1 /* 2 * upd6408x - NEC Electronics 3-Dimensional Y/C separation input defines 3 * 4 * 2006 by Hans Verkuil (hverkuil@xs4all.nl) 5 * 6 * This program is free software; you can redistribute it and/or 7 * modify it under the terms of the GNU General Public License 8 * as published by the Free Software Foundation; either version 2 9 * of the License, or (at your option) any later version. 10 * 11 * This program is distributed in the hope that it will be useful, 12 * but WITHOUT ANY WARRANTY; without even the implied warranty of 13 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the 14 * GNU General Public License for more details. 15 */ 16 17 #ifndef _UPD64083_H_ 18 #define _UPD64083_H_ 19 20 /* There are two bits of information that the driver needs in order 21 to select the correct routing: the operating mode and the selection 22 of the Y input (external or internal). 23 24 The first two operating modes expect a composite signal on the Y input, 25 the second two operating modes use both the Y and C inputs. 26 27 Normally YCS_MODE is used for tuner and composite inputs, and the 28 YCNR mode is used for S-Video inputs. 29 30 The external Y-ADC is selected when the composite input comes from a 31 upd64031a ghost reduction device. If this device is not present, or 32 the input is a S-Video signal, then the internal Y-ADC input should 33 be used. */ 34 35 /* Operating modes: */ 36 37 /* YCS mode: Y/C separation (burst locked clocking) */ 38 #define UPD64083_YCS_MODE 0 39 /* YCS+ mode: 2D Y/C separation and YCNR (burst locked clocking) */ 40 #define UPD64083_YCS_PLUS_MODE 1 41 42 /* Note: the following two modes cannot be used in combination with the 43 external Y-ADC. */ 44 /* MNNR mode: frame comb type YNR+C delay (line locked clocking) */ 45 #define UPD64083_MNNR_MODE 2 46 /* YCNR mode: frame recursive YCNR (burst locked clocking) */ 47 #define UPD64083_YCNR_MODE 3 48 49 /* Select external Y-ADC: this should be set if this device is used in 50 combination with the upd64031a ghost reduction device. 51 Otherwise leave at 0 (use internal Y-ADC). */ 52 #define UPD64083_EXT_Y_ADC (1 << 2) 53 54 #endif 55