Merge drm/drm-fixes into drm-misc-fixes

Updating drm-misc-fixes to the state of v6.17-rc1. Begins a new release
cycle.

Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>

Merge tag 'regulator-v6.17' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator

Pull regulator updates from Mark Brown:
"The big change in this release is the addition of Rust bindin

Merge tag 'regulator-v6.17' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator

Pull regulator updates from Mark Brown:
"The big change in this release is the addition of Rust bindings from
Daniel Almeida, allowing fairly basic consumer use with support for
enable and voltage setting operations. This should be good for the
vast majority of consumers.

Otherwise it's been quite quiet, a few new devices supported, plus
some cleanups and fixes.

Summary:

- Basic Rust bindings

- A fix for making large voltage changes on regulators where we limit
the size of voltage change we will do in one step, previously we
just got as close as we could in one step

- Cleanups of our usage of the PM autosuspend functions, this pulls
in some PM core changes on a shared tag

- Mode setting support for PCA9450

- Support for Mediatek MT6893 and MT8196 DVFSRC, Qualcomm PM7550 and
PMR735B, Raspberry Pi displays and TI TPS652G1

The TI driver pulls in the MFD portion of the support for the device
and the pinctrl driver which was in the same tag"

* tag 'regulator-v6.17' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator: (40 commits)
regulator: mt6370: Fix spelling mistake in mt6370_regualtor_register
regulator: Kconfig: Fix spelling mistake "regualtor" -> "regulator"
regulator: core: repeat voltage setting request for stepped regulators
regulator: rt6160: Add rt6166 vout min_uV setting for compatible
MAINTAINERS: add regulator.rs to the regulator API entry
rust: regulator: add a bare minimum regulator abstraction
regulator: tps6286x-regulator: Fix a copy & paste error
regulator: qcom-rpmh: add support for pm7550 regulators
regulator: qcom-rpmh: add support for pmr735b regulators
regulator: dt-bindings: qcom,rpmh: Add PMR735B compatible
regulator: dt-bindings: qcom,rpmh: Add PM7550 compatible
regulator: tps6594-regulator: Add TI TPS652G1 PMIC regulators
regulator: tps6594-regulator: refactor variant descriptions
regulator: tps6594-regulator: remove hardcoded buck config
regulator: tps6594-regulator: remove interrupt_count
dt-bindings: mfd: ti,tps6594: Add TI TPS652G1 PMIC
pinctrl: pinctrl-tps6594: Add TPS652G1 PMIC pinctrl and GPIO
misc: tps6594-pfsm: Add TI TPS652G1 PMIC PFSM
mfd: tps6594: Add TI TPS652G1 support
regulator: sy8827n: make enable gpio NONEXCLUSIVE
...

show more ...

dt-bindings: regulator: add pca9450: Add regulator-allowed-modes

Make the PWM mode on the buck controllers configurable from devicetree.
Some boards require forced PWM mode to keep the supply ripple

dt-bindings: regulator: add pca9450: Add regulator-allowed-modes

Make the PWM mode on the buck controllers configurable from devicetree.
Some boards require forced PWM mode to keep the supply ripple within
acceptable limits under light load conditions.

Signed-off-by: Martijn de Gouw <martijn.de.gouw@prodrive-technologies.com>
Acked-by: Conor Dooley <conor.dooley@microchip.com>
Link: https://patch.msgid.link/20250525071823.819342-1-martijn.de.gouw@prodrive-technologies.com
Signed-off-by: Mark Brown <broonie@kernel.org>

show more ...