Lines Matching +full:leds +full:- +full:pca9532
1 # SPDX-License-Identifier: GPL-2.0-only
19 LEDs from both userspace and optionally, by kernel events (triggers).
26 This option enables the LED sysfs class in /sys/class/leds. You'll
27 need this to do anything useful with LEDs. If unsure, say Y.
33 This option enables the flash LED sysfs class in /sys/class/leds.
34 It wraps LED Class and adds flash LEDs specific sysfs attributes
43 This option enables the multicolor LED sysfs class in /sys/class/leds.
46 for multicolor LEDs that are grouped together. This class is not
47 intended for single color LEDs. It can be built as a module.
54 for LED sysfs class devices under /sys/class/leds.
56 See Documentation/ABI/testing/sysfs-class-led for details.
65 This option enables support for on-chip LED drivers found on Marvell
72 This option enables support for the AN30259A 3-channel
76 will be called leds-an30259a.
83 This driver makes the PC Engines APU1 front panel LEDs
86 If you're looking for APU2/3, use the pcengines-apu2 driver.
90 module will be called leds-apu.
98 LEDs on Dell Wyse 3020 (Ariel) board via the KB3930 Embedded
110 a set of individually controlled LEDs and support 3 pattern controllers
112 - AW20036 (3x12) 36 LEDs
113 - AW20054 (6x9) 54 LEDs
114 - AW20072 (6x12) 72 LEDs
115 - AW20108 (9x12) 108 LEDs
118 will be called leds-aw200xx.
125 This option enables support for the AW2013 3-channel
129 will be called leds-aw2013.
137 This option enables support for LEDs connected to the BCM6328
146 This option enables support for LEDs connected to the BCM6358
154 This option enables support for charger and general purpose LEDs
158 will be called leds-cht-wcove.
166 This option enables support for LEDs offered by Motorola's
180 will be called leds-cr0014114.
189 This option enables support for LEDs managed by ChromeOS ECs.
190 All LEDs exposed by the EC are supported in multicolor mode.
195 will be called leds-cros_ec.
208 will be called leds-el15203000.
222 This option enables basic support for the LEDs found on the front
223 side of CZ.NIC's Turris Omnia router. There are 12 RGB LEDs on the
252 This option enables support for the LEDs on National Semiconductor /
255 The LEDs can be controlled directly, through PWM input, or by the
256 ambient-light-sensor interface. The chip supports
257 hardware-accelerated blinking with maximum on and off periods of 9.8
265 This option enables support for LEDs connected to LM3642.
266 The LM3642 is a 4MHz fixed-frequency synchronous boost
267 converter plus 1.5A constant current driver for a high-current
283 This option enables support for the LEDs on Sharp Locomo.
284 Zaurus models SL-5500 and SL-5600.
299 This option enables support for on-chip LED drivers found on
311 tristate "LED Support for the WRAP series LEDs"
315 This option enables support for the PCEngines WRAP programmable LEDs.
329 This option enables support for the Cobalt Raq series LEDs.
338 It uses a one-wire interface to control up to 1024 LEDs.
347 LEDs on the I/O and CPU boards of SunFire UltraSPARC servers.
366 tristate "LED driver for PCA9532 dimmer"
370 This option enables support for NXP pca9532
375 bool "Enable GPIO support for PCA9532"
379 Allow unused pins on PCA9532 to be used as gpio.
385 tristate "LED Support for GPIO connected LEDs"
389 This option enables support for the LEDs connected to GPIO
390 outputs. To be useful the particular board must have LEDs
391 and they must be connected to the GPIO lines. The LEDs must be
400 This option enables support for LEDs connected to the National
405 module will be called leds-lp3944.
414 This option enables support for LEDs connected to the Texas
418 module will be called leds-lp3952.
429 module will be called leds-lp50xx.
501 This option enables support for the Keyboard LEDs on the LP8788 PMIC.
510 This option enables support for the display cluster LEDs
520 programs through the LEDs subsystem. This LED has three
523 The driver supports two kinds of interface: using ledtrig-timer
524 or through /sys/class/leds/clevo::mail/brightness. As this LED
543 module will be called leds-clevo-mail.
550 This option enables support for LEDs connected to PCA955x
570 This option enables support for LEDs connected to the PCA963x
579 This option enables support for LEDs connected to PCA995x
584 tristate "LED support for status LEDs on WM831x PMICs"
588 This option enables support for the status LEDs of the WM831x
596 This option enables support for LEDs driven by the Wolfson
604 This option enables support for on-chip LED drivers found
608 tristate "Dialog DA9052/DA9053 LEDS"
612 This option enables support for on-chip LED drivers found
613 on Dialog Semiconductor DA9052-BC and DA9053-AA/Bx PMICs.
621 which can be used to control up to four LEDs.
628 This option enables support for pwm driven LEDs
635 This option enables support for regulator driven LEDs.
649 be called leds-bd2606mvv.
667 drive or power LEDs on the front panel. Using this driver
675 This option enables support for LEDs driven by a Linear Technology
676 LT3593 controller. This controller uses a special one-wire pulse
684 This option enables support for on-chip LED drivers found
688 be called leds-adp5520.
696 switch indication LEDs via the I2C bus.
699 be called leds-max5970.
706 This option enables support for on-chip LED drivers found
710 tristate "LED support for Network Space v2 GPIO LEDs"
715 This option enables support for the dual-GPIO LEDs found on the
721 n090401 (Seagate NAS 4-Bay)
724 tristate "LED support for Big Network series LEDs"
730 This option enables support for LEDs found on the LaCie 2Big
731 and 5Big Network v2 boards. The LEDs are wired to a CPLD and are
738 This option enables support for LEDs connected to TC6507
740 Driver support brightness control and hardware-assisted blinking.
754 LEDs driver for MAX77650 family of PMICs from Maxim Integrated.
760 This option enables support for on-chip LED drivers on
768 This option enables support for LEDs connected to LM3554
775 This option enables support for the LEDs on the Bachmann OT200.
776 Say Y to enable LEDs on the Bachmann OT200.
782 Say Y here to include support for the MEN 14F021P00 BMC LEDs.
785 will be called leds-menf21bmc.
792 This option enables support for LEDs connected to ISSI IS31FL319x
797 called leds-is31fl319x.
803 Say Y here to include support for ISSI IS31FL32XX and Si-En SN32xx
804 LED controllers. They are I2C devices with multiple constant-current
805 channels, each with independent 256-level PWM control.
813 LEDs.
816 called leds-sc27xx-bltc.
842 This option enables support for the system LEDs present on
845 will be called leds-powernv.
848 bool "LED support for LEDs on system controllers"
853 This option enables support for the LEDs on syscon type
870 This option enables support for the LEDs on the Mellanox
877 This option enables support for the LEDs on the Mellanox Ethernet and
880 module, choose 'M' here: the module will be called leds-mlxreg.
886 This option enables support for userspace LEDs. Say 'y' to enable this
895 This option enables support for the User1 and User2 LEDs on NI
899 will be called leds-nic78bx.
941 It is a single boost converter primarily for white LEDs and
949 This option enables support for the Red and White LEDs of
953 will be called leds-ip30.
962 source "drivers/leds/blink/Kconfig"
965 source "drivers/leds/flash/Kconfig"
968 source "drivers/leds/rgb/Kconfig"
971 source "drivers/leds/trigger/Kconfig"
974 source "drivers/leds/simple/Kconfig"