1 /* SPDX-License-Identifier: GPL-2.0 2 * 3 * SuperH FLCTL nand controller 4 * 5 * Copyright © 2008 Renesas Solutions Corp. 6 */ 7 8 #ifndef __SH_FLCTL_H__ 9 #define __SH_FLCTL_H__ 10 11 #include <linux/completion.h> 12 #include <linux/mtd/mtd.h> 13 #include <linux/mtd/rawnand.h> 14 #include <linux/mtd/partitions.h> 15 #include <linux/pm_qos.h> 16 17 /* FLCTL registers */ 18 #define FLCMNCR(f) (f->reg + 0x0) 19 #define FLCMDCR(f) (f->reg + 0x4) 20 #define FLCMCDR(f) (f->reg + 0x8) 21 #define FLADR(f) (f->reg + 0xC) 22 #define FLADR2(f) (f->reg + 0x3C) 23 #define FLDATAR(f) (f->reg + 0x10) 24 #define FLDTCNTR(f) (f->reg + 0x14) 25 #define FLINTDMACR(f) (f->reg + 0x18) 26 #define FLBSYTMR(f) (f->reg + 0x1C) 27 #define FLBSYCNT(f) (f->reg + 0x20) 28 #define FLDTFIFO(f) (f->reg + 0x24) 29 #define FLECFIFO(f) (f->reg + 0x28) 30 #define FLTRCR(f) (f->reg + 0x2C) 31 #define FLHOLDCR(f) (f->reg + 0x38) 32 #define FL4ECCRESULT0(f) (f->reg + 0x80) 33 #define FL4ECCRESULT1(f) (f->reg + 0x84) 34 #define FL4ECCRESULT2(f) (f->reg + 0x88) 35 #define FL4ECCRESULT3(f) (f->reg + 0x8C) 36 #define FL4ECCCR(f) (f->reg + 0x90) 37 #define FL4ECCCNT(f) (f->reg + 0x94) 38 #define FLERRADR(f) (f->reg + 0x98) 39 40 /* FLCMNCR control bits */ 41 #define _4ECCCNTEN (0x1 << 24) 42 #define _4ECCEN (0x1 << 23) 43 #define _4ECCCORRECT (0x1 << 22) 44 #define SHBUSSEL (0x1 << 20) 45 #define SEL_16BIT (0x1 << 19) 46 #define SNAND_E (0x1 << 18) /* SNAND (0=512 1=2048)*/ 47 #define QTSEL_E (0x1 << 17) 48 #define ENDIAN (0x1 << 16) /* 1 = little endian */ 49 #define FCKSEL_E (0x1 << 15) 50 #define ACM_SACCES_MODE (0x01 << 10) 51 #define NANWF_E (0x1 << 9) 52 #define SE_D (0x1 << 8) /* Spare area disable */ 53 #define CE1_ENABLE (0x1 << 4) /* Chip Enable 1 */ 54 #define CE0_ENABLE (0x1 << 3) /* Chip Enable 0 */ 55 #define TYPESEL_SET (0x1 << 0) 56 57 /* 58 * Clock settings using the PULSEx registers from FLCMNCR 59 * 60 * Some hardware uses bits called PULSEx instead of FCKSEL_E and QTSEL_E 61 * to control the clock divider used between the High-Speed Peripheral Clock 62 * and the FLCTL internal clock. If so, use CLK_8_BIT_xxx for connecting 8 bit 63 * and CLK_16_BIT_xxx for connecting 16 bit bus bandwith NAND chips. For the 16 64 * bit version the divider is seperate for the pulse width of high and low 65 * signals. 66 */ 67 #define PULSE3 (0x1 << 27) 68 #define PULSE2 (0x1 << 17) 69 #define PULSE1 (0x1 << 15) 70 #define PULSE0 (0x1 << 9) 71 #define CLK_8B_0_5 PULSE1 72 #define CLK_8B_1 0x0 73 #define CLK_8B_1_5 (PULSE1 | PULSE2) 74 #define CLK_8B_2 PULSE0 75 #define CLK_8B_3 (PULSE0 | PULSE1 | PULSE2) 76 #define CLK_8B_4 (PULSE0 | PULSE2) 77 #define CLK_16B_6L_2H PULSE0 78 #define CLK_16B_9L_3H (PULSE0 | PULSE1 | PULSE2) 79 #define CLK_16B_12L_4H (PULSE0 | PULSE2) 80 81 /* FLCMDCR control bits */ 82 #define ADRCNT2_E (0x1 << 31) /* 5byte address enable */ 83 #define ADRMD_E (0x1 << 26) /* Sector address access */ 84 #define CDSRC_E (0x1 << 25) /* Data buffer selection */ 85 #define DOSR_E (0x1 << 24) /* Status read check */ 86 #define SELRW (0x1 << 21) /* 0:read 1:write */ 87 #define DOADR_E (0x1 << 20) /* Address stage execute */ 88 #define ADRCNT_1 (0x00 << 18) /* Address data bytes: 1byte */ 89 #define ADRCNT_2 (0x01 << 18) /* Address data bytes: 2byte */ 90 #define ADRCNT_3 (0x02 << 18) /* Address data bytes: 3byte */ 91 #define ADRCNT_4 (0x03 << 18) /* Address data bytes: 4byte */ 92 #define DOCMD2_E (0x1 << 17) /* 2nd cmd stage execute */ 93 #define DOCMD1_E (0x1 << 16) /* 1st cmd stage execute */ 94 95 /* FLINTDMACR control bits */ 96 #define ESTERINTE (0x1 << 24) /* ECC error interrupt enable */ 97 #define AC1CLR (0x1 << 19) /* ECC FIFO clear */ 98 #define AC0CLR (0x1 << 18) /* Data FIFO clear */ 99 #define DREQ0EN (0x1 << 16) /* FLDTFIFODMA Request Enable */ 100 #define ECERB (0x1 << 9) /* ECC error */ 101 #define STERB (0x1 << 8) /* Status error */ 102 #define STERINTE (0x1 << 4) /* Status error enable */ 103 104 /* FLTRCR control bits */ 105 #define TRSTRT (0x1 << 0) /* translation start */ 106 #define TREND (0x1 << 1) /* translation end */ 107 108 /* 109 * FLHOLDCR control bits 110 * 111 * HOLDEN: Bus Occupancy Enable (inverted) 112 * Enable this bit when the external bus might be used in between transfers. 113 * If not set and the bus gets used by other modules, a deadlock occurs. 114 */ 115 #define HOLDEN (0x1 << 0) 116 117 /* FL4ECCCR control bits */ 118 #define _4ECCFA (0x1 << 2) /* 4 symbols correct fault */ 119 #define _4ECCEND (0x1 << 1) /* 4 symbols end */ 120 #define _4ECCEXST (0x1 << 0) /* 4 symbols exist */ 121 122 #define LOOP_TIMEOUT_MAX 0x00010000 123 124 enum flctl_ecc_res_t { 125 FL_SUCCESS, 126 FL_REPAIRABLE, 127 FL_ERROR, 128 FL_TIMEOUT 129 }; 130 131 struct dma_chan; 132 133 struct sh_flctl { 134 struct nand_chip chip; 135 struct platform_device *pdev; 136 struct dev_pm_qos_request pm_qos; 137 void __iomem *reg; 138 resource_size_t fifo; 139 140 uint8_t done_buff[2048 + 64]; /* max size 2048 + 64 */ 141 int read_bytes; 142 unsigned int index; 143 int seqin_column; /* column in SEQIN cmd */ 144 int seqin_page_addr; /* page_addr in SEQIN cmd */ 145 uint32_t seqin_read_cmd; /* read cmd in SEQIN cmd */ 146 int erase1_page_addr; /* page_addr in ERASE1 cmd */ 147 uint32_t erase_ADRCNT; /* bits of FLCMDCR in ERASE1 cmd */ 148 uint32_t rw_ADRCNT; /* bits of FLCMDCR in READ WRITE cmd */ 149 uint32_t flcmncr_base; /* base value of FLCMNCR */ 150 uint32_t flintdmacr_base; /* irq enable bits */ 151 152 unsigned page_size:1; /* NAND page size (0 = 512, 1 = 2048) */ 153 unsigned hwecc:1; /* Hardware ECC (0 = disabled, 1 = enabled) */ 154 unsigned holden:1; /* Hardware has FLHOLDCR and HOLDEN is set */ 155 unsigned qos_request:1; /* QoS request to prevent deep power shutdown */ 156 157 /* DMA related objects */ 158 struct dma_chan *chan_fifo0_rx; 159 struct dma_chan *chan_fifo0_tx; 160 struct completion dma_complete; 161 }; 162 163 struct sh_flctl_platform_data { 164 struct mtd_partition *parts; 165 int nr_parts; 166 unsigned long flcmncr_val; 167 168 unsigned has_hwecc:1; 169 unsigned use_holden:1; 170 171 unsigned int slave_id_fifo0_tx; 172 unsigned int slave_id_fifo0_rx; 173 }; 174 175 static inline struct sh_flctl *mtd_to_flctl(struct mtd_info *mtdinfo) 176 { 177 return container_of(mtd_to_nand(mtdinfo), struct sh_flctl, chip); 178 } 179 180 #endif /* __SH_FLCTL_H__ */ 181