Lines Matching +full:stmpe +full:- +full:ts
1 # SPDX-License-Identifier: GPL-2.0-only
47 this symbol, but new drivers should use the generic gpio-regmap
57 non-sleeping contexts. They can make bitbanged serial protocols
126 Enables support for the idio-16 library functions. The idio-16 library
128 ACCES IDIO-16 family such as the 104-IDIO-16 and the PCI-IDIO-16.
130 If built as a module its name will be gpio-idio-16.
136 tristate "GPIO driver for 74xx-ICs with MMIO access"
140 Say yes here to support GPIO functionality for 74xx-compatible ICs
155 If driver is built as a module it will be called gpio-altera.
330 tristate "Generic memory-mapped GPIO controller support (MMIO platform device)"
333 Say yes here to support basic platform_device memory-mapped GPIO controllers.
336 tristate "Intel Granite Rapids-D vGPIO support"
343 - Intel Granite Rapids-D
351 be called gpio-graniterapids.
370 This GPIO controller supports double-edge interrupt and multi-core
388 ICH-based chipsets. Currently supported devices: ICH6, ICH7, ICH8
419 bool "Loongson-2/3 GPIO support"
422 Driver for GPIO functionality on Loongson-2F/3A/3B processors.
472 created by attaching a 16-bit latch to the bus.
543 Say yes here to support the on-chip GPIO lines on the OCTEON
577 tristate "Renesas R-Car and RZ/G GPIO support"
581 Say yes here to support GPIO on Renesas R-Car or RZ/G SoCs.
601 are grouped in four 8-bit wide ports.
608 A 32-bit single register GPIO fixed in/out implementation. This
644 maintain their value during backup/self-refresh.
662 via a SIOX bus and have a number of fixed-direction I/O lines.
670 This is a single-register MMIO GPIO driver for complex cases
721 - Elkhart Lake
722 - Merrifield
724 If built as a module its name will be gpio-tangier.
753 tristate "TS-4800 DIO blocks and compatibles"
758 This driver support TS-4800 FPGA GPIO controllers.
761 tristate "Cavium ThunderX/OCTEON-TX GPIO"
768 Say yes here to support the on-chip GPIO lines on the ThunderX
769 and OCTEON-TX families of SoCs.
806 bool "APM X-Gene GPIO controller support"
809 This driver is to support the GPIO block within the APM X-Gene SoC
815 tristate "APM X-Gene GPIO standby controller support"
821 This driver supports the GPIO block within the APM X-Gene
863 tristate "ZynqMP ps-mode pin GPIO configuration driver"
867 Say yes here to support the ZynqMP ps-mode pin GPIO configuration
870 This ps-mode pin GPIO driver is based on GPIO framework. PS_MODE
871 is 4-bits boot mode pins. It sets and gets the status of
872 the ps-mode pin. Every pin can be configured as input/output.
882 tristate "GPIO support for AMD Fusion Controller Hub (G-series SOCs)"
885 as found on G-series SOCs (e.g. GX-412TC).
888 needs to be provided with platform-specific configuration.
899 ARMv7-based SoCs.
908 IDT 79RC3243X-based devices like Mikrotik RB532.
911 be called gpio-idt3243x.
915 menu "Port-mapped I/O GPIO drivers"
941 If built as a module its name will be gpio-i8255.
944 tristate "ACCES 104-DIO-48E GPIO support"
953 Enables GPIO support for the ACCES 104-DIO-48E series (104-DIO-48E,
954 104-DIO-24E). The base port addresses for the devices may be
959 tristate "ACCES 104-IDIO-16 GPIO support"
965 Enables GPIO support for the ACCES 104-IDIO-16 family (104-IDIO-16,
966 104-IDIO-16E, 104-IDO-16, 104-IDIO-8, 104-IDIO-8E, 104-IDO-8). The
972 tristate "ACCES 104-IDI-48 GPIO support"
980 Enables GPIO support for the ACCES 104-IDI-48 family (104-IDI-48A,
981 104-IDI-48AC, 104-IDI-48B, 104-IDI-48BC). The base port addresses for
987 tristate "Fintek and Nuvoton Super-I/O GPIO support"
989 This option enables support for GPIOs found on Fintek Super-I/O
991 As well as Nuvoton Super-I/O chip NCT6126D.
994 be called f7188x-gpio.
997 tristate "Diamond Systems GPIO-MM GPIO support"
1003 Enables GPIO support for the Diamond Systems GPIO-MM and GPIO-MM-12.
1005 The Diamond Systems GPIO-MM device features 48 lines of digital I/O
1038 active during S3. The suspend-powered GPIOs can be used to wake the
1039 system from the Suspend-to-RAM state.
1045 Twenty-one are powered by the core power rail and 9 from the
1058 be called gpio-sch311x.
1061 tristate "TS-5500 DIO blocks and compatibles"
1066 blocks of the TS-5500: DIO1, DIO2 and the LCD port, and the TS-5600
1079 boot-time parameter "gpio_winbond.gpios" with a bitmask of GPIO
1083 be called gpio-winbond.
1104 tristate "Avionic Design N-bit GPIO expander"
1123 be called gpio-fxl6408.
1130 GPIO driver for ADI DS4520 I2C-based GPIO expander.
1134 be called gpio-ds4520.
1141 Expander. This is used at least on the Cambria GW2358-4.
1147 GPIO driver for Maxim MAX7300 I2C-based GPIO expander.
1150 tristate "MAX7319, MAX7320-7327 I2C Port Expanders"
1152 Say yes here to support the MAX7319, MAX7320-7327 series of I2C
1154 Input (designated by 'I'), Push-Pull Output ('O'), or Open-Drain
1179 Say yes here to provide access to several register-oriented
1204 tristate "PCA9570 4-Bit I2C GPO expander"
1209 be called gpio-pca9570.
1216 Say yes here to provide access to most "quasi-bidirectional" I2C
1233 This driver provides an in-kernel interface to those GPIOs using
1234 platform-neutral GPIO calls.
1237 tristate "TPIC2810 8-Bit I2C GPO expander"
1242 be called gpio-tpic2810.
1250 Series supported include TS-4100, TS-4900, TS-7970 and TS-7990.
1260 This option enables support for on-chip GPIO found
1292 will be called gpio-bd71815.
1304 will be called gpio-bd71828.
1315 will be called gpio-bd9571mwv.
1325 called gpio-cgbc.
1335 will be called gpio-cros-ec.
1344 Say Yes if you have a Intel SoC-based tablet with Crystal Cove PMIC
1348 called gpio-crystalcove.
1376 If driver is built as a module it will be called gpio-da9055.
1388 will be called gpio-dln2.
1407 be called gpio-elkhartlake.
1410 tristate "Janz VMOD-TTL Digital IO Module"
1413 This enables support for the Janz VMOD-TTL Digital IO module.
1425 called gpio-kempld.
1437 will be called gpio-ljca.
1455 called gpio-lp873x.
1465 called gpio-lp87565.
1501 called gpio-max77759.
1537 called gpio-sl28cpld.
1540 bool "STMPE GPIOs"
1545 This enables support for the GPIOs found on the STMPE I/O
1571 they are input-only or output-only type.
1574 module will be called gpio-tn48m.
1631 There are 7 GPIOs and few sensor-related GPIOs supported
1637 tristate "TQ-Systems TQMx86 GPIO"
1648 Say yes here to access the GPIO signals of various multi-function
1665 Say Yes if you have an Intel SoC-based tablet with Whiskey Cove PMIC
1669 called gpio-wcove.
1717 This chip can be found on Miro, Hauppauge and STB TV-cards.
1722 Documentation/driver-api/gpio/bt8xxgpio.rst
1757 This controller should be used in parallel with pinctrl-mlxbf3 to
1759 This driver can also be built as a module called mlxbf3-gpio.
1768 Hub) which is for IVI (In-Vehicle Infotainment) use.
1788 tristate "ACCES PCI-IDIO-16 GPIO support"
1792 Enables GPIO support for the ACCES PCI-IDIO-16. An interrupt is
1798 tristate "ACCES PCIe-IDIO-24 GPIO support"
1804 Enables GPIO support for the ACCES PCIe-IDIO-24 family (PCIe-IDIO-24,
1805 PCIe-IDI-24, PCIe-IDO-24, PCIe-IDIO-12). An interrupt is generated
1811 tristate "RDC R-321x GPIO support"
1832 tristate "74x164 serial-in/parallel-out 8-bits shift register"
1834 Driver for 74x164 compatible serial-in/parallel-out 8-outputs
1843 MAX31953 and MAX31963 industrial serializer, a daisy-chainable
1852 GPIO driver for Maxim MAX7301 SPI-based GPIO expander.
1855 tristate "Freescale MC33880 high-side/low-side switch"
1857 SPI driver for Freescale MC33880 high-side/low-side switch.
1861 tristate "Generic parallel-in/serial-out shift register"
1863 GPIO driver for SPI compatible parallel-in/serial-out shift
1867 tristate "EXAR XRA1403 16-bit GPIO expander"
1870 GPIO driver for EXAR XRA1403 16-bit SPI-based GPIO expander.
1916 - Assign permissions for a collection of GPIO lines to a user,
1917 - Export a collection of GPIO lines to a virtual machine,
1918 - Provide a generic driver for a GPIO-operated device in an
1932 This module is DEPRECATED. Please consider using gpio-sim instead.
1937 tools/testing/selftests/gpio/gpio-mockup.sh. Reference the usage in
1945 Say Y here to enable guest support for virtio-based GPIO controllers.
1956 This enables the GPIO simulator - a configfs-based GPIO testing
1968 GPIOs. Use the 'tools/gpio/gpio-sloppy-logic-analyzer' script with
1971 analyzer which can be affected by latencies, non-deterministic code
1976 'gpio-sloppy-logic-analyzer'.
1985 Say Y here to enable the configurable, configfs-based virtual GPIO
1989 hot-unplug handling in GPIOLIB.