1config MAC80211 2 tristate "Generic IEEE 802.11 Networking Stack (mac80211)" 3 depends on EXPERIMENTAL 4 select CRYPTO 5 select CRYPTO_ECB 6 select CRYPTO_ARC4 7 select CRYPTO_AES 8 select CRC32 9 select WIRELESS_EXT 10 select CFG80211 11 select NET_SCH_FIFO 12 ---help--- 13 This option enables the hardware independent IEEE 802.11 14 networking stack. 15 16config MAC80211_RCSIMPLE 17 bool "'simple' rate control algorithm" if EMBEDDED 18 default y 19 depends on MAC80211 20 help 21 This option allows you to turn off the 'simple' rate 22 control algorithm in mac80211. If you do turn it off, 23 you absolutely need another rate control algorithm. 24 25 Say Y unless you know you will have another algorithm 26 available. 27 28config MAC80211_LEDS 29 bool "Enable LED triggers" 30 depends on MAC80211 && LEDS_TRIGGERS 31 ---help--- 32 This option enables a few LED triggers for different 33 packet receive/transmit events. 34 35config MAC80211_DEBUGFS 36 bool "Export mac80211 internals in DebugFS" 37 depends on MAC80211 && DEBUG_FS 38 ---help--- 39 Select this to see extensive information about 40 the internal state of mac80211 in debugfs. 41 42 Say N unless you know you need this. 43 44config MAC80211_DEBUG 45 bool "Enable debugging output" 46 depends on MAC80211 47 ---help--- 48 This option will enable debug tracing output for the 49 ieee80211 network stack. 50 51 If you are not trying to debug or develop the ieee80211 52 subsystem, you most likely want to say N here. 53 54config MAC80211_VERBOSE_DEBUG 55 bool "Verbose debugging output" 56 depends on MAC80211_DEBUG 57 58config MAC80211_LOWTX_FRAME_DUMP 59 bool "Debug frame dumping" 60 depends on MAC80211_DEBUG 61 ---help--- 62 Selecting this option will cause the stack to 63 print a message for each frame that is handed 64 to the lowlevel driver for transmission. This 65 message includes all MAC addresses and the 66 frame control field. 67 68 If unsure, say N and insert the debugging code 69 you require into the driver you are debugging. 70 71config TKIP_DEBUG 72 bool "TKIP debugging" 73 depends on MAC80211_DEBUG 74 75config MAC80211_DEBUG_COUNTERS 76 bool "Extra statistics for TX/RX debugging" 77 depends on MAC80211_DEBUG 78 79config MAC80211_IBSS_DEBUG 80 bool "Support for IBSS testing" 81 depends on MAC80211_DEBUG 82 ---help--- 83 Say Y here if you intend to debug the IBSS code. 84 85config MAC80211_VERBOSE_PS_DEBUG 86 bool "Verbose powersave mode debugging" 87 depends on MAC80211_DEBUG 88 ---help--- 89 Say Y here to print out verbose powersave 90 mode debug messages. 91