Merge drm/drm-fixes into drm-misc-fixes

Getting fixes and updates from v7.1-rc1.

Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>

Merge tag 'mips_7.1' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux

Pull MIPS updates from Thomas Bogendoerfer:

- Support for Mobileye EyeQ6Lplus

- Cleanups and fixes

* tag 'mips_7

Merge tag 'mips_7.1' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux

Pull MIPS updates from Thomas Bogendoerfer:

- Support for Mobileye EyeQ6Lplus

- Cleanups and fixes

* tag 'mips_7.1' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux: (30 commits)
MIPS/mtd: Handle READY GPIO in generic NAND platform data
MIPS/input: Move RB532 button to GPIO descriptors
MIPS: validate DT bootargs before appending them
MIPS: Alchemy: Remove unused forward declaration
MAINTAINERS: Mobileye: Add EyeQ6Lplus files
MIPS: config: add eyeq6lplus_defconfig
MIPS: Add Mobileye EyeQ6Lplus evaluation board dts
MIPS: Add Mobileye EyeQ6Lplus SoC dtsi
clk: eyeq: Add Mobileye EyeQ6Lplus OLB
clk: eyeq: Adjust PLL accuracy computation
clk: eyeq: Skip post-divisor when computing PLL frequency
pinctrl: eyeq5: Add Mobileye EyeQ6Lplus OLB
pinctrl: eyeq5: Use match data
reset: eyeq: Add Mobileye EyeQ6Lplus OLB
MIPS: Add Mobileye EyeQ6Lplus support
dt-bindings: soc: mobileye: Add EyeQ6Lplus OLB
dt-bindings: mips: Add Mobileye EyeQ6Lplus SoC
MIPS: dts: loongson64g-package: Switch to Loongson UART driver
mips: pci-mt7620: rework initialization procedure
mips: pci-mt7620: add more register init values
...

show more ...

MIPS: Add Mobileye EyeQ6Lplus support

Add the EyeQ6Lplus to the group of choices for Mobileye SoC
and set the kernel load address specific to this SoC.

Signed-off-by: Benoît Monin <benoit.monin@boo

MIPS: Add Mobileye EyeQ6Lplus support

Add the EyeQ6Lplus to the group of choices for Mobileye SoC
and set the kernel load address specific to this SoC.

Signed-off-by: Benoît Monin <benoit.monin@bootlin.com>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>

show more ...

Merge drm/drm-next into drm-intel-gt-next

We need
4ba4f1afb6a9 ("perf: Generic hotplug support for a PMU with a scope")
in order to land a i915 PMU simplification and a fix. That landed in 6.12
and

Merge drm/drm-next into drm-intel-gt-next

We need
4ba4f1afb6a9 ("perf: Generic hotplug support for a PMU with a scope")
in order to land a i915 PMU simplification and a fix. That landed in 6.12
and we are stuck at 6.9 so lets bump things forward.

Signed-off-by: Tvrtko Ursulin <tursulin@ursulin.net>

show more ...

Merge branch 'next' into for-linus

Prepare input updates for 6.12 merge window.

Merge branch 'ib/6.11-rc6-matrix-keypad-spitz' into next

Bring in changes removing support for platform data from matrix-keypad
driver.

Merge tag 'v6.11-rc1' into clk-meson-next

Linux 6.11-rc1

Merge tag 'v6.11-rc3' into trace/ring-buffer/core

The "reserve_mem" kernel command line parameter has been pulled into
v6.11. Merge the latest -rc3 to allow the persistent ring buffer memory to
be a

Merge tag 'v6.11-rc3' into trace/ring-buffer/core

The "reserve_mem" kernel command line parameter has been pulled into
v6.11. Merge the latest -rc3 to allow the persistent ring buffer memory to
be able to be mapped at the address specified by the "reserve_mem" command
line parameter.

Signed-off-by: Steven Rostedt (Google) <rostedt@goodmis.org>

show more ...

Merge tag 'v6.11-rc1' into for-6.12

Linux 6.11-rc1

Merge drm/drm-next into drm-xe-next

Get drm-xe-next on v6.11-rc2 and synchronized with drm-intel-next for
the display side. This resolves the current conflict for the
enable_display module parameter

Merge drm/drm-next into drm-xe-next

Get drm-xe-next on v6.11-rc2 and synchronized with drm-intel-next for
the display side. This resolves the current conflict for the
enable_display module parameter and allows further pending refactors.

Signed-off-by: Lucas De Marchi <lucas.demarchi@intel.com>

show more ...

Merge drm/drm-next into drm-misc-next

Get drm-misc-next to the state of v6.11-rc2.

Signed-off-by: Thomas Zimmermann <tzimmermann@suse.de>

Merge drm/drm-next into drm-intel-next

Sync with v6.11-rc1 in general, and specifically get the new
BACKLIGHT_POWER_ constants for power states.

Signed-off-by: Jani Nikula <jani.nikula@intel.com>

Merge branch 'linus' into x86/mm

Bring x86 and selftests up to date

Merge drm/drm-fixes into drm-misc-fixes

Let's start the new drm-misc-fixes cycle by bringing in 6.11-rc1.

Signed-off-by: Maxime Ripard <mripard@kernel.org>

Merge tag 'mips_6.11' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux

Pull MIPS updates from Thomas Bogendoerfer:

- add support for Realtek RTL9302C

- add support for Mobileye EyeQ6H

Merge tag 'mips_6.11' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux

Pull MIPS updates from Thomas Bogendoerfer:

- add support for Realtek RTL9302C

- add support for Mobileye EyeQ6H

- add support for Mobileye EyeQ OLB system controller

- improve r4k clocksource

- add mode for emulating ieee754 NAN2008

- rework for BMIPS CBR address handling

- fixes for Loongson 2K1000

- defconfig updates

- cleanups and fixes

* tag 'mips_6.11' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux: (58 commits)
MIPS: config: Add ip30_defconfig
MIPS: config: lemote2f: Regenerate defconfig
MIPS: config: generic: Add board-litex
MIPS: config: Enable MSA and virtualization for MIPS64R6
MIPS: Fix fallback march for SB1
mips: dts: realtek: Add RTL9302C board
mips: generic: add fdt fixup for Realtek reference board
mips: select REALTEK_OTTO_TIMER for Realtek platforms
dt-bindings: interrupt-controller: realtek,rtl-intc: Add rtl9300-intc
dt-bindings: mips: realtek: Add rtl930x-soc compatible
dt-bindings: vendor-prefixes: Add Cameo Communications
mips: dts: realtek: add device_type property to cpu node
mips: dts: realtek: use "serial" instead of "uart" in node name
MIPS: Implement ieee754 NAN2008 emulation mode
MIPS: lantiq: improve USB initialization
MIPS: GIC: Generate redirect block accessors
MIPS: CPS: Add a couple of multi-cluster utility functions
MIPS: Octeron: remove source file executable bit
MAINTAINERS: Mobileye: add OLB drivers and dt-bindings
MIPS: mobileye: eyeq5: add OLB system-controller node
...

show more ...

MIPS: mobileye: Add EyeQ6H support

EyeQ6H (or “High”) is an other SoC from Mobileye still based on the
MIPS I6500 architecture as the EyeQ5. The 2 clusters of this SoC
contains 4 cores which are cap

MIPS: mobileye: Add EyeQ6H support

EyeQ6H (or “High”) is an other SoC from Mobileye still based on the
MIPS I6500 architecture as the EyeQ5. The 2 clusters of this SoC
contains 4 cores which are capable of running 4 threads. Besides this,
it features multiple controllers such as the classic UART, high speed
I2C, SPI, as well as CAN-FD, PCIe Gen4, Octal/Quad SPI Flash
interface, Gigabit Ethernet, MIPI CSI-2, MIPI DSI, and eMMC 5.1. It
also includes a Hardware Security Module, Functional Safety Hardware,
and video encoders and more.

This commit provides the infrastructure to build a kernel running on
EyeQ6H SoC. For now the support is limited and only one CPU core is
running.

Reviewed-by: Jiaxun Yang <jiaxun.yang@flygoat.com>
Signed-off-by: Gregory CLEMENT <gregory.clement@bootlin.com>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>

show more ...