1 /* 2 * omap_udc.h -- for omap 3.2 udc, with OTG support 3 * 4 * 2004 (C) Texas Instruments, Inc. 5 * 2004 (C) David Brownell 6 */ 7 8 /* 9 * USB device/endpoint management registers 10 */ 11 12 #define UDC_REV (UDC_BASE + 0x0) /* Revision */ 13 #define UDC_EP_NUM (UDC_BASE + 0x4) /* Which endpoint */ 14 # define UDC_SETUP_SEL (1 << 6) 15 # define UDC_EP_SEL (1 << 5) 16 # define UDC_EP_DIR (1 << 4) 17 /* low 4 bits for endpoint number */ 18 #define UDC_DATA (UDC_BASE + 0x08) /* Endpoint FIFO */ 19 #define UDC_CTRL (UDC_BASE + 0x0C) /* Endpoint control */ 20 # define UDC_CLR_HALT (1 << 7) 21 # define UDC_SET_HALT (1 << 6) 22 # define UDC_CLRDATA_TOGGLE (1 << 3) 23 # define UDC_SET_FIFO_EN (1 << 2) 24 # define UDC_CLR_EP (1 << 1) 25 # define UDC_RESET_EP (1 << 0) 26 #define UDC_STAT_FLG (UDC_BASE + 0x10) /* Endpoint status */ 27 # define UDC_NO_RXPACKET (1 << 15) 28 # define UDC_MISS_IN (1 << 14) 29 # define UDC_DATA_FLUSH (1 << 13) 30 # define UDC_ISO_ERR (1 << 12) 31 # define UDC_ISO_FIFO_EMPTY (1 << 9) 32 # define UDC_ISO_FIFO_FULL (1 << 8) 33 # define UDC_EP_HALTED (1 << 6) 34 # define UDC_STALL (1 << 5) 35 # define UDC_NAK (1 << 4) 36 # define UDC_ACK (1 << 3) 37 # define UDC_FIFO_EN (1 << 2) 38 # define UDC_NON_ISO_FIFO_EMPTY (1 << 1) 39 # define UDC_NON_ISO_FIFO_FULL (1 << 0) 40 #define UDC_RXFSTAT (UDC_BASE + 0x14) /* OUT bytecount */ 41 #define UDC_SYSCON1 (UDC_BASE + 0x18) /* System config 1 */ 42 # define UDC_CFG_LOCK (1 << 8) 43 # define UDC_DATA_ENDIAN (1 << 7) 44 # define UDC_DMA_ENDIAN (1 << 6) 45 # define UDC_NAK_EN (1 << 4) 46 # define UDC_AUTODECODE_DIS (1 << 3) 47 # define UDC_SELF_PWR (1 << 2) 48 # define UDC_SOFF_DIS (1 << 1) 49 # define UDC_PULLUP_EN (1 << 0) 50 #define UDC_SYSCON2 (UDC_BASE + 0x1C) /* System config 2 */ 51 # define UDC_RMT_WKP (1 << 6) 52 # define UDC_STALL_CMD (1 << 5) 53 # define UDC_DEV_CFG (1 << 3) 54 # define UDC_CLR_CFG (1 << 2) 55 #define UDC_DEVSTAT (UDC_BASE + 0x20) /* Device status */ 56 # define UDC_B_HNP_ENABLE (1 << 9) 57 # define UDC_A_HNP_SUPPORT (1 << 8) 58 # define UDC_A_ALT_HNP_SUPPORT (1 << 7) 59 # define UDC_R_WK_OK (1 << 6) 60 # define UDC_USB_RESET (1 << 5) 61 # define UDC_SUS (1 << 4) 62 # define UDC_CFG (1 << 3) 63 # define UDC_ADD (1 << 2) 64 # define UDC_DEF (1 << 1) 65 # define UDC_ATT (1 << 0) 66 #define UDC_SOF (UDC_BASE + 0x24) /* Start of frame */ 67 # define UDC_FT_LOCK (1 << 12) 68 # define UDC_TS_OK (1 << 11) 69 # define UDC_TS 0x03ff 70 #define UDC_IRQ_EN (UDC_BASE + 0x28) /* Interrupt enable */ 71 # define UDC_SOF_IE (1 << 7) 72 # define UDC_EPN_RX_IE (1 << 5) 73 # define UDC_EPN_TX_IE (1 << 4) 74 # define UDC_DS_CHG_IE (1 << 3) 75 # define UDC_EP0_IE (1 << 0) 76 #define UDC_DMA_IRQ_EN (UDC_BASE + 0x2C) /* DMA irq enable */ 77 /* rx/tx dma channels numbered 1-3 not 0-2 */ 78 # define UDC_TX_DONE_IE(n) (1 << (4 * (n) - 2)) 79 # define UDC_RX_CNT_IE(n) (1 << (4 * (n) - 3)) 80 # define UDC_RX_EOT_IE(n) (1 << (4 * (n) - 4)) 81 #define UDC_IRQ_SRC (UDC_BASE + 0x30) /* Interrupt source */ 82 # define UDC_TXN_DONE (1 << 10) 83 # define UDC_RXN_CNT (1 << 9) 84 # define UDC_RXN_EOT (1 << 8) 85 # define UDC_IRQ_SOF (1 << 7) 86 # define UDC_EPN_RX (1 << 5) 87 # define UDC_EPN_TX (1 << 4) 88 # define UDC_DS_CHG (1 << 3) 89 # define UDC_SETUP (1 << 2) 90 # define UDC_EP0_RX (1 << 1) 91 # define UDC_EP0_TX (1 << 0) 92 # define UDC_IRQ_SRC_MASK 0x7bf 93 #define UDC_EPN_STAT (UDC_BASE + 0x34) /* EP irq status */ 94 #define UDC_DMAN_STAT (UDC_BASE + 0x38) /* DMA irq status */ 95 # define UDC_DMA_RX_SB (1 << 12) 96 # define UDC_DMA_RX_SRC(x) (((x)>>8) & 0xf) 97 # define UDC_DMA_TX_SRC(x) (((x)>>0) & 0xf) 98 99 100 /* DMA configuration registers: up to three channels in each direction. */ 101 #define UDC_RXDMA_CFG (UDC_BASE + 0x40) /* 3 eps for RX DMA */ 102 # define UDC_DMA_REQ (1 << 12) 103 #define UDC_TXDMA_CFG (UDC_BASE + 0x44) /* 3 eps for TX DMA */ 104 #define UDC_DATA_DMA (UDC_BASE + 0x48) /* rx/tx fifo addr */ 105 106 /* rx/tx dma control, numbering channels 1-3 not 0-2 */ 107 #define UDC_TXDMA(chan) (UDC_BASE + 0x50 - 4 + 4 * (chan)) 108 # define UDC_TXN_EOT (1 << 15) /* bytes vs packets */ 109 # define UDC_TXN_START (1 << 14) /* start transfer */ 110 # define UDC_TXN_TSC 0x03ff /* units in xfer */ 111 #define UDC_RXDMA(chan) (UDC_BASE + 0x60 - 4 + 4 * (chan)) 112 # define UDC_RXN_STOP (1 << 15) /* enable EOT irq */ 113 # define UDC_RXN_TC 0x00ff /* packets in xfer */ 114 115 116 /* 117 * Endpoint configuration registers (used before CFG_LOCK is set) 118 * UDC_EP_TX(0) is unused 119 */ 120 #define UDC_EP_RX(endpoint) (UDC_BASE + 0x80 + (endpoint)*4) 121 # define UDC_EPN_RX_VALID (1 << 15) 122 # define UDC_EPN_RX_DB (1 << 14) 123 /* buffer size in bits 13, 12 */ 124 # define UDC_EPN_RX_ISO (1 << 11) 125 /* buffer pointer in low 11 bits */ 126 #define UDC_EP_TX(endpoint) (UDC_BASE + 0xc0 + (endpoint)*4) 127 /* same bitfields as in RX */ 128 129 /*-------------------------------------------------------------------------*/ 130 131 struct omap_req { 132 struct usb_request req; 133 struct list_head queue; 134 unsigned dma_bytes; 135 unsigned mapped:1; 136 }; 137 138 struct omap_ep { 139 struct usb_ep ep; 140 struct list_head queue; 141 unsigned long irqs; 142 struct list_head iso; 143 char name[14]; 144 u16 maxpacket; 145 u8 bEndpointAddress; 146 u8 bmAttributes; 147 unsigned double_buf:1; 148 unsigned stopped:1; 149 unsigned fnf:1; 150 unsigned has_dma:1; 151 u8 ackwait; 152 u8 dma_channel; 153 u16 dma_counter; 154 int lch; 155 struct omap_udc *udc; 156 struct timer_list timer; 157 }; 158 159 struct omap_udc { 160 struct usb_gadget gadget; 161 struct usb_gadget_driver *driver; 162 spinlock_t lock; 163 struct omap_ep ep[32]; 164 u16 devstat; 165 u16 clr_halt; 166 struct usb_phy *transceiver; 167 struct list_head iso; 168 unsigned softconnect:1; 169 unsigned vbus_active:1; 170 unsigned ep0_pending:1; 171 unsigned ep0_in:1; 172 unsigned ep0_set_config:1; 173 unsigned ep0_reset_config:1; 174 unsigned ep0_setup:1; 175 struct completion *done; 176 struct clk *dc_clk; 177 struct clk *hhc_clk; 178 unsigned clk_requested:1; 179 }; 180 181 /*-------------------------------------------------------------------------*/ 182 183 #ifdef VERBOSE 184 # define VDBG DBG 185 #else 186 # define VDBG(stuff...) do{}while(0) 187 #endif 188 189 #define ERR(stuff...) pr_err("udc: " stuff) 190 #define WARNING(stuff...) pr_warning("udc: " stuff) 191 #define INFO(stuff...) pr_info("udc: " stuff) 192 #define DBG(stuff...) pr_debug("udc: " stuff) 193 194 /*-------------------------------------------------------------------------*/ 195 196 /* MOD_CONF_CTRL_0 */ 197 #define VBUS_W2FC_1510 (1 << 17) /* 0 gpio0, 1 dvdd2 pin */ 198 199 /* FUNC_MUX_CTRL_0 */ 200 #define VBUS_CTRL_1510 (1 << 19) /* 1 connected (software) */ 201 #define VBUS_MODE_1510 (1 << 18) /* 0 hardware, 1 software */ 202 203 #define HMC_1510 ((omap_readl(MOD_CONF_CTRL_0) >> 1) & 0x3f) 204 #define HMC_1610 (omap_readl(OTG_SYSCON_2) & 0x3f) 205 #define HMC (cpu_is_omap15xx() ? HMC_1510 : HMC_1610) 206 207