1// SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 2/* 3 * Device Tree Source for the RZ/G2LC SMARC EVK parts 4 * 5 * Copyright (C) 2022 Renesas Electronics Corp. 6 */ 7 8#include <dt-bindings/gpio/gpio.h> 9#include <dt-bindings/pinctrl/rzg2l-pinctrl.h> 10 11/* 12 * DIP-Switch SW1 setting on SoM 13 * 1 : High; 0: Low 14 * SW1-2 : SW_SD0_DEV_SEL (1: eMMC; 0: uSD) 15 * SW1-3 : SW_SCIF_CAN (1: CAN1; 0: SCIF1) 16 * SW1-4 : SW_RSPI_CAN (1: CAN1; 0: RSPI1) 17 * SW1-5 : SW_I2S0_I2S1 (1: I2S2 (HDMI audio); 0: I2S0) 18 * Please change below macros according to SW1 setting 19 */ 20 21#define SW_SCIF_CAN 0 22#if (SW_SCIF_CAN) 23/* Due to HW routing, SW_RSPI_CAN is always 0 when SW_SCIF_CAN is set to 1 */ 24#define SW_RSPI_CAN 0 25#else 26/* Please set SW_RSPI_CAN. Default value is 1 */ 27#define SW_RSPI_CAN 1 28#endif 29 30#if (SW_SCIF_CAN & SW_RSPI_CAN) 31#error "Can not set 1 to both SW_SCIF_CAN and SW_RSPI_CAN due to HW routing" 32#endif 33 34#include "rzg2lc-smarc-som.dtsi" 35#include "rzg2lc-smarc-pinfunction.dtsi" 36#include "rz-smarc-common.dtsi" 37 38/* comment the #define statement to disable SCIF1 (SER0) on PMOD1 (CN7) */ 39#define PMOD1_SER0 1 40 41/ { 42 aliases { 43 serial1 = &scif1; 44 }; 45}; 46 47/* 48 * To enable SCIF1 (SER0) on PMOD1 (CN7), On connector board 49 * SW1 should be at position 2->3 so that SER0_CTS# line is activated 50 * SW2 should be at position 2->3 so that SER0_TX line is activated 51 * SW3 should be at position 2->3 so that SER0_RX line is activated 52 * SW4 should be at position 2->3 so that SER0_RTS# line is activated 53 */ 54#if (!SW_SCIF_CAN && PMOD1_SER0) 55&scif1 { 56 pinctrl-0 = <&scif1_pins>; 57 pinctrl-names = "default"; 58 59 uart-has-rtscts; 60 status = "okay"; 61}; 62#endif 63