Lines Matching +full:sl28 +full:- +full:gpi
1 # SPDX-License-Identifier: GPL-2.0-only
47 this symbol, but new drivers should use the generic gpio-regmap
57 non-sleeping contexts. They can make bitbanged serial protocols
126 Enables support for the idio-16 library functions. The idio-16 library
128 ACCES IDIO-16 family such as the 104-IDIO-16 and the PCI-IDIO-16.
130 If built as a module its name will be gpio-idio-16.
136 tristate "GPIO driver for 74xx-ICs with MMIO access"
140 Say yes here to support GPIO functionality for 74xx-compatible ICs
155 If driver is built as a module it will be called gpio-altera.
316 tristate "Generic memory-mapped GPIO controller support (MMIO platform device)"
319 Say yes here to support basic platform_device memory-mapped GPIO controllers.
322 tristate "Intel Granite Rapids-D vGPIO support"
329 - Intel Granite Rapids-D
337 be called gpio-graniterapids.
356 This GPIO controller supports double-edge interrupt and multi-core
375 ICH-based chipsets. Currently supported devices: ICH6, ICH7, ICH8
406 bool "Loongson-2/3 GPIO support"
409 Driver for GPIO functionality on Loongson-2F/3A/3B processors.
458 created by attaching a 16-bit latch to the bus.
529 Say yes here to support the on-chip GPIO lines on the OCTEON
562 tristate "Renesas R-Car and RZ/G GPIO support"
566 Say yes here to support GPIO on Renesas R-Car or RZ/G SoCs.
586 are grouped in four 8-bit wide ports.
593 A 32-bit single register GPIO fixed in/out implementation. This
629 maintain their value during backup/self-refresh.
647 via a SIOX bus and have a number of fixed-direction I/O lines.
655 This is a single-register MMIO GPIO driver for complex cases
697 - Elkhart Lake
698 - Merrifield
700 If built as a module its name will be gpio-tangier.
729 tristate "TS-4800 DIO blocks and compatibles"
734 This driver support TS-4800 FPGA GPIO controllers.
737 tristate "Cavium ThunderX/OCTEON-TX GPIO"
744 Say yes here to support the on-chip GPIO lines on the ThunderX
745 and OCTEON-TX families of SoCs.
781 bool "APM X-Gene GPIO controller support"
784 This driver is to support the GPIO block within the APM X-Gene SoC
790 tristate "APM X-Gene GPIO standby controller support"
796 This driver supports the GPIO block within the APM X-Gene
838 tristate "ZynqMP ps-mode pin GPIO configuration driver"
842 Say yes here to support the ZynqMP ps-mode pin GPIO configuration
845 This ps-mode pin GPIO driver is based on GPIO framework. PS_MODE
846 is 4-bits boot mode pins. It sets and gets the status of
847 the ps-mode pin. Every pin can be configured as input/output.
857 tristate "GPIO support for AMD Fusion Controller Hub (G-series SOCs)"
860 as found on G-series SOCs (e.g. GX-412TC).
863 needs to be provided with platform-specific configuration.
874 ARMv7-based SoCs.
883 IDT 79RC3243X-based devices like Mikrotik RB532.
886 be called gpio-idt3243x.
890 menu "Port-mapped I/O GPIO drivers"
916 If built as a module its name will be gpio-i8255.
919 tristate "ACCES 104-DIO-48E GPIO support"
928 Enables GPIO support for the ACCES 104-DIO-48E series (104-DIO-48E,
929 104-DIO-24E). The base port addresses for the devices may be
934 tristate "ACCES 104-IDIO-16 GPIO support"
940 Enables GPIO support for the ACCES 104-IDIO-16 family (104-IDIO-16,
941 104-IDIO-16E, 104-IDO-16, 104-IDIO-8, 104-IDIO-8E, 104-IDO-8). The
947 tristate "ACCES 104-IDI-48 GPIO support"
955 Enables GPIO support for the ACCES 104-IDI-48 family (104-IDI-48A,
956 104-IDI-48AC, 104-IDI-48B, 104-IDI-48BC). The base port addresses for
962 tristate "Fintek and Nuvoton Super-I/O GPIO support"
964 This option enables support for GPIOs found on Fintek Super-I/O
966 As well as Nuvoton Super-I/O chip NCT6126D.
969 be called f7188x-gpio.
972 tristate "Diamond Systems GPIO-MM GPIO support"
978 Enables GPIO support for the Diamond Systems GPIO-MM and GPIO-MM-12.
980 The Diamond Systems GPIO-MM device features 48 lines of digital I/O
1013 active during S3. The suspend-powered GPIOs can be used to wake the
1014 system from the Suspend-to-RAM state.
1020 Twenty-one are powered by the core power rail and 9 from the
1033 be called gpio-sch311x.
1036 tristate "TS-5500 DIO blocks and compatibles"
1041 blocks of the TS-5500: DIO1, DIO2 and the LCD port, and the TS-5600
1054 boot-time parameter "gpio_winbond.gpios" with a bitmask of GPIO
1058 be called gpio-winbond.
1079 tristate "Avionic Design N-bit GPIO expander"
1098 be called gpio-fxl6408.
1105 GPIO driver for ADI DS4520 I2C-based GPIO expander.
1109 be called gpio-ds4520.
1116 Expander. This is used at least on the Cambria GW2358-4.
1122 GPIO driver for Maxim MAX7300 I2C-based GPIO expander.
1125 tristate "MAX7319, MAX7320-7327 I2C Port Expanders"
1127 Say yes here to support the MAX7319, MAX7320-7327 series of I2C
1129 Input (designated by 'I'), Push-Pull Output ('O'), or Open-Drain
1154 Say yes here to provide access to several register-oriented
1179 tristate "PCA9570 4-Bit I2C GPO expander"
1184 be called gpio-pca9570.
1191 Say yes here to provide access to most "quasi-bidirectional" I2C
1208 This driver provides an in-kernel interface to those GPIOs using
1209 platform-neutral GPIO calls.
1212 tristate "TPIC2810 8-Bit I2C GPO expander"
1217 be called gpio-tpic2810.
1225 Series supported include TS-4100, TS-4900, TS-7970 and TS-7990.
1235 This option enables support for on-chip GPIO found
1267 will be called gpio-bd71815.
1279 will be called gpio-bd71828.
1290 will be called gpio-bd9571mwv.
1300 called gpio-cgbc.
1310 will be called gpio-cros-ec.
1319 Say Yes if you have a Intel SoC-based tablet with Crystal Cove PMIC
1323 called gpio-crystalcove.
1351 If driver is built as a module it will be called gpio-da9055.
1363 will be called gpio-dln2.
1382 be called gpio-elkhartlake.
1385 tristate "Janz VMOD-TTL Digital IO Module"
1388 This enables support for the Janz VMOD-TTL Digital IO module.
1400 called gpio-kempld.
1412 will be called gpio-ljca.
1430 called gpio-lp873x.
1440 called gpio-lp87565.
1496 This enables support for the GPIOs found on the Kontron sl28 CPLD.
1499 called gpio-sl28cpld.
1532 they are input-only or output-only type.
1535 module will be called gpio-tn48m.
1560 GPIO. It's either a GPO when MULTI_DEVICE_EN=0 or a GPI when
1592 There are 7 GPIOs and few sensor-related GPIOs supported
1598 tristate "TQ-Systems TQMx86 GPIO"
1609 Say yes here to access the GPIO signals of various multi-function
1626 Say Yes if you have an Intel SoC-based tablet with Whiskey Cove PMIC
1630 called gpio-wcove.
1678 This chip can be found on Miro, Hauppauge and STB TV-cards.
1683 Documentation/driver-api/gpio/bt8xxgpio.rst
1718 This controller should be used in parallel with pinctrl-mlxbf3 to
1720 This driver can also be built as a module called mlxbf3-gpio.
1729 Hub) which is for IVI (In-Vehicle Infotainment) use.
1749 tristate "ACCES PCI-IDIO-16 GPIO support"
1753 Enables GPIO support for the ACCES PCI-IDIO-16. An interrupt is
1759 tristate "ACCES PCIe-IDIO-24 GPIO support"
1765 Enables GPIO support for the ACCES PCIe-IDIO-24 family (PCIe-IDIO-24,
1766 PCIe-IDI-24, PCIe-IDO-24, PCIe-IDIO-12). An interrupt is generated
1772 tristate "RDC R-321x GPIO support"
1793 tristate "74x164 serial-in/parallel-out 8-bits shift register"
1796 Driver for 74x164 compatible serial-in/parallel-out 8-outputs
1805 MAX31953 and MAX31963 industrial serializer, a daisy-chainable
1814 GPIO driver for Maxim MAX7301 SPI-based GPIO expander.
1817 tristate "Freescale MC33880 high-side/low-side switch"
1819 SPI driver for Freescale MC33880 high-side/low-side switch.
1823 tristate "Generic parallel-in/serial-out shift register"
1825 GPIO driver for SPI compatible parallel-in/serial-out shift
1829 tristate "EXAR XRA1403 16-bit GPIO expander"
1832 GPIO driver for EXAR XRA1403 16-bit SPI-based GPIO expander.
1876 - Assign permissions for a collection of GPIO lines to a user,
1877 - Export a collection of GPIO lines to a virtual machine,
1878 - Provide a generic driver for a GPIO-operated device in an
1892 This module is DEPRECATED. Please consider using gpio-sim instead.
1897 tools/testing/selftests/gpio/gpio-mockup.sh. Reference the usage in
1905 Say Y here to enable guest support for virtio-based GPIO controllers.
1915 This enables the GPIO simulator - a configfs-based GPIO testing
1927 GPIOs. Use the 'tools/gpio/gpio-sloppy-logic-analyzer' script with
1930 analyzer which can be affected by latencies, non-deterministic code
1935 'gpio-sloppy-logic-analyzer'.
1943 Say Y here to enable the configurable, configfs-based virtual GPIO
1947 hot-unplug handling in GPIOLIB.