Merge drm/drm-fixes into drm-misc-fixes

Getting fixes and updates from v7.1-rc1.

Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>

Merge tag 'pinctrl-v7.1-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

Pull pin control updates from Linus Walleij:
"Core changes:

- Perform basic checks on pin config

Merge tag 'pinctrl-v7.1-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

Pull pin control updates from Linus Walleij:
"Core changes:

- Perform basic checks on pin config properties so as not to allow
directly contradictory settings such as setting a pin to more than
one bias or drive mode

- Handle input-threshold-voltage-microvolt property

- Introduce pinctrl_gpio_get_config() handling in the core for SCMI
GPIO using pin control

New drivers:

- GPIO-by-pin control driver (also appearing in the GPIO pull
request) fulfilling a promise on a comment from Grant Likely many
years ago: "can't GPIO just be a front-end for pin control?" it
turns out it can, if and only if you design something new from
scratch, such as SCMI

- Broadcom BCM7038 as a pinctrl-single delegate

- Mobileye EyeQ6Lplus OLB pin controller

- Qualcomm Eliza and Hawi families TLMM pin controllers

- Qualcomm SDM670 and Milos family LPASS LPI pin controllers

- Qualcomm IPQ5210 pin controller

- Realtek RTD1625 pin controller support

- Rockchip RV1103B pin controller support

- Texas Instruments AM62L as a pinctrl-single delegate

Improvements:

- Set config implementation for the Spacemit K1 pin controller"

* tag 'pinctrl-v7.1-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl: (84 commits)
pinctrl: qcom: Add Hawi pinctrl driver
dt-bindings: pinctrl: qcom: Describe Hawi TLMM block
dt-bindings: pinctrl: pinctrl-max77620: convert to DT schema
pinctrl: single: Add bcm7038-padconf compatible matching
dt-bindings: pinctrl: pinctrl-single: Add brcm,bcm7038-padconf
dt-bindings: pinctrl: apple,pinctrl: Add t8122 compatible
pinctrl: qcom: sdm670-lpass-lpi: label variables as static
pinctrl: sophgo: pinctrl-sg2044: Fix wrong module description
pinctrl: sophgo: pinctrl-sg2042: Fix wrong module description
pinctrl: qcom: add sdm670 lpi tlmm
dt-bindings: pinctrl: qcom: Add SDM670 LPASS LPI pinctrl
dt-bindings: qcom: lpass-lpi-common: add reserved GPIOs property
pinctrl: qcom: Introduce IPQ5210 TLMM driver
dt-bindings: pinctrl: qcom: add IPQ5210 pinctrl
pinctrl: qcom: Drop redundant intr_target_reg on modern SoCs
pinctrl: qcom: eliza: Fix interrupt target bit
pinctrl: core: Don't use "proxy" headers
pinctrl: amd: Support new ACPI ID AMDI0033
pinctrl: renesas: rzg2l: Drop superfluous blank line
pinctrl: renesas: rzg2l: Fix save/restore of {IOLH,IEN,PUPD,SMT} registers
...

show more ...

pinctrl: Kconfig: drop unneeded dependencies on OF_GPIO

OF_GPIO is selected automatically on all OF systems. Any symbols it
controls also provide stubs so there's really no reason to select it
expli

pinctrl: Kconfig: drop unneeded dependencies on OF_GPIO

OF_GPIO is selected automatically on all OF systems. Any symbols it
controls also provide stubs so there's really no reason to select it
explicitly.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com>
Signed-off-by: Linus Walleij <linusw@kernel.org>

show more ...

Merge tag 'v6.18' into next

Sync up with the mainline to bring in the latest APIs.

Merge remote-tracking branch 'drm/drm-next' into msm-next-robclark

Back-merge drm-next to get caught up.

Signed-off-by: Rob Clark <robin.clark@oss.qualcomm.com>

Merge drm/drm-next into drm-xe-next

Backmerging to bring in 6.18-rc1.

Signed-off-by: Thomas Hellström <thomas.hellstrom@linux.intel.com>

Merge drm/drm-next into drm-intel-next

Sync to v6.18-rc1.

Signed-off-by: Jani Nikula <jani.nikula@intel.com>

Merge drm/drm-next into drm-misc-next

Updating drm-misc-next to the state of v6.18-rc1.

Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>

Merge branch 'objtool/core'

Bring in the UDB and objtool data annotations to avoid conflicts while further extending the bug exceptions.

Signed-off-by: Peter Zijlstra <peterz@infradead.org>

Merge tag 'v6.18-rc6' into for-linus

Sync up with the mainline to bring in definition of
INPUT_PROP_HAPTIC_TOUCHPAD.

spi: Merge up v6.18-rc1

Ensure my CI has a sensible baseline.

Merge tag 'asoc-fix-v6.18-rc1' of https://git.kernel.org/pub/scm/linux/kernel/git/broonie/sound into for-linus

ASoC: Fixes for v6.18

A moderately large collection of driver specific fixes, plus a f

Merge tag 'asoc-fix-v6.18-rc1' of https://git.kernel.org/pub/scm/linux/kernel/git/broonie/sound into for-linus

ASoC: Fixes for v6.18

A moderately large collection of driver specific fixes, plus a few new
quirks and device IDs. The NAU8821 changes are a little large but more
in mechanical ways than in ways that are complex.

show more ...

Merge drm/drm-fixes into drm-misc-fixes

Updating drm-misc-fixes to the state of v6.18-rc1.

Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>

Merge tag 'pinctrl-v6.18-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

Pull pin control updates from Linus Walleij:
"We have GPIO awareness in the pin control core and an

Merge tag 'pinctrl-v6.18-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

Pull pin control updates from Linus Walleij:
"We have GPIO awareness in the pin control core and an interesting
AAEON driver.

Core changes:

- Allow pins to be identified/marked as GPIO mode with a special
callback.

The pin controller core is now "aware" if a pin is in GPIO mode if
the callback is implemented in the driver, and can thus be marked
as "strict", i.e. disallowing simultaneous use of a line as GPIO
and another function such as I2C.

This is enabled in the Qualcomm TLMM driver and also implemeted
from day 1 in the new Broadcom STB driver

- Rename the pin config option PIN_CONFIG_OUTPUT to PIN_CONFIG_LEVEL
to better describe what the config is doing, as well as making it
more intuitive what shall be returned when reading this property

New drivers:

- Qualcomm SDM660 LPASS LPI TLMM pin controller subdriver

- Qualcomm Glymur family pin controller driver

- Broadcom STB family pin controller driver

- Tegra186 pin controller driver

- AAEON UP pin controller support.

This is some special pin controller that works as an external
advanced line MUX and amplifier for signals from an Intel SoC. A
cooperative effort with the GPIO maintainer was needed to reach a
solution where we reuse code from the GPIO aggregator/forwarder
driver

- Renesas RZ/T2H and RZ/N2H pin controller support

- Axis ARTPEC-8 subdriver for the Samsung pin controller driver

Improvements:

- Output enable (OEN) support in the Renesas RZG2L driver

- Properly support bias pull up/down in the pinctrl-single driver

- Move over all GPIO portions using generic MMIO GPIO to the new
generic GPIO chip management which has a nice and separate API

- Proper DT bindings for some older Broadcom SoCs

- External GPIO (EGPIO) support in the Qualcomm SM8250

Deleted code:

- Dropped the now unused Samsung S3C24xx drivers"

* tag 'pinctrl-v6.18-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl: (75 commits)
pinctrl: use more common syntax for compound literals
pinctrl: Simplify printks with pOF format
pinctrl: qcom: Add SDM660 LPASS LPI TLMM
dt-bindings: pinctrl: qcom: Add SDM660 LPI pinctrl
pinctrl: qcom: lpass-lpi: Add ability to use custom pin offsets
pinctrl: qcom: Add glymur pinctrl driver
dt-bindings: pinctrl: qcom: Add Glymur pinctrl
pinctrl: qcom: sm8250: Add egpio support
pinctrl: generic: rename PIN_CONFIG_OUTPUT to LEVEL
pinctrl: keembay: fix double free in keembay_build_functions()
pinctrl: spacemit: fix typo in PRI_TDI pin name
pinctrl: eswin: Fix regulator error check and Kconfig dependency
pinctrl: bcm: Add STB family pin controller driver
dt-bindings: pinctrl: Add support for Broadcom STB pin controller
pinctrl: qcom: make the pinmuxing strict
pinctrl: qcom: mark the `gpio` and `egpio` pins function as non-strict functions
pinctrl: qcom: add infrastructure for marking pin functions as GPIOs
pinctrl: allow to mark pin functions as requestable GPIOs
pinctrl: qcom: use generic pin function helpers
pinctrl: make struct pinfunction a pointer in struct function_desc
...

show more ...

pinctrl: bcm: Add STB family pin controller driver

This driver provide pin muxing and configuration functionality
for BCM2712 SoC used by RPi5. According to [1] this chip is an
instance of the one u

pinctrl: bcm: Add STB family pin controller driver

This driver provide pin muxing and configuration functionality
for BCM2712 SoC used by RPi5. According to [1] this chip is an
instance of the one used in Broadcom STB product line.

[1] https://lore.kernel.org/lkml/f6601f73-cb22-4ba3-88c5-241be8421fc3@broadcom.com/

Cc: Jonathan Bell <jonathan@raspberrypi.com>
Cc: Phil Elwell <phil@raspberrypi.com>
Signed-off-by: Ivan T. Ivanov <iivanov@suse.de>
Reviewed-by: Phil Elwell <phil@raspberrypi.com>
Signed-off-by: Andrea della Porta <andrea.porta@suse.com>
[linusw: Enable also for ARCH_BCM2835]
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

show more ...

Merge branch 'main' into zstd-linus

Merge branch 'next' into for-linus

Prepare input updates for 6.2 merge window.

Merge drm/drm-next into drm-misc-next-fixes

Backmerging to update drm-misc-next-fixes for the final phase
of the release cycle.

Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>

Merge drm/drm-next into drm-intel-next

Catch up on 6.1-rc cycle in order to solve the intel_backlight
conflict on linux-next.

Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>

Merge drm/drm-next into drm-intel-gt-next

Needed to bring in v6.1-rc1 which contains commit f683b9d61319 ("i915: use the VMA iterator")
which is needed for series https://patchwork.freedesktop.org/s

Merge drm/drm-next into drm-intel-gt-next

Needed to bring in v6.1-rc1 which contains commit f683b9d61319 ("i915: use the VMA iterator")
which is needed for series https://patchwork.freedesktop.org/series/110083/ .

Signed-off-by: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>

show more ...

Merge branch 'main' into zstd-next

Merge drm/drm-fixes into drm-misc-fixes

Backmerging to get v6.1-rc1.

Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>

ASoC: jz4752b: Capture fixes

Merge series from Siarhei Volkau <lis8215@gmail.com>:

The patchset fixes:
- Line In path stays powered off during capturing or
bypass to mixer.
- incorrectly repre

ASoC: jz4752b: Capture fixes

Merge series from Siarhei Volkau <lis8215@gmail.com>:

The patchset fixes:
- Line In path stays powered off during capturing or
bypass to mixer.
- incorrectly represented dB values in alsamixer, et al.
- incorrect represented Capture input selector in alsamixer
in Playback tab.
- wrong control selected as Capture Master

show more ...

Merge drm/drm-next into drm-misc-next

Let's kick-off this release cycle.

Signed-off-by: Maxime Ripard <maxime@cerno.tech>

Merge tag 'v6.1-rc1' into next

Merge with mainline to bring in the latest changes to twl4030 driver.