEMC
179 This driver is for the NAND/External Memory Controller (NEMC) in
180 the Ingenic JZ4780. This controller is used to handle external
183 config MTK_SMI
191 config DA8XX_DDRCTL
199 config PL353_SMC
208 config RENESAS_RPCIF
209 tristate "Renesas RPC-IF driver"
214 This supports Renesas R-Car Gen3 or RZ/G2 RPC-IF which provides
218 config STM32_FMC2_EBI
219 tristate "Support for FMC2 External Bus Interface on STM32MP SoCs"
223 Select this option to enable the STM32 FMC2 External Bus Interface
224 controller. This driver configures the transactions with external
226 SOCs containing the FMC2 External Bus Interface.
228 config STM32_OMM
234 - direct mode (no multiplexing): OSPI1 output is on port 1 and OSPI2
236 - OSPI1 and OSPI2 are multiplexed over the same output port 1
237 - swapped mode (no multiplexing), OSPI1 output is on port 2,
239 - OSPI1 and OSPI2 are multiplexed over the same output port 2
241 - the split of the memory area shared between the 2 OSPI instances.
242 - chip select selection override.
243 - the time between 2 transactions in multiplexed mode.