1# 2# Physical Layer USB driver configuration 3# 4comment "USB Physical Layer drivers" 5 depends on USB || USB_GADGET 6 7config OMAP_USB2 8 tristate "OMAP USB2 PHY Driver" 9 depends on ARCH_OMAP2PLUS 10 select USB_OTG_UTILS 11 help 12 Enable this to support the transceiver that is part of SOC. This 13 driver takes care of all the PHY functionality apart from comparator. 14 The USB OTG controller communicates with the comparator using this 15 driver. 16 17config USB_ISP1301 18 tristate "NXP ISP1301 USB transceiver support" 19 depends on USB || USB_GADGET 20 depends on I2C 21 help 22 Say Y here to add support for the NXP ISP1301 USB transceiver driver. 23 This chip is typically used as USB transceiver for USB host, gadget 24 and OTG drivers (to be selected separately). 25 26 To compile this driver as a module, choose M here: the 27 module will be called isp1301. 28 29config MV_U3D_PHY 30 bool "Marvell USB 3.0 PHY controller Driver" 31 depends on USB_MV_U3D 32 select USB_OTG_UTILS 33 help 34 Enable this to support Marvell USB 3.0 phy controller for Marvell 35 SoC. 36 37config USB_RCAR_PHY 38 tristate "Renesas R-Car USB phy support" 39 depends on USB || USB_GADGET 40 select USB_OTG_UTILS 41 help 42 Say Y here to add support for the Renesas R-Car USB phy driver. 43 This chip is typically used as USB phy for USB host, gadget. 44 This driver supports: R8A7779 45 46 To compile this driver as a module, choose M here: the 47 module will be called rcar-phy. 48