xref: /linux/drivers/spi/spi-dw.h (revision ca55b2fef3a9373fcfc30f82fd26bc7fccbda732)
1 #ifndef DW_SPI_HEADER_H
2 #define DW_SPI_HEADER_H
3 
4 #include <linux/io.h>
5 #include <linux/scatterlist.h>
6 #include <linux/gpio.h>
7 
8 /* Register offsets */
9 #define DW_SPI_CTRL0			0x00
10 #define DW_SPI_CTRL1			0x04
11 #define DW_SPI_SSIENR			0x08
12 #define DW_SPI_MWCR			0x0c
13 #define DW_SPI_SER			0x10
14 #define DW_SPI_BAUDR			0x14
15 #define DW_SPI_TXFLTR			0x18
16 #define DW_SPI_RXFLTR			0x1c
17 #define DW_SPI_TXFLR			0x20
18 #define DW_SPI_RXFLR			0x24
19 #define DW_SPI_SR			0x28
20 #define DW_SPI_IMR			0x2c
21 #define DW_SPI_ISR			0x30
22 #define DW_SPI_RISR			0x34
23 #define DW_SPI_TXOICR			0x38
24 #define DW_SPI_RXOICR			0x3c
25 #define DW_SPI_RXUICR			0x40
26 #define DW_SPI_MSTICR			0x44
27 #define DW_SPI_ICR			0x48
28 #define DW_SPI_DMACR			0x4c
29 #define DW_SPI_DMATDLR			0x50
30 #define DW_SPI_DMARDLR			0x54
31 #define DW_SPI_IDR			0x58
32 #define DW_SPI_VERSION			0x5c
33 #define DW_SPI_DR			0x60
34 
35 /* Bit fields in CTRLR0 */
36 #define SPI_DFS_OFFSET			0
37 
38 #define SPI_FRF_OFFSET			4
39 #define SPI_FRF_SPI			0x0
40 #define SPI_FRF_SSP			0x1
41 #define SPI_FRF_MICROWIRE		0x2
42 #define SPI_FRF_RESV			0x3
43 
44 #define SPI_MODE_OFFSET			6
45 #define SPI_SCPH_OFFSET			6
46 #define SPI_SCOL_OFFSET			7
47 
48 #define SPI_TMOD_OFFSET			8
49 #define SPI_TMOD_MASK			(0x3 << SPI_TMOD_OFFSET)
50 #define	SPI_TMOD_TR			0x0		/* xmit & recv */
51 #define SPI_TMOD_TO			0x1		/* xmit only */
52 #define SPI_TMOD_RO			0x2		/* recv only */
53 #define SPI_TMOD_EPROMREAD		0x3		/* eeprom read mode */
54 
55 #define SPI_SLVOE_OFFSET		10
56 #define SPI_SRL_OFFSET			11
57 #define SPI_CFS_OFFSET			12
58 
59 /* Bit fields in SR, 7 bits */
60 #define SR_MASK				0x7f		/* cover 7 bits */
61 #define SR_BUSY				(1 << 0)
62 #define SR_TF_NOT_FULL			(1 << 1)
63 #define SR_TF_EMPT			(1 << 2)
64 #define SR_RF_NOT_EMPT			(1 << 3)
65 #define SR_RF_FULL			(1 << 4)
66 #define SR_TX_ERR			(1 << 5)
67 #define SR_DCOL				(1 << 6)
68 
69 /* Bit fields in ISR, IMR, RISR, 7 bits */
70 #define SPI_INT_TXEI			(1 << 0)
71 #define SPI_INT_TXOI			(1 << 1)
72 #define SPI_INT_RXUI			(1 << 2)
73 #define SPI_INT_RXOI			(1 << 3)
74 #define SPI_INT_RXFI			(1 << 4)
75 #define SPI_INT_MSTI			(1 << 5)
76 
77 /* Bit fields in DMACR */
78 #define SPI_DMA_RDMAE			(1 << 0)
79 #define SPI_DMA_TDMAE			(1 << 1)
80 
81 /* TX RX interrupt level threshold, max can be 256 */
82 #define SPI_INT_THRESHOLD		32
83 
84 enum dw_ssi_type {
85 	SSI_MOTO_SPI = 0,
86 	SSI_TI_SSP,
87 	SSI_NS_MICROWIRE,
88 };
89 
90 struct dw_spi;
91 struct dw_spi_dma_ops {
92 	int (*dma_init)(struct dw_spi *dws);
93 	void (*dma_exit)(struct dw_spi *dws);
94 	int (*dma_setup)(struct dw_spi *dws, struct spi_transfer *xfer);
95 	bool (*can_dma)(struct spi_master *master, struct spi_device *spi,
96 			struct spi_transfer *xfer);
97 	int (*dma_transfer)(struct dw_spi *dws, struct spi_transfer *xfer);
98 	void (*dma_stop)(struct dw_spi *dws);
99 };
100 
101 struct dw_spi {
102 	struct spi_master	*master;
103 	enum dw_ssi_type	type;
104 	char			name[16];
105 
106 	void __iomem		*regs;
107 	unsigned long		paddr;
108 	int			irq;
109 	u32			fifo_len;	/* depth of the FIFO buffer */
110 	u32			max_freq;	/* max bus freq supported */
111 
112 	u32			reg_io_width;	/* DR I/O width in bytes */
113 	u16			bus_num;
114 	u16			num_cs;		/* supported slave numbers */
115 
116 	/* Current message transfer state info */
117 	size_t			len;
118 	void			*tx;
119 	void			*tx_end;
120 	void			*rx;
121 	void			*rx_end;
122 	int			dma_mapped;
123 	u8			n_bytes;	/* current is a 1/2 bytes op */
124 	u32			dma_width;
125 	irqreturn_t		(*transfer_handler)(struct dw_spi *dws);
126 
127 	/* DMA info */
128 	int			dma_inited;
129 	struct dma_chan		*txchan;
130 	struct dma_chan		*rxchan;
131 	unsigned long		dma_chan_busy;
132 	dma_addr_t		dma_addr; /* phy address of the Data register */
133 	struct dw_spi_dma_ops	*dma_ops;
134 	void			*dma_tx;
135 	void			*dma_rx;
136 
137 	/* Bus interface info */
138 	void			*priv;
139 #ifdef CONFIG_DEBUG_FS
140 	struct dentry *debugfs;
141 #endif
142 };
143 
144 static inline u32 dw_readl(struct dw_spi *dws, u32 offset)
145 {
146 	return __raw_readl(dws->regs + offset);
147 }
148 
149 static inline u16 dw_readw(struct dw_spi *dws, u32 offset)
150 {
151 	return __raw_readw(dws->regs + offset);
152 }
153 
154 static inline void dw_writel(struct dw_spi *dws, u32 offset, u32 val)
155 {
156 	__raw_writel(val, dws->regs + offset);
157 }
158 
159 static inline void dw_writew(struct dw_spi *dws, u32 offset, u16 val)
160 {
161 	__raw_writew(val, dws->regs + offset);
162 }
163 
164 static inline u32 dw_read_io_reg(struct dw_spi *dws, u32 offset)
165 {
166 	switch (dws->reg_io_width) {
167 	case 2:
168 		return dw_readw(dws, offset);
169 	case 4:
170 	default:
171 		return dw_readl(dws, offset);
172 	}
173 }
174 
175 static inline void dw_write_io_reg(struct dw_spi *dws, u32 offset, u32 val)
176 {
177 	switch (dws->reg_io_width) {
178 	case 2:
179 		dw_writew(dws, offset, val);
180 		break;
181 	case 4:
182 	default:
183 		dw_writel(dws, offset, val);
184 		break;
185 	}
186 }
187 
188 static inline void spi_enable_chip(struct dw_spi *dws, int enable)
189 {
190 	dw_writel(dws, DW_SPI_SSIENR, (enable ? 1 : 0));
191 }
192 
193 static inline void spi_set_clk(struct dw_spi *dws, u16 div)
194 {
195 	dw_writel(dws, DW_SPI_BAUDR, div);
196 }
197 
198 /* Disable IRQ bits */
199 static inline void spi_mask_intr(struct dw_spi *dws, u32 mask)
200 {
201 	u32 new_mask;
202 
203 	new_mask = dw_readl(dws, DW_SPI_IMR) & ~mask;
204 	dw_writel(dws, DW_SPI_IMR, new_mask);
205 }
206 
207 /* Enable IRQ bits */
208 static inline void spi_umask_intr(struct dw_spi *dws, u32 mask)
209 {
210 	u32 new_mask;
211 
212 	new_mask = dw_readl(dws, DW_SPI_IMR) | mask;
213 	dw_writel(dws, DW_SPI_IMR, new_mask);
214 }
215 
216 /*
217  * This does disable the SPI controller, interrupts, and re-enable the
218  * controller back. Transmit and receive FIFO buffers are cleared when the
219  * device is disabled.
220  */
221 static inline void spi_reset_chip(struct dw_spi *dws)
222 {
223 	spi_enable_chip(dws, 0);
224 	spi_mask_intr(dws, 0xff);
225 	spi_enable_chip(dws, 1);
226 }
227 
228 /*
229  * Each SPI slave device to work with dw_api controller should
230  * has such a structure claiming its working mode (poll or PIO/DMA),
231  * which can be save in the "controller_data" member of the
232  * struct spi_device.
233  */
234 struct dw_spi_chip {
235 	u8 poll_mode;	/* 1 for controller polling mode */
236 	u8 type;	/* SPI/SSP/MicroWire */
237 	void (*cs_control)(u32 command);
238 };
239 
240 extern int dw_spi_add_host(struct device *dev, struct dw_spi *dws);
241 extern void dw_spi_remove_host(struct dw_spi *dws);
242 extern int dw_spi_suspend_host(struct dw_spi *dws);
243 extern int dw_spi_resume_host(struct dw_spi *dws);
244 
245 /* platform related setup */
246 extern int dw_spi_mid_init(struct dw_spi *dws); /* Intel MID platforms */
247 #endif /* DW_SPI_HEADER_H */
248